journal article·2018-08

Interactions between a polymer electrolyte membrane fuel cell and boost converter utilizing a multiscale model

Liangfei Xu, Po Hong, Chuan Fang, Jianqiu Li, Minggao Ouyang, Werner Lehnert

Publisher page

Abstract

Abstract In a fuel cell vehicle, a direct current boost converter (DCC) is required to link a polymer electrolyte membrane fuel cell system (FCS) and lithium battery packages. The DCC is installed to regulate the output power of the FCS, and can be controlled in different ways, via current, voltage, or power modes. Interactions between a DCC and FCS have attracted growing interests in recent years, because they affect dynamic and stable performances of the entire system. This paper outlines a simulation study on interactions between high-frequency switching operations of a DCC and internal states of an FCS based on a multiscale model. Results are as follows. (1) High-frequency switching operations have a major influence on the cathode overpotential, voltage ohmic loss and water transport through the membrane, whereas the influence on the partial pressures of gas species inside the stack is slight. (2) The FCS is more stable in the case of membrane dehydration than in that of water flooding. DCC's control mode has a greater influence on the FCS when water flooding occurs than membrane dehydration. The power control mode is the most unstable of the three, whereas the current control mode is the most stable.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Fuel Cells and Related Materials · Electrocatalysts for Energy Conversion · Advanced Battery Technologies Research

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (70)

