Thermal neutron radiography of a passive proton exchange membrane fuel cell for portable hydrogen energy systems
Source abstract
Abstract
A proton exchange membrane fuel cell (PEMFC) for low power and portable applications is studied with thermal neutron radiography. The PEMFC operates under full passive conditions, with an air-breathing cathode and a dead-end anode supplied with static ambient air and dry hydrogen, respectively. A columnar cathodic plate favors the mobility of water drops over the cathode surface and their elimination. Thermal neutron images show liquid water build up during operation with the cell in vertical and horizontal positions, i.e. with its main plane aligned parallel and perpendicular to the gravity field, respectively. Polarization curves and impedance spectroscopy show cell orientation dependent response that can be related with the water accumulation profiles. In vertical position, lower water contents in the cathode electrode is favored by the elimination of water drops rolling over the cathode surface and the onset of natural convection. As a consequence, oxygen transport is improved in the vertical cell, that can be operated full passive for hours under ambient conditions, providing steady peak power densities above 100 mW/cm2. Gravity and natural convection are less effective in horizontal position, leading to a 17% decrease in peak power density due to oxygen transport losses. The horizontal position is especially adverse if the upper electrode is the cathode, because of anode flooding causing cell failure after production of a small amount of water (5 mg/cm2). The combined information from thermal neutron radiography and cell response characteristics explains the important influence of cell orientation on the performance of a fully passive air-breathing PEMFC for portable applications.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Fuel Cells and Related Materials · Nuclear Physics and Applications · Gas Sensing Nanomaterials and Sensors
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (57)
Show source-provided references
1. Fuel cells for low power applications10.1016/S0378-7753(01)00948-X ↗
2. Fuel cells for portable applications10.1016/S0378-7753(01)01069-2 ↗
3. Microfabricated fuel cells10.1016/S0013-4686(03)00351-7 ↗
4. Micro fuel cells: can we apply them to a successful market?10.1149/06403.0875ecst ↗
5. Development and user evaluation of an AlH3 wearable power system (WPS)10.1149/06501.0205ecst ↗
6. Advances in stationary and portable fuel cell applications10.1016/j.ijhydene.2016.02.057 ↗
7. 2018
8. Design considerations for miniaturized PEM fuel cells10.1016/S0378-7753(02)00066-6 ↗
9. Optimization of passive air-breathing fuel cell cathodes10.1115/1.3177381 ↗
10. Design and evaluation of a passive self-breathing micro fuel cell for autonomous portable applications10.1016/j.ijhydene.2012.09.117 ↗
11. High resolution neutron imaging for pulsed and constant load operation of passive self-breathing polymer electrolyte fuel cells10.1016/j.electacta.2012.09.091 ↗
12. Micro fuel cells based on silicon materials
13. A study on cathode structure and water transport in air-breathing PEM fuel cells10.1016/j.jpowsour.2005.12.046 ↗
14. Understanding cathode flooding and dry-out for water management in air-breathing PEM fuel cells10.1016/j.jpowsour.2008.02.012 ↗
15. Single cell study of water transport in PEMFCs with electrosprayed catalyst layers10.1002/fuce.201700217 ↗
16. Innovative water management in micro air-breathing polymer electrolyte membrane fuel cells10.1016/j.jpowsour.2009.08.068 ↗
17. Water management in a planar air-breathing fuel cell array using operando neutron imaging10.1016/j.jpowsour.2016.09.041 ↗
18. Measurement of liquid water accumulation in a PEMFC with dead-ended anode10.1149/1.2976356 ↗
19. Effects of heat and water transport on the performance of polymer electrolyte membrane fuel cell under high current density operation10.1016/j.electacta.2010.08.070 ↗
20. Analysis of liquid water formation in polymer electrolyte membrane (PEM) fuel cell flow-fields with a dry cathode supply10.1016/j.jpowsour.2015.12.060 ↗
21. Nitrogen blanketing and hydrogen starvation in dead-ended-anode polymer electrolyte fuel cells revealed by hydro-electro-thermal analysis10.1016/j.electacta.2016.04.018 ↗
22. Effect of cell compression on the water dynamics of a polymer electrolyte fuel cell using in-plane and through-plane in-operando neutron radiography10.1016/j.jpowsour.2019.227074 ↗
23. Bipolar plate research using Computational Fluid Dynamics and neutron radiography for proton exchange membrane fuel cells10.1016/j.ijhydene.2020.02.183 ↗
