Optimal fault-tolerant control strategy of a solid oxide fuel cell system
Source abstract
Abstract
Abstract For solid oxide fuel cell (SOFC) development, load tracking, heat management, air excess ratio constraint, high efficiency, low cost and fault diagnosis are six key issues. However, no literature studies the control techniques combining optimization and fault diagnosis for the SOFC system. An optimal fault-tolerant control strategy is presented in this paper, which involves four parts: a fault diagnosis module, a switching module, two backup optimizers and a controller loop. The fault diagnosis part is presented to identify the SOFC current fault type, and the switching module is used to select the appropriate backup optimizer based on the diagnosis result. NSGA-II and TOPSIS are employed to design the two backup optimizers under normal and air compressor fault states. PID algorithm is proposed to design the control loop, which includes a power tracking controller, an anode inlet temperature controller, a cathode inlet temperature controller and an air excess ratio controller. The simulation results show the proposed optimal fault-tolerant control method can track the power, temperature and air excess ratio at the desired values, simultaneously achieving the maximum efficiency and the minimum unit cost in the case of SOFC normal and even in the air compressor fault.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Fuel Cells and Related Materials · Advancements in Solid Oxide Fuel Cells · Electrocatalysts for Energy Conversion
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (55)
Show source-provided references
1. Part load operation of SOFC/GT hybrid systems : stationary analysis10.1016/j.ijhydene.2012.08.015 ↗
2. Dynamic modeling and experimental validation for the electrical coupling in a 5-cell solid oxide fuel cell stack in the perspective of thermal coupling10.1016/j.ijhydene.2011.01.032 ↗
3. Control strategy for power management, efficiency -optimization and operating-safety of a 5-kW solid oxide fuel cell system10.1016/j.electacta.2015.02.045 ↗
4. Improving the performance of proton exchange membrane and solid oxide fuel cells under voltage flicker using Fuzzy-PI controller10.1016/j.ijhydene.2012.01.130 ↗
5. Development of models for analyzing the load-following performance of microturbines and fuel cells10.1016/S0378-7796(02)00033-0 ↗
6. An analysis of the control and operation of a solid oxide fuel-cell power plant in an isolated system10.1109/TEC.2005.847998 ↗
7. A novel adaptive neural network constrained control for solid oxide fuel cells via dynamic anti-windup10.1016/j.neucom.2016.05.076 ↗
8. Improved data driven model free adaptive constrained control for a solid oxide fuel cell10.1049/iet-cta.2015.0841 ↗
9. Data-driven predictive control for solid oxide fuel cells10.1016/j.jprocont.2006.09.004 ↗
10. Predictive control for sector bounded nonlinear model and its application to solid oxide fuel cell systems
11. Robust control of solid oxide fuel cell ultracapacitor hybrid system
12. Thermal stress management of a solid oxide fuel cell using neural network predictive control10.1016/j.energy.2013.08.031 ↗
13. Model-based development of low-level control strategies for transient operation of solid oxide fuel cell systems10.1016/j.jpowsour.2011.01.023 ↗
14. Thermal management of an independent steam reformer for a solid oxide fuel cell with constrained generalized predictive control10.1016/j.ijhydene.2012.05.119 ↗
15. A. Repository, Model predictive control of the solid oxide fuel cell stack temperature with models based on experimental data10.1016/j.jpowsour.2014.11.126 ↗
16. A nonlinear sliding mode observer for the estimation of temperature distribution in a planar solid oxide fuel cell10.1016/j.ijhydene.2014.10.117 ↗
17. Thomas · 2013 · 2489
18. Interval-based sliding mode control design for solid oxide fuel cells with state and actuator constraints10.1109/TIE.2015.2404811 ↗
19. Feedback control of solid oxide fuel cell spatial temperature variation10.1016/j.jpowsour.2009.12.111 ↗
20. Advanced control approach for hybrid systems based on solid oxide fuel cells10.1016/j.apenergy.2015.02.059 ↗
21. Thermal management-oriented multivariable robust control of a kW-scale solid oxide fuel cell stand-alone system10.1109/TEC.2015.2510030 ↗
22. An adaptive non-linear observer for the estimation of temperature distribution in the planar solid oxide fuel cell10.1016/j.jprocont.2012.11.007 ↗
