journal article·2025-12Open access

Balancing kinetics and stoichiometry in Li-ion full cells with co-doped NMC9½½

Ethan Williams, Yongxiu Chen, David Burnett, Peter R. Slater, Emma Kendrick

Abstract

Optimizing lithium-ion batteries (LIBs) for high-power and high-energy applications requires careful control of electrode composition, cell balancing, and electrochemical kinetics. This study explores full cells using pristine and doped LiNi 0.9 Mn 0.05 Co 0.05 O 2 (NMC9½½) cathodes, single-doped with boron (B25) and co-doped with boron and tin (SB25), paired with graphite anodes. Coin and pouch cells were evaluated to assess the impact of doping and negative-to-positive (N/P) ratio on rate performance, polarization, and long-term stability. SB25 showed superior rate capability, retaining 78.9 % of its initial capacity at 500 mA g −1 , compared to 69.5 % for undoped NMC9½½. Electrochemical impedance spectroscopy (EIS) and galvanostatic intermittent titration technique (GITT) analysis revealed SB25 had the lowest charge transfer resistance and highest lithium diffusion coefficients across all states of charge. At low SOC, graphite overpotentials were more severe at low N/P ratios, necessitating higher balancing for fast cycling. At high SOC, polarization in the cathode limited lithium extraction and reduced time in the high-voltage H2–H3 phase transition region. High-mass-loading (∼4.5 mA h cm −2 ) pouch cells confirmed that SB25 improved cycling stability under energy-dense conditions. These results highlight the importance of understanding impact of the material and electrode kinetics in cell balancing strategies for advancing Ni-rich LIBs in practical applications. • B, Sn co-doping improves NMC9½½ cathode kinetics and Li-ion transport. • SB25 cathodes delay the H2–H3 transition, improving cycling stability. • Optimised cell N/P ratios minimises overpotentials at low and high SOC. • Dopant design addresses trade-offs between rate capability and lifetime. • High-loading pouch cells (4.5 mA h cm −2 ) increase energy with stable reversibility.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Advanced Battery Technologies Research · Advancements in Battery Materials · Advanced Battery Materials and Technologies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (34)

Show source-provided references
1. Preparation of LFP-Based cathode materials for lithium-ion battery applications10.1016/j.matpr.2022.05.302 ↗
2. Toward higher-power Li-ion batteries: unravelling kinetics and thermodynamics of MoNb12O33 vs. NMC62210.1016/j.jpowsour.2023.233710 ↗
3. Lithium niobate for fast cycling in Li-ion batteries: review and new experimental results10.3390/batteries9050244 ↗
4. Design strategies for high power vs. high energy lithium ion cells10.3390/batteries5040064 ↗
5. A review on design parameters for the full-cell lithium-ion batteries10.3390/batteries10100340 ↗
6. Evaluating the capacity ratio and prelithiation strategies for extending cyclability in porous silicon composite anodes and lithium iron phosphate cathodes for high capacity lithium-ion batteries10.1016/j.est.2020.101268 ↗
7. Accurate voltage prediction for lithium and sodium-ion full-cell development10.1016/j.nxener.2024.100166 ↗
8. Revealing the rate-limiting electrode of lithium batteries at high rates and mass loadings10.1016/j.cej.2022.138275 ↗
9. Williams · 2025
10. Enhancing high-voltage structural stability of single-crystalline Ni-rich LiNi0.9Mn0.05Co0.05O2 cathode material by ultrathin Li-rich oxide layer for lithium-ion batteries10.1016/j.jpowsour.2024.234300 ↗
11. Potential and limitations of research battery cell types for electrochemical data acquisition10.1002/batt.202300080 ↗
12. The success story of graphite as a lithium-ion anode material – fundamentals, remaining challenges, and recent developments including silicon (oxide) composites
13. Effect of N/P ratios on the performance of LiNi0.8Co0.15Al0.05O2||SiOx/Graphite lithium-ion batteries10.1016/j.jpowsour.2019.227056 ↗
14. Intragranular cracking as a critical barrier for high-voltage usage of layer-structured cathode for lithium-ion batteries10.1038/ncomms14101 ↗
15. On the fragmentation of active material secondary particles in lithium ion battery cathodes induced by charge cycling10.1016/j.eml.2016.03.018 ↗
16. Understanding the crack formation of graphite particles in cycled commercial lithium-ion batteries by focused ion beam - scanning electron microscopy10.1016/j.jpowsour.2017.08.045 ↗
17. The transformation of graphite electrode materials in lithium-ion batteries after cycling10.1016/j.jpowsour.2015.08.055 ↗
18. A new approach to surface properties of solid electrolyte interphase on a graphite negative electrode10.1016/j.jpowsour.2013.08.105 ↗
19. Ag–Sn dual-modified LiNi0.8Co0.1Mn0.1O2 as cathode for lithium storage10.1016/j.jallcom.2020.156763 ↗
20. Chen · 2020
21. Investigation of mass loading of cathode materials for high energy lithium-ion batteries10.1016/j.elecom.2023.107437 ↗
22. A comprehensive understanding of electrode thickness effects on the electrochemical performances of Li-ion battery cathodes10.1016/j.electacta.2012.03.161 ↗
23. A comparison of lithium-ion cell performance across three different cell formats A Comparison of Lithium-Ion Cell Performance across three Different Cell formats10.3390/batteries7020038 ↗
24. Heenan · 2020
25. Drying of lithium-ion battery anodes for use in high-energy cells: influence of electrode thickness on drying time, adhesion, and crack Formation10.1002/ente.201900722 ↗
26. Concurrent operando neutron Imaging and diffraction analysis revealing spatial lithiation phase evolution in an ultra-thick graphite Electrode10.1002/aenm.202405238 ↗
27. Revealing the rate-limiting Li-Ion diffusion pathway in Ultrathick electrodes for Li-Ion batteries10.1021/acs.jpclett.8b02229 ↗
28. A guide to making highly reproducible Li-Ion single-layer pouch cells for academic researchers10.1149/1945-7111/aceffc ↗
29. Impedance spectroscopy characterization of porous electrodes under different electrode thickness using a symmetric cell for high-performance lithium-ion batteries10.1021/jp512564f ↗
30. Boron in Ni-Rich NCM811 cathode material: impact on atomic and microscale properties10.1021/acsaem.1c03000 ↗
31. Multi-scale boron penetration toward stabilizing nickel-rich cathode10.1016/j.fmre.2022.03.001 ↗
32. Investigation on the structure and electrochemical performance of LiNi0.8Co0.1Mn0.1O2 modified with Sn10.1016/j.electacta.2021.139468 ↗
33. Enhanced cycling stability of Sn-doped Li[Ni0.90Co0.05Mn0.05]O2 via optimization of particle shape and orientation10.1016/j.cej.2020.126887 ↗
34. Stabilizing Ni-rich high energy cathodes for advanced lithium-ion batteries: the case of LiNi0.9Co0.1O210.1039/D3TA00444A ↗