24. Selective visualization of water in fuel cell gas diffusion layers with neutron dark-field imaging10.1149/2.1011902jes ↗
25. High-resolution in-plane investigation of the water evolution and transport in PEM fuel cells10.1016/j.jpowsour.2008.12.023 ↗
26. Investigation of 3D water transport paths in gas diffusion layers by combined in-situ synchrotron X-ray radiography and tomography10.1016/j.elecom.2011.06.023 ↗
27. Microscale X-ray tomographic investigation of the interfacial morphology between the catalyst and micro porous layers in proton exchange membrane fuel cells10.1016/j.jpowsour.2016.04.031 ↗
28. Simultaneous characterization of oxygen transport resistance and spatially resolved liquid water saturation at high-current density of polymer electrolyte membrane fuel cells with varied cathode relative humidity10.1016/j.ijhydene.2017.10.031 ↗
29. Microstructural analysis and transport resistances of low-platinum-loaded PEFC electrodes10.1149/2.1111714jes ↗
30. Four-dimensional joint visualization of electrode degradation and liquid water distribution inside operating polymer electrolyte fuel cells10.1038/s41598-018-38464-9 ↗
31. Diagnostic tools in PEM fuel cell research: Part II. Physical/chemical methods10.1016/j.ijhydene.2008.01.020 ↗
32. Magnetic resonance imaging of water distribution and production in a 6 cm2 PEMFC under operation10.1016/j.ijhydene.2008.01.053 ↗
33. In situ diagnostics for water transport in proton exchange membrane fuel cells10.1016/j.pecs.2010.06.001 ↗
34. Novel dead-ended anode design for self-regulating humidification in an air-breathing H2-PEM fuel cell10.1149/06403.0945ecst ↗
35. Patent ES1232498
36. Neutron imaging at the low flux training and research reactor AKR-210.1016/j.nima.2019.06.033 ↗
37. Influence of the cathode catalyst layer thickness on the behaviour of an air-breathing PEM fuel cell10.12989/eri.2014.2.2.073 ↗
38. Effective diffusivity in partially-saturated carbon-fiber gas diffusion layers: effect of local saturation and application to macroscopic continuum models10.1016/j.jpowsour.2015.07.034 ↗
39. Anisotropic, effective diffusivity of porous gas diffusion layer materials for PEFC10.1016/j.electacta.2008.07.034 ↗
40. Oxygen transport resistance correlated to liquid water saturation in the gas diffusion layer of PEM fuel cells10.1016/j.ijheatmasstransfer.2013.12.059 ↗
41. Effective diffusivity of polymer electrolyte fuel cell gas diffusion layers: an overview and numerical study10.1016/j.ijhydene.2015.06.073 ↗
42. Investigation of the through-plane effective oxygen diffusivity in the porous media of PEM fuel cells: effects of the pore size distribution and water saturation distribution10.1016/j.ijheatmasstransfer.2016.03.060 ↗
43. In operando measurements of liquid water saturation distributions and effective diffusivities of polymer electrolyte membrane fuel cell gas diffusion layers10.1016/j.electacta.2016.05.180 ↗
44. The effects of catalyst layer microstructure and water saturation on the effective diffusivity in PEMFC10.1149/2.0711807jes ↗
45. Rosner · 2000
46. Characterization of polymer electrolyte fuel cells using AC impedance spectroscopy10.1149/1.1836485 ↗
47. Concerning the conversion of the constant phase element parameter Y0 into a capacitance10.5006/1.3280607 ↗
48. Determination of effective capacitance and film thickness from constant-phase-element parameters10.1016/j.electacta.2009.10.065 ↗
49. Effect of cathode flow-field configuration on air-breathing proton exchange membrane fuel cell10.1007/s12541-015-0146-6 ↗
50. Study of water accumulation dynamics in the channels of an open-cathode fuel cell through electro-thermal characterisation and droplet visualisation10.1016/j.ijhydene.2015.07.066 ↗
51. Influence of the cathode architecture in the frequency response of self-breathing proton exchange membrane fuel cells10.1016/j.jpowsour.2014.08.046 ↗
52. Influence of the gas diffusion cathode structure on the performance of an air-breathing proton exchange membrane fuel cell
53. Thermal modelling of the cathode in air-breathing PEM fuel cells10.1016/j.apenergy.2013.05.007 ↗
54. Numerical studies on an air-breathing proton exchange membrane (PEM)
55. Effect of cathode separator structure on performance characteristics of free-breathing PEMFCs10.1016/j.jpowsour.2006.06.093 ↗
56. The role of ambient conditions on the performance of a planar, air-breathing hydrogen PEM fuel cell10.1016/j.jpowsour.2006.03.054 ↗
57. Droplet and percolation network interactions in a fuel cell gas diffusion layer10.1149/1945-7111/ab8c85 ↗