journal article·2019-10

Fault detection and assessment for solid oxide fuel cell system gas supply unit based on novel principal component analysis

Xiao-long Wu, Yuan-Wu Xu, Dong-qi Zhao, Ze-hua Li, Xiao-bo Zhong, Meng-ting Chen, Jianhua Jiang, Zhonghua Deng, Xiaowei Fu, Xi Li

Publisher page

Abstract

Abstract After long-term running of solid oxide fuel cell system, the performance degradation of solid oxide fuel cell stack is caused by the fault of gas supply equipment. The more serious problem is that the stack performance does not match external load requirement. In order to guarantee the normal discharge of the stack, the fault detection of the system balance of plant components is a prerequisite for maintaining stack normal state, and is an important guarantee for increasing its operating cycle and remain useful lifetime. This paper proposes a novel statistical method based on principal component analysis and exponentially weighted moving average control chart for solid oxide fuel cell system gas supply fault detection. The gas supply fault is derived from the reformer and heat exchangers of the real system. The fault detection is carried out with collected data of real system and novel detection method. The results show that the novel method has higher efficiency and better effect than the traditional method under the system gas supply fault. Multi-times experimental data of real system is used to verify the robustness of the novel methods on-site fault detection.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Fault Detection and Control Systems · Machine Fault Diagnosis Techniques · Risk and Safety Analysis

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (61)

