journal article·2004-10

Standby-battery autonomy versus power quality

Ian F. Bitterlin

Journal of Power Sources· Volume 136· Issue 2
Publisher page

Abstract

Abstract Batteries are used in a wide variety of applications as an energy store to bridge gaps in the primary source of supplied power for a given period of time. In some cases this bridging time, the battery’s “autonomy”, is fixed by local legislation but it is also often set by historically common practices. However, even if common practice dictates a long autonomy time, we are entering a new era of “cost and benefit realism” underpinned by environmentally friendly policies and we should challenge these historical practices at every opportunity if it can lead to resource and cost savings. In some cases the application engineer has no choice in the design autonomy; either follow a piece of local legislation (e.g. 4 h autonomy for a “life safety” application), or actually work out what is needed! An example of the latter would be for a remote site, off-grid, using integrated wind/solar power (without emergency generator back-up) where you may have to design-in several days’ battery autonomy. This short paper proposes that a battery’s autonomy should be related to the time expected for the system to be without the primary power source, balanced by the capital costs and commercial risk of power failure. To discuss this we shall consider the factors in selecting the autonomy time and other related aspects for high voltage battery systems used in facility-wide uninterruptible power supply (UPS) systems.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Smart Grid Energy Management · Advanced Battery Technologies Research · Microgrid Control and Optimization

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (5)

Show source-provided references
1. Contingency Planning Research Inc., USA, 1997.10.1016/S1359-6128(97)82727-9 ↗
2. IEEE Std. 1100, 1992.
3. IEEE Std. 466, 1987.
4. Electricity Council, UK Annual Report, 1998.
5. Yorkshire Electricity plc, UK Annual Report, May 1997.