journal article·2020-02Open access

Scattered and linked microcracks in solid oxide fuel cell electrolyte

M. Lugovy, V. Slyunyayev, M. Brodnikovskyy, R. Steinberger-Wilckens

Abstract

Abstract Scattered and linked microcracks in the electrolyte layer have been analysed in detail in anode supported planar solid oxide fuel cells. The empirical model established allowed critical characteristics of scattered and localised microcracking to be determined using electrolyte microstructural parameters. The model was verified with experimental data obtained for electron beam deposited scandia-stabilised zirconia electrolytes. Suitable annealing and deposition temperatures during fuel cell fabrication could be predicted from the critical temperature difference below which microcracking does not occur.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Advancements in Solid Oxide Fuel Cells · Electronic and Structural Properties of Oxides · Chemical Looping and Thermochemical Processes

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (30)

Show source-provided references
1. Materials for solid oxide fuel cells10.1021/cm902640j ↗
2. Materials for lower temperature solid oxide fuel cells10.1023/A:1004881825710 ↗
3. Fabrication of thin electrolytes for second-generation solid oxide fuel cells10.1016/S0167-2738(00)00624-X ↗
4. Microcracking in electron beam deposited scandia-stabilised zirconia electrolyte10.1016/j.jpowsour.2009.05.024 ↗
5. Evolutions of residual stress and microstructure in ZrO2 thin films deposited at different temperature and rates10.1016/j.tsf.2003.08.051 ↗
6. Dimensional instability of doped lanthanum chromite10.1149/1.1837127 ↗
7. Chemically-induced stresses in gadolinium-doped ceria solid oxide fuel cell electrolytes10.1016/S0167-2738(96)00588-7 ↗
8. Three-dimensional thermo-fluid electrochemical modeling of planar SOFC stacks10.1016/S0378-7753(02)00487-1 ↗
9. Solid oxide fuel cells: technology status10.1111/j.1744-7402.2004.tb00149.x ↗
10. Solid oxide fuel cells: fundamental aspects and prospects10.1016/S0013-4686(00)00330-3 ↗
11. Simulation of microcracking in inhomogeneous structures in the ductile-brittle transition range
12. Local stochastic analysis of microcracking and non-elastic behavior of ceramics10.1016/S0167-8442(01)00062-3 ↗
13. Statistical evaluation of microcracking of inelastic ceramics10.1023/A:1020332421276 ↗
14. Limiting state of two-phase composites under uniaxial tension10.1007/BF00558592 ↗
15. Microstructural engineering of ceramic-matrix layered composites: effect of grain-size dispersion on single-phase ceramic strength10.1016/S0266-3538(98)00070-0 ↗
16. Statistical aspects of micro-inhomogeneous material cleavage
17. Statistical failure model of materials with micro-inhomogeneity10.1016/S0167-8442(96)00032-8 ↗
18. Crack arrest in Si3N4-based layered composites with residual stress10.1016/j.compscitech.2004.02.007 ↗
19. Apparent fracture toughness of Si3N4-based laminates with residual compressive or tensile stresses in surface layers10.1016/j.actamat.2004.09.022 ↗
20. Buresch · 1978 · 256
21. Microcracking in ceramics induced by thermal expansion or elastic anisotropy10.1111/j.1151-2916.1988.tb05022.x ↗
22. Microcrack toughening in alumina/zirconia10.1016/0001-6160(87)90269-0 ↗
23. Hutchinson · 1989 · 139
24. Mechanics of solids with large number of cracks
25. Fracture mechanisms in nanoscale layered hard thin films10.1016/S0040-6090(02)00944-6 ↗
26. A further insight into spherical indentation: ring crack formation in a brittle La0.8Sr0.2Ga0.8Mg0.2O3 perovskite10.1016/j.actamat.2011.03.066 ↗
27. Mechanical properties of brittle materials
28. Linear elastic stress analysis of 2D cracks10.1007/978-94-007-2595-9_2 ↗
29. Role of damage on the flow and fracture of particulate reinforced alloys and metal matrix composites10.1016/S1359-6454(97)00147-X ↗
30. Residual stress distribution in solid oxide fuel cells: anode-electrolyte and anode-electrolyte-cathode systems