Show source-provided references
1. A nonlinear sliding mode observer for the estimation of temperature distribution in a planar solid oxide fuel cell10.1016/j.ijhydene.2014.10.117 ↗
2. Control-oriented modeling analysis and optimization of planar solid oxide fuel cell system10.1016/j.ijhydene.2016.08.213 ↗
3. Fault tolerance control of sofc systems based on nonlinear model predictive control10.1016/j.ijhydene.2016.09.203 ↗
4. Carbon deposition diagnostics for reliability and state-of-health assessment of sofc10.1149/08504.0025ecst ↗
5. Computational analysis of ir-sofc: transient, thermal stress, carbon deposition and flow dependency10.1016/j.ijhydene.2016.04.016 ↗
6. An operando surface enhanced Raman spectroscopy (sers) study of carbon deposition on sofc anodes10.1039/C4CP05176A ↗
7. Fabrication and performance evaluation of planar solid oxide fuel cell with large active reaction area10.1016/j.ijhydene.2011.03.011 ↗
8. Degradation analysis and durability improvement for sofc 1-cell stack10.1016/j.apenergy.2016.04.094 ↗
9. Process flow model of solid oxide fuel cell system supplied with sewage biogas
10. 3d modeling of anode-supported planar sofc with internal reforming of methane10.1016/j.jpowsour.2007.07.003 ↗
11. Numerical study on carbon deposition of sofc with unsteady state variation of porosity10.1016/j.apenergy.2012.02.055 ↗
12. A review of ac impedance modeling and validation in sofc diagnosis10.1016/j.electacta.2007.05.071 ↗
13. Diagnosis methodology and technique for solid oxide fuel cells: a review10.1016/j.ijhydene.2013.02.024 ↗
14. Analysis of pem fuel cell experimental data using principal component analysis and multi linear regression10.1016/j.ijhydene.2010.02.076 ↗
15. Application of fault tree analysis to fuel cell diagnosis10.1002/fuce.201100072 ↗
16. Solid oxide fuel cell fault diagnosis and ageing estimation based on wavelet transform approach10.1016/j.ijhydene.2016.06.143 ↗
17. Impedance diagnosis of metal-supported sofcs with sdc as electrolyte10.1016/j.jpowsour.2009.02.004 ↗
18. Fault diagnosis and prognostic of solid oxide fuel cells10.1016/j.jpowsour.2016.04.080 ↗
19. Monitoring and fault-tolerant control of distributed power generation: application to solid oxide fuel cells
20. On the use of neural networks and statistical tools for nonlinear modeling and on-field diagnosis of solid oxide fuel cell stacks ?10.1016/j.egypro.2014.01.032 ↗
21. A review on fault diagnosis tools of the proton exchange membrane fuel cell
22. A non-intrusive signal-based method for a proton exchange membrane fuel cell fault diagnosis10.1002/fuce.201600070 ↗
23. Fault diagnosis in polymer electrolyte membrane fuel cells based on patterns of tolerance10.1049/iet-rpg.2016.0158 ↗
24. Kamal · 2014
25. Pem fuel cell fault detection and identification using differential method: simulation and experimental validation
26. Parameter optimization of thermal-model-oriented control law for pem fuel cell stack via novel genetic algorithm10.1016/j.enconman.2011.05.012 ↗
27. A review on water fault diagnosis of pemfc associated with the pressure drop10.1016/j.apenergy.2016.04.064 ↗
28. A review of fault tolerant control strategies applied to proton exchange membrane fuel cell systems10.1016/j.jpowsour.2017.05.058 ↗
29. Fault tree analysis of proton exchange membrane fuel cell system safety10.1016/j.ijhydene.2015.04.101 ↗
30. Fault detection and isolation for polymer electrolyte membrane fuel cell systems by analyzing cell voltage generated space10.1016/j.apenergy.2015.03.076 ↗
31. Reformer faults in sofc systems: experimental and modeling analysis, and simulated fault maps10.1016/j.ijhydene.2014.09.063 ↗
32. A classification approach for model-based fault diagnosis in power generation systems based on solid oxide fuel cells10.1109/TEC.2015.2492938 ↗
33. Fault diagnosis strategies for sofc-based power generation plants10.3390/s16081336 ↗
34. Intelligent simultaneous fault diagnosis for solid oxide fuel cell system based on deep learning10.1016/j.apenergy.2018.10.113 ↗
35. Reliability analysis and initial requirements for fc systems and stacks10.1016/j.jpowsour.2006.11.085 ↗
36. Model-based development of a fault signature matrix to improve solid oxide fuel cell systems on-site diagnosis10.1016/j.jpowsour.2015.01.037 ↗
37. Data-driven simultaneous fault diagnosis for solid oxide fuel cell system using multi-label pattern identification10.1016/j.jpowsour.2018.01.015 ↗
38. Monitoring of solid oxide fuel cell systems10.1002/apj.554 ↗
39. A model-based diagnostic technique to enhance faults isolability in solid oxide fuel cell systems10.1016/j.apenergy.2017.05.069 ↗
40. Fault diagnosis of solid oxide fuel cell based on a supervised self-organization map model10.1115/1.4029070 ↗
41. A survey of fault diagnosis and fault-tolerant techniquespart i: fault diagnosis with model-based and signal-based approaches10.1109/TIE.2015.2417501 ↗
42. A survey of fault diagnosis and fault-tolerant techniquespart ii: fault diagnosis with knowledge-based and hybrid/active approaches10.1109/TIE.2015.2417501 ↗
43. Forecast system for blasting vibration velocity peak based on matlab and bp neural network
44. Pca in studying coordination and variability: a tutorial10.1016/j.clinbiomech.2004.01.005 ↗
45. Multiscale pca with application to multivariate statistical process monitoring10.1002/aic.690440712 ↗
46. Learning visual spatial pooling by strong pca dimension reduction10.1162/NECO_a_00843 ↗
47. Statistically constrained economic design of the ewma control chart10.1080/00224065.1995.11979597 ↗
48. Robustness to non-normality of the multivariate ewma control chart10.1080/00224065.2002.11980157 ↗
49. A multivariate sign ewma control chart10.1198/TECH.2010.09095 ↗
50. Environomic design for electric vehicles with an integrated solid oxide fuel cell (sofc) unit as a range extender10.1016/j.renene.2017.05.031 ↗
51. Sofc ev range extender systems for biofuels
52. Bossel · 2003
53. Health state prediction and analysis of sofc system based on the data-driven entire stage experiment10.1016/j.apenergy.2019.04.053 ↗
54. Designing a multivariate ewma control chart10.1080/00224065.1997.11979720 ↗
55. Thermal management-oriented multivariable robust control of a kw-scale solid oxide fuel cell stand-alone system10.1109/TEC.2015.2510030 ↗
56. Control strategy for power management, efficiency-optimization and operating-safety of a 5-kw solid oxide fuel cell system10.1016/j.electacta.2015.02.045 ↗
57. Efficient fault detection using multivariate exponentially weighted moving average and independent component analysis10.1016/S1570-7946(03)80424-8 ↗
58. Fault modeling and simulation comparative study of two solid oxide fuel cell system
59. A hybrid prognostic model applied to sofc prognostics10.1016/j.ijhydene.2017.08.114 ↗
60. Joint particle filters prognostics for proton exchange membrane fuel cell power prediction at constant current solicitation10.1109/TR.2015.2454499 ↗
61. How to estimate and use mttf/mtbf would the real mtbf please stand up?