Measurement of transient temperature distribution behavior of a planar solid oxide fuel cell: Effect of instantaneous switching of power generation and direct internal reforming
Source abstract
Abstract
Abstract The transient temperature distribution behavior of a planar, co-flow type anode supported solid oxide fuel cell is experimentally investigated under furnace temperatures of 670 °C, 720 °C, and 770 °C. An in-situ measurement is conducted by using a specially designed cell holder and a high-resolution infrared camera. The single and combined effects of electrochemical reactions and direct internal reforming (DIR) reactions are examined. The transient response of the cell temperature profile to a sudden change in the current density or reforming reaction rate is obtained. The results show the clear increase/decrease in the local temperature owing to the exothermic electrochemical reaction/endothermic reforming reaction. The analysis of the time constant shows that the response of the temperature distribution to a sudden change in the current density is faster than that to a change in the fuel gas composition. The time constant is smaller in the upstream region, indicating that the new steady state is first achieved near the flow inlet and gradually propagates downstream. The maximum temperature gradient along the operating cell is found to be lower under the DIR condition than under the non-DIR condition regardless of the furnace temperature.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Advancements in Solid Oxide Fuel Cells · Electrocatalysts for Energy Conversion · Fuel Cells and Related Materials
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (40)
Show source-provided references
1. Sustainable development Goals,” https://sustainabledevelopment.un.org/sdgs, accessed August 1, 2020.10.1007/978-3-030-02006-4_1043-1 ↗
2. The status of SOFC and SOEC R&D in the European fuel cell and hydrogen joint undertaking programme10.1149/09101.0009ecst ↗
3. Power generation efficiency of photovoltaics and a SOFC-PEFC combined micro-grid with time shift utilization of the SOFC exhaust heat10.1299/jpes.4.274 ↗
4. Intelligent control strategy for a grid connected PV/SOFC/BESS energy generation system10.1016/j.energy.2018.01.030 ↗
5. Distributed grid-connected SOFC supporting a multilevel dynamic voltage restorer10.1007/s12667-018-0272-1 ↗
6. Development and demonstration of a novel reversible SOFC system for utility and micro grid energy storage10.1002/fuce.201600185 ↗
7. Numerical simulation of intermediate-temperature direct-internal-reforming planar solid oxide fuel cell10.1016/j.energy.2010.03.058 ↗
8. The current density and temperature distributions of anode-supported flat-tube solid oxide fuel cells affected by various channel designs10.1016/j.ijhydene.2011.04.168 ↗
9. The effect of coupled mass transport and internal reforming on modeling of solid oxide fuel cells part I: channel-level model development and steady-state comparison10.1016/j.jpowsour.2015.11.043 ↗
10. Enhanced performance of counter flow SOFC with partial internal reformation10.1016/j.ijhydene.2014.09.148 ↗
11. Sanjay, “Computational analysis of IR-SOFC: thermodynamic, electrochemical process and flow configuration dependency10.1016/j.ijhydene.2015.10.098 ↗
12. A review of numerical modeling of solid oxide fuel cells10.1016/j.ijhydene.2006.11.028 ↗
13. 3D modeling of anode-supported planar SOFC with internal reforming of methane10.1016/j.jpowsour.2007.07.003 ↗
14. Modeling radiation heat transfer with participating media in solid oxide fuel cells,10.1115/1.2134738 ↗
15. Numerical analysis of thermal and electrochemical phenomena for anode supported micro tubular SOFC10.1002/aic.11697 ↗
16. 3-D model of thermos-fluid and electrochemical for planar SOFC10.1016/j.jpowsour.2007.02.019 ↗
17. Performance analysis of planar-type unit SOFC considering current and temperature distributions10.1016/S0167-2738(00)00645-7 ↗
18. Dynamic temperature modeling of an SOFC using least squares support vector machines10.1016/j.jpowsour.2008.01.022 ↗
19. CFD to predict temperature profile for scale up of micro-tubular SOFC stacks10.1016/j.jpowsour.2003.11.082 ↗
20. 3-D model calculation for planar SOFC10.1016/S0378-7753(01)00792-3 ↗
21. A novel approach to model the transient behavior of solid-oxide fuel cell stacks10.1016/j.jpowsour.2012.03.114 ↗
22. Thermo-electrochemical and thermal stress analysis for an anode-supported SOFC cell10.1016/j.renene.2008.02.023 ↗
23. Analysis of residual and operation thermal stresses in a planar SOFC10.1115/1.4025051 ↗
24. A transient analysis of a micro-tubular solid oxide fuel cell (SOFC)10.1016/j.jpowsour.2009.06.036 ↗
25. Detailed transient thermal simulation of a planar SOFC (solid oxide fuel cell) using gPROMSTM10.1016/j.energy.2014.11.049 ↗
26. Dynamic analysis of direct internal reforming in a SOFC stack with electrolyte-supported cells using a quasi-1D model10.1016/j.apenergy.2017.07.122 ↗
27. Steady state and transient thermal stress analysis in planar solid oxide fuel cells10.1016/j.jpowsour.2004.11.073 ↗
28. Sugihara · 2017
29. Measurement of the temperature distribution in a large solid oxide fuel cell short stack10.1016/j.ijhydene.2013.06.024 ↗
30. Study on paper-structured catalyst for direct internal reforming SOFC fueled by the mixture of CH4 and CO210.1016/j.ijhydene.2013.06.046 ↗
31. Investigation of temperature distribution and performance of SOFC short stack with/without machined gas channels10.1016/j.ijhydene.2016.02.045 ↗
32. Development of an in situ surface deformation and temperature measurement technique for a solid oxide fuel cell button cell10.1111/j.1744-7402.2009.02414.x ↗
33. Experimental investigation of temperature distribution over a planar solid oxide fuel cell10.1016/j.apenergy.2012.12.062 ↗
34. The effect of overpotentials on the transient response of the 300W SOFC cell stack voltage10.1016/j.apenergy.2013.11.017 ↗
35. In-situ studies of gas phase composition and anode surface temperature through a model DIR-SOFC steam-methane reformer at 973.15K10.1016/j.ijhydene.2013.08.042 ↗
36. Fuel flexibility in power generation by solid oxide fuel cells10.1016/S0167-2738(02)00351-X ↗
37. Direct operation of solid oxide fuel cells with methane fuel10.1016/j.ssi.2005.05.008 ↗
38. Formulation of steam-methane reforming rate in Ni-YSZ porous anode of solid oxide fuel cells10.1007/s00231-018-2299-1 ↗
39. Three-dimensional inverse heat conduction modeling of a multi-layered hollow cylindrical tube using input estimation algorithm and thermal resistance network10.1016/j.ijheatmasstransfer.2016.09.101 ↗
40. A combined electromagnetic and thermal analysis of induction motors10.1109/TMAG.2005.845044 ↗