journal article·2022-02

Hydrogen starvation mitigation strategies during the start-up of proton exchange membrane fuel cell stack

Xingying Bai, Qifei Jian, Bi Huang, Lizhong Luo, Yangyang Chen

Publisher page

Abstract

Abstract Hydrogen starvation during start-up loading and rapid load change is a severe threat to the life and durability of proton exchange membrane fuel cell. To mitigate and eliminate hydrogen starvation during start-up loading, a dual-path hydrogen supply strategy is proposed to improve hydrogen diffusion within the stack. Based on constant loading rate continuous loading, two optimized start-up strategies with variable loading rates are presented. Stack voltage, stack average temperature, and single-cell temperature uniformity under different start-up loading strategies are discussed in detail. Experimental results show that at the end of continuous loading with a loading rate of 0.67 A/s, the peak voltage uniformity rate of dual-path hydrogen supply mode is 12.67% lower than that of dead-ended anode mode. In start-up loading from open-circuit state (0 A) to nominal state (40 A), single-cell temperature uniformity index has a maximum reduction of 0.136 °C compared to dead-ended anode mode. Besides, the combination of dual-path hydrogen supply and gradual-decreasing loading rate eliminates voltage overshoot during start-up loading, and reduces the single-cell temperature uniformity index by a maximum of 15.8%. Results indicate that the proposed strategies can mitigate hydrogen starvation, and improve the stability of stack voltage and the temperature uniformity of single cells.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Fuel Cells and Related Materials · Electrocatalysts for Energy Conversion · Advanced battery technologies research

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (38)

Show source-provided references
1. A review of automotive proton exchange membrane fuel cell degradation under start-stop operating condition10.1016/j.apenergy.2018.04.049 ↗
2. Investigation of real-time changes and recovery of proton exchange membrane fuel cell in voltage reversal10.1016/j.enconman.2021.114037 ↗
3. A review of polymer electrolyte membrane fuel cell durability for vehicular applications: degradation modes and experimental techniques10.1016/j.enconman.2019.112022 ↗
4. Recent progress of carbon dots and carbon nanotubes applied in oxygen reduction reaction of fuel cell for transportation10.1016/j.apenergy.2019.114027 ↗
5. A review on polymer electrolyte membrane fuel cell catalyst degradation and starvation issues: causes, consequences and diagnostic for mitigation10.1016/j.jpowsour.2009.03.060 ↗
6. The reactant starvation of the proton exchange membrane fuel cells for vehicular applications: a review10.1016/j.enconman.2018.12.049 ↗
7. The experimental analysis of a dead-end H 2/O 2 PEM fuel cell stack with cascade type design10.1016/j.ijhydene.2017.03.094 ↗
8. Experimental and numerical studies of header design and inlet/outlet configurations on flow mal-distribution in parallel micro-channels10.1016/j.applthermaleng.2013.04.026 ↗
9. An investigation into the effect of manifold geometry on uniformity of temperature distribution in a PEMFC stack10.1016/j.energy.2017.12.124 ↗
10. Channel to rib width ratio influence with various flow field designs on performance of PEM fuel cell10.1016/j.enconman.2018.08.041 ↗
11. Theory and practice of flow field designs for fuel cell scaling-up: a critical review10.1016/j.apenergy.2015.01.032 ↗
12. Comparison of degradation behaviors for open-ended and closed proton exchange membrane fuel cells during startup and shutdown cycles10.1016/j.jpowsour.2011.01.075 ↗
13. Titanium cobalt nitride supported platinum catalyst with high activity and stability for oxygen reduction reaction10.1016/j.jpowsour.2015.03.001 ↗
14. Graphene and reduced graphene oxide based microporous layers for high-performance proton-exchange membrane fuel cells under varied humidity operation10.1016/j.jpowsour.2019.03.048 ↗
15. Semi-physical modeling and control of a centrifugal compressor for the air feeding of a PEM fuel cell10.1016/j.enconman.2017.11.030 ↗
16. passive fault tolerant control of PEMFC air feeding system10.1016/j.ijhydene.2016.06.210 ↗
17. Impact of gas diffusion layer spatial variation properties on water management and performance of PEM fuel cells10.1016/j.enconman.2020.113579 ↗
18. Optimization of purge cycle for dead-ended anode fuel cell operation10.1016/j.ijhydene.2013.02.022 ↗
19. A mathematical model to study the energy efficiency of a proton exchange membrane fuel cell with a dead-ended anode10.1016/j.apenergy.2016.11.128 ↗
20. Anode purge strategy optimization of the polymer electrode membrane fuel cell system under the dead-end anode operation10.1016/j.jpowsour.2016.04.023 ↗
21. Mechanisms of voltage spikes and mitigation strategies for proton exchange membrane fuel cells with dead-ended anode under pressure swing operation10.1016/j.ijhydene.2017.09.103 ↗
22. Experimental study on water management improvement of proton exchange membrane fuel cells with dead-ended anode by periodically supplying fuel from anode outlet10.1016/j.jpowsour.2019.226775 ↗
23. Mitigation strategies for hydrogen starvation under dynamic loading in proton exchange membrane fuel cells10.1016/j.enconman.2017.02.051 ↗
24. Development of a durable PEMFC start-up process by applying a dummy load II. Diagnostic study10.1149/1.3246003 ↗
25. Study on voltage clamping and self-humidification effects of pem fuel cell system with dual recirculation based on orthogonal test method10.1016/j.ijhydene.2018.06.172 ↗
26. Experimental study on dynamic voltage uniformity of a 2-kW air-cooled PEMFC10.1007/s00202-018-0733-5 ↗
27. Experimental study on the voltage uniformity for dynamic loading of a PEM fuel cell stack10.1016/j.ijhydene.2015.04.058 ↗
28. Optimization of hydrogen feeding procedure in PEM fuel cell systems for transportation10.1016/j.ijhydene.2014.08.070 ↗
29. Hydrogen purge and reactant feeding strategies in self-humidified PEM fuel cell systems10.1016/j.ijhydene.2016.06.196 ↗
30. Spiegel · 2011
31. Flow characteristics analysis for multi-path hydrogen supply within proton exchange membrane fuel cell stack10.1016/j.apenergy.2021.117468 ↗
32. An experimental study on anode water management in high temperature PEM fuel cell10.1016/j.ijhydene.2015.02.037 ↗
33. Donald · 2015
34. Experimental investigation on the voltage uniformity for a PEMFC stack with different dynamic loading strategies10.1016/j.ijhydene.2020.05.070 ↗
35. Transient response of a unit proton-exchange membrane fuel cell under various operating conditions10.1016/j.jpowsour.2008.06.073 ↗
36. Visualization study on enhancing water transport of proton exchange membrane fuel cells with a dead-ended anode by generating fluctuating flow at anode compartment10.1016/j.enconman.2020.112477 ↗
37. Experimental and theoretical study on improving the operating characteristics of an open-cathode PEMFC stack by generating periodic disturbances at anode10.1016/j.enconman.2019.06.034 ↗
38. Flow distribution in proton exchange membrane fuel cell stacks10.1016/j.jpowsour.2006.06.081 ↗