Dynamic behaviour of SOFC short stacks
Source abstract
Abstract
Electrical output behaviour obtained on solid oxide fuel cell stacks, based on planar anode supported cells (50 or 100 cm2 active area) and metallic interconnects, is reported. Stacks (1–12 cells) have been operated with cathode air and anode hydrogen flows between 750 and 800 ◦C operating temperature. At first polarisation, an activation phase (increase in power density) is typically observed, ascribed to the cathode but not clarified. Activation may extend over days or weeks. The materials are fairly resistant to thermal cycling. A 1-cell stack cycled five times in 4 days at heating/cooling rates of 100–300Kh−1, showed no accelerated degradation. In a 5-cell stack, open circuit voltage (OCV) of all cells remained constant after three full cycles (800–25 ◦C). Power output is little affected by air flow but markedly influenced by small fuel flow variation. Fuel utilisation reached 88% in one 5-cell stack test. Performance homogeneity between cells lay at ±4–8% for three different 5- or 6-cell stacks, but was poor for a 12-cell stack with respect to the border cells. Degradation of a 1-cell stack operated for 5500 h showed clear dependence on operating conditions (cell voltage, fuel conversion), believed to be related to anode reoxidation (Ni). A 6-cell stack (50 cm2 cells) delivering 100Wel at 790 ◦C (1kWel L−1 or 0.34Wcm−2) went through a fuel supply interruption and a thermal cycle, with one out of the six cells slightly underperforming after these events. This cell was eventually responsible (hot spot) for stack failure.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Advancements in Solid Oxide Fuel Cells · Electronic and Structural Properties of Oxides · Fuel Cells and Related Materials
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (22)
Show source-provided references
1. Recent results of stack development at Forschungszentrum Juelich
2. Long term tests of DK-SOFC cells
3. Improved microstructure of Ni-YSZ cermet SOFC with long term stability10.5796/kogyobutsurikagaku.64.549 ↗
4. La2Zr2O7 formation and oxygen reduction kinetics of the La0.85Sr0.15MnyO3/O2/YSZ system10.1016/S0167-2738(98)00195-7 ↗
5. Evaluation of ferritic steel interconnects for SOFC stacks
6. New cost-effective ceramic oxide phases used as protective coatings for Cr-based interconnects
7. Current collection and stacking of anode support cells with metal interconnects to compact repeating units
8. Stability and performance of tape cast anode supported electrolyte cells
9. CFD modeling tool for SOFC10.1016/j.jpowsour.2003.11.089 ↗
10. Performance of SOFC stacks operated with CH4 at reduced temperatures
11. Anode supported SOFC with screen-printed cathodes10.1016/S0955-2219(01)00130-3 ↗
12. Bard · 1980
13. A. Hammouche, Contribution à l’étude de LaSrMnO3 comme matériau d’électrode à oxygène à haute température, Ph.D. Thesis, National Polytechnic Institute of Grenoble, France, 1989, pp. 71, 76.
14. J. Van herle, Oxygen reduction reaction mechanisms on SOFC cathodes, Ph.D. Thesis no. 1187, Federal Institute of Technology, Lausanne, Switzerland, 1993, p. 256.
15. S. Widmer, Mécanismes de dépolarisation de la réduction de l’oxygène sur des interfaces structurées à haute température, Ph.D. Thesis no. 1732, Federal Institute of Technology, Lausanne, Switzerland, 1997, pp. 208–218.
16. F. Ravussin, Caractérisations locales dans une pile à combustible SOFC, Diploma Thesis, LENI, Federal Institute of Technology (EPFL), Lausanne, Switzerland, March 2004.
17. Development of lanthanum ferrite SOFC cathodes10.1016/S0378-7753(02)00455-X ↗
18. Improved sinterability and performance of lanthanum ferrite SOFC cathodes
19. Strong performance improvement of La0.6Sr0.4Co0.8Fe0.2O3 solid oxide fuel cell model cathodes by electrochemical activation10.1149/1.2034529 ↗
20. Generalized model of SOFC planar repeat element for design optimisation10.1016/j.jpowsour.2003.11.088 ↗
21. Thermal modeling of a small anode supported solid oxide fuel cell10.1016/S0378-7753(03)00102-2 ↗
22. Modeling of cross-flow stack: sensitivity to thermal properties of the materials