Show source-provided references
1. Larminie · 2003
2. A review of polymer electrolyte membrane fuel cells: technology, applications, and needs on fundamental research10.1016/j.apenergy.2010.09.030 ↗
3. Current status and trends of the research and development for fuel cell vehicles
4. Performance comparison of two fuel cell hybrid buses with different powertrain and energy management strategies10.1016/j.jpowsour.2006.09.033 ↗
5. Optimal vehicle control strategy of a fuel cell/battery hybrid city bus10.1016/j.ijhydene.2009.06.021 ↗
6. Adaptive supervisory control strategy of a fuel cell/battery-powered city bus10.1016/j.jpowsour.2009.04.074 ↗
7. Active fault tolerance control system of fuel cell hybrid city bus10.1016/j.ijhydene.2010.08.005 ↗
8. Real time optimal energy management strategy targeting at minimizing daily operation cost for a plug-in fuel cell city bus10.1016/j.ijhydene.2012.07.074 ↗
9. Application of Pontryagin's Minimal Principle to the energy management strategy of plugin fuel cell electric vehicles10.1016/j.ijhydene.2013.05.125 ↗
10. Multi-mode control strategy for fuel cell electric vehicles regarding fuel economy and durability10.1016/j.ijhydene.2013.11.133 ↗
11. Energy flow modeling and real-time control design basing on mean values for maximizing driving mileage of a fuel cell bus10.1016/j.ijhydene.2015.08.104 ↗
12. Optimal sizing of plug-in fuel cell electric vehicles using models of vehicle performance and system cost10.1016/j.apenergy.2012.10.010 ↗
13. Multi-objective component sizing based on optimal energy management strategy of fuel cell electric vehicles10.1016/j.apenergy.2015.02.017 ↗
14. Multi-objective energy management optimization and parameter sizing for proton exchange membrane hybrid fuel cell vehicles10.1016/j.enconman.2016.09.082 ↗
15. Development of a PEM fuel cell city bus with a hierarchical control system10.3390/en9060417 ↗
16. Comparison of daily operation strategies for a fuel cell/battery tram10.1016/j.ijhydene.2017.04.151 ↗
17. Modeling and experimental validation of hybrid proton exchange membrane fuel cell/battery system for power management control10.1016/j.ijhydene.2015.03.073 ↗
18. An air-breathing single cell small proton exchange membrane fuel cell system with AB5-type metal hydride and an ultra-low voltage input boost converter10.1016/j.jpowsour.2008.09.051 ↗
19. A passivity-based controller for coordination of converters in a fuel cell system10.1016/j.conengprac.2013.04.003 ↗
20. A review on fuel cell technologies and power electronic interface10.1016/j.rser.2009.04.004 ↗
21. A review and design of power electronics converters for fuel cell hybrid system applications10.1016/j.egypro.2012.03.030 ↗
22. Pt/C catalyst degradation in proton exchange membrane fuel cells due to high-frequency potential cycling induced by switching power converters10.1016/j.jpowsour.2011.08.030 ↗
23. Modeling of current mode controlled boost converter supplied by fuel cell suitable for controller design purposes10.1016/j.jpowsour.2011.09.079 ↗
24. Nonlinear control and observation of a boost converter associated with a fuel-cell source in presence of model uncertainty
25. Fuel cell system control under converter losses with experimental results
26. Robust DC/DC converter control for polymer electrolyte membrane fuel cell application10.1016/j.jpowsour.2014.03.048 ↗
27. Nonlinear stability analysis and a new design methodology for a PEM fuel cell fed DC–DC boost converter10.1016/j.ijhydene.2012.09.002 ↗
28. Control of PEM fuel cell distributed generation systems10.1109/TEC.2005.860404 ↗
29. A DSP-based interleaved boost DC–DC converter for fuel cell applications10.1016/j.ijhydene.2015.03.069 ↗
30. Nonlinear single-loop control of the parallel converters for a fuel cell power source used in DC grid applications10.1016/j.ijepes.2014.09.025 ↗
31. Investigation of the interactions between proton exchange membrane fuel cell and interleaved DC/DC boost converter in the case of power switch faults10.1016/j.ijhydene.2014.10.072 ↗
32. Fuel cell systems reliability and availability enhancement by developing a fast and efficient power switch open-circuit fault detection algorithm in interleaved DC/DC boost converter topologies10.1016/j.ijhydene.2016.01.169 ↗
33. Robust control of the PEM fuel cell air-feed system via sub-optimal second order sliding mode10.1016/j.apenergy.2012.12.012 ↗
34. Effect of nitrogen crossover on purging strategy in PEM fuel cell systems10.1016/j.apenergy.2013.06.057 ↗
35. Control-oriented modeling and analysis for automotive fuel cell systems10.1115/1.1648308 ↗
36. Control oriented modeling of fuel-cell based vehicle
37. Dynamic models and model validation for PEM fuel cells using electrical circuits10.1109/TEC.2004.842357 ↗
38. Two-phase transients of polymer electrolyte fuel cells10.1149/1.2734076 ↗
39. A suitable model plant for control of the set fuel cell DC/DC converter10.1016/j.renene.2007.04.013 ↗
40. Detection of membrane drying, fuel cell flooding, and anode catalyst poisoning on PEMFC stacks by electrochemical impedance spectroscopy10.1149/1.2179200 ↗
41. A parametric study on water transfer in a PEMFC (Chinese)
42. Analytical calculation and evaluation of water transport through a proton exchange membrane fuel cell based on a one-dimensional model10.1016/j.energy.2016.06.020 ↗
43. A review of water flooding issues in the proton exchange membrane fuel cell10.1016/j.jpowsour.2007.12.068 ↗
44. In-plane transport effects on hydrogen depletion and carbon corrosion induced by anode flooding in proton exchange membrane fuel cells10.1016/j.ijheatmasstransfer.2012.04.040 ↗
45. Relationships between water management contamination and lifetime degradation in PEFC
46. Parameter extraction and uncertainty analysis of a proton exchange membrane fuel cell system based on Monte Carlo simulation10.1016/j.ijhydene.2016.11.151 ↗
47. Parameter extraction of polymer electrolyte membrane fuel cell based on quasi-dynamic model and periphery signal10.1016/j.energy.2017.01.078 ↗
48. Modeling and analysis of internal water transfer behavior of PEM fuel cell of large surface area10.1016/j.ijhydene.2017.04.164 ↗
49. Robust control of internal states in a polymer electrolyte membrane fuel cell air-feed system by considering actuator properties10.1016/j.ijhydene.2017.03.191 ↗
50. Nonlinear observation of internal states of fuel cell cathode utilizing a high-order sliding-mode algorithm10.1016/j.jpowsour.2017.04.068 ↗
51. Sliding-mode-based temperature regulation of a proton exchange membrane fuel cell test bench10.1016/j.ijhydene.2017.03.070 ↗
52. Optimal warm-up control strategy of the PEMFC system on a city bus aimed at improving efficiency10.1016/j.ijhydene.2017.02.203 ↗
53. Faults diagnosis for PEM fuel cell system based on multi-sensor signals and principle component analysis method
54. Liquid water transport in gas diffusion layer of polymer electrolyte fuel cells10.1149/1.1646148 ↗
55. Nonlinear predictive control for durability enhancement and efficiency improvement in a fuel cell power system10.1016/j.jpowsour.2016.08.019 ↗
56. Barbir · 2013
57. Liquid water transport in gas diffusion layer of polymer electrolyte fuel cells10.1149/1.1646148 ↗
58. A review on water fault diagnosis of PEMFC associated with the pressure drop10.1016/j.apenergy.2016.04.064 ↗
59. Water management of proton exchange membrane fuel cell based on control of hydrogen pressure drop10.1016/j.jpowsour.2014.05.094 ↗
60. Estimation of flooding in PEMFC gas diffusion layer by differential pressure measurement10.1016/j.jpowsour.2007.10.019 ↗
61. Development and application of a generalised steady-state electrochemical model for a PEM fuel cell10.1016/S0378-7753(99)00484-X ↗
62. Electrode structure effects on the performance of open-cathode proton exchange membrane fuel cells: a multiscale modeling approach10.1016/j.ijhydene.2014.03.218 ↗
63. Water transport in polymer electrolyte membrane fuel cells10.1016/j.pecs.2010.06.002 ↗
64. Modeling and simulation of parallel DC/DC converter for online AC impedance estimation of PEM fuel cell stack10.1016/j.ijhydene.2015.11.129 ↗
65. Time delay control for fuel cells with bidirectional DC/DC converter and battery10.1016/j.ijhydene.2010.05.022 ↗
66. Model-based estimation of liquid saturation in cathode gas diffusion layer and current density difference under proton exchange membrane fuel cell flooding10.1016/j.ijhydene.2015.09.005 ↗
67. Model-based fuel pressure regulation algorithm for a hydrogen-injected PEM fuel cell engine10.1016/j.ijhydene.2015.08.043 ↗
68. Model-based temperature regulation of a PEM fuel cell system on a city bus10.1016/j.ijhydene.2015.08.042 ↗
69. Design of durability test protocol for vehicular fuel cell system operated in power follow mode based on statistic results of on-road data10.1016/j.jpowsour.2017.11.075 ↗
70. Methodology of designing durability test protocol for vehicular fuel cell system operated in soft run mode based on statistic results of on-road data10.1016/j.ijhydene.2017.10.060 ↗