Reinforcement induced microcracking during the conversion of polymer-derived ceramics

This study investigates the role of discontinuous reinforcement on the microcracking of a preceramic polymer matrix during polymer to ceramic conversion. The material system comprised a carbosilane-based, preceramic polymer reinforced with mullite particles. The preceramic resin slurry was formulated for photopolymerization on a digital light projection 3D printer. Micro X-ray computed tomography, using a synchrotron light source, monitored a printed composite part during pyrolysis. The conversion of the carbosilane matrix into Si(O)C generated microcracks in the matrix that radially extended from particles. The likelihood of microcrack formation positively correlated with particle size. The largest particles (>104 µm3 volume or >60 µm side length) always abutted microcracks, while the matrix surrounding smaller particles (<5 µm) was free of microcracks. Numerical calculations showed the particles resist the shrinking matrix during its conversion. This created tensile stresses within the matrix. The driving force for microcrack growth was also analyzed with regard to the influence of matrix material parameters, particle form-factor and crack length. These results reveal the need to consider the form factor of discontinuous reinforcements, with regard to the material properties of the polymer-derived ceramic, in order to reduce or eliminate defects in the final part.