23. A nonlinear sliding mode observer for the estimation of temperature distribution in a planar solid oxide fuel cell10.1016/j.ijhydene.2014.10.117 ↗
24. Anode-supported intermediate-temperature direct internal reforming solid oxide fuel cell: II. Model-based dynamic performance and control10.1016/j.jpowsour.2005.01.017 ↗
25. Numerical analysis on dynamic behavior of solid oxide fuel cell with power output control scheme10.1016/j.jpowsour.2012.09.048 ↗
26. Dynamic modeling, simulation, and MIMO predictive control of a tubular solid oxide fuel cell10.1016/j.jprocont.2012.01.015 ↗
27. Thermal management oriented steady state analysis and optimization of a kW scale solid oxide fuel cell stand-alone system for maximum system efficiency10.1016/j.ijhydene.2013.07.052 ↗
28. Modeling and model-based analysis of a solid oxide fuel cell thermal-electrical management system with an air bypass valve10.1016/j.electacta.2015.01.211 ↗
29. Optimization of single SOFC structural design for maximum power10.1016/j.applthermaleng.2012.05.020 ↗
30. Experimental real-time optimization of a solid oxide fuel cell stack via constraint adaptation10.1016/j.energy.2011.04.033 ↗
31. Thermal e economic e environmental analysis and multi-objective optimization of an internal-reforming solid oxide fuel cell e gas turbine hybrid system10.1016/j.ijhydene.2012.09.143 ↗
32. 4E analysis and multi objective optimization of a micro gas turbine and solid oxide fuel cell hybrid combined heat and power system10.1016/j.jpowsour.2013.08.065 ↗
33. Multi-objective optimization of an indirectly integrated solid oxide fuel cell-gas turbine cogeneration system10.1016/j.ijhydene.2016.09.023 ↗
34. Multi-objective optimization of a pressurized solid oxide fuel cell – gas turbine hybrid system integrated with seawater reverse osmosis10.1016/j.energy.2017.01.127 ↗
35. Exergetic, economic, and environmental evaluations and multi-objective optimization of an internal-reforming SOFC-gas turbine cycle coupled with a Rankine cycle10.1016/j.applthermaleng.2016.07.180 ↗
36. Two strategies for multi-objective optimisation of solid oxide fuel cell stacks10.1080/14786451.2013.777337 ↗
37. Design and operation optimization of an internal reforming solid oxide fuel cell integrated system based on multi objective approach10.1016/j.applthermaleng.2016.12.013 ↗
38. Optimum power performance of a new integrated SOFC-trigeneration system by multi-objective exergoeconomic optimization10.1016/j.ijepes.2015.06.017 ↗
39. Comparative assessment and optimization of fuel cells10.1016/j.ijhydene.2014.11.050 ↗
40. Application of rolling horizon optimization to an integrated solid-oxide fuel cell and compressed air energy storage plant for zero-emissions peaking power under uncertainty10.1016/j.compchemeng.2014.06.001 ↗
41. A methodology for thermo-economic modeling and optimization of solid oxide fuel cell systems10.1016/j.applthermaleng.2007.06.007 ↗
42. Thermo-Economic optimization of a solid oxide fuel cell, gas turbine hybrid system10.1115/1.2714564 ↗
43. Large size biogas-fed Solid Oxide Fuel Cell power plants with carbon dioxide management: technical and economic optimization10.1016/j.jpowsour.2015.06.091 ↗
44. Jiang · 2016 · 1197
45. Dynamic modeling and analysis of a 5-kW solid oxide fuel cell system from the perspectives of cooperative control of thermal safety and high efficiency10.1016/j.ijhydene.2014.10.149 ↗
46. Fault tolerance control of SOFC systems based on nonlinear model predictive control10.1016/j.ijhydene.2016.09.203 ↗
47. Sun · 2010 · 448
48. Robust fault detection and reconfigurable control of distributed energy generation systems
49. Control oriented modeling of solid oxide fuel cell auxiliary power unit for transportation applications10.1115/1.3081475 ↗
50. Model-based development of a fault signature matrix to improve solid oxide fuel cell systems on-site diagnosis10.1016/j.jpowsour.2015.01.037 ↗
51. Thermodynamic and exergoeconomic analysis of biogas fed solid oxide fuel cell power plants emphasizing on anode and cathode recycling: a comparative study10.1016/j.enconman.2015.07.085 ↗
52. A fast and elitist multi-objective genetic algorithm: NGSA-II10.1109/4235.996017 ↗
53. Deb · 2001
54. A method for group decision-making based on determining weights of decision makers using TOPSIS10.1016/j.apm.2010.11.001 ↗
55. Cooperative control of a nonuniform gantry crane with constrained tension10.1016/j.automatica.2015.12.026 ↗