Biaxial fatigue crack propagation behavior of perfluorosulfonic-acid membranes
Source abstract
Abstract
Abstract Perfluorosulfonic-acid membranes have long been used as the typical electrolyte for polymer-electrolyte fuel cells, which not only transport proton and water but also serve as barriers to prevent reactants mixing. However, too often the structural integrity of perfluorosulfonic-acid membranes is impaired by membrane thinning or cracks/pinholes formation induced by mechanical and chemical degradations. Despite the increasing number of studies that report crack formation, such as crack size and shape, the underlying mechanism and driving forces have not been well explored. In this paper, the fatigue crack propagation behaviors of Nafion membranes subjected to biaxial loading conditions have been investigated. In particular, the fatigue crack growth rates of flat cracks in responses to different loading conditions are compared, and the impact of transverse stress on fatigue crack growth rate is clarified. In addition, the crack paths for slant cracks under both uniaxial and biaxial loading conditions are discussed, which are similar in geometry to those found after accelerated stress testing of fuel cells. The directions of initial crack propagation are calculated theoretically and compared with experimental observations, which are in good agreement. The findings reported here lays the foundation for understanding of mechanical failure of membranes.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Fuel Cells and Related Materials · Advanced Battery Technologies Research · Mechanical stress and fatigue analysis
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (43)
Show source-provided references
1. New insights into perfluorinated sulfonic-acid ionomers10.1021/acs.chemrev.6b00159 ↗
2. State of understanding of nafion10.1021/cr0207123 ↗
3. Recent development of polymer electrolyte membranes for fuel cells10.1021/cr200035s ↗
4. Membrane durability: physical and chemical degradation
5. Morphological features (defects) in fuel cell membrane electrode assemblies10.1016/j.jpowsour.2005.12.027 ↗
6. Applying infrared thermography as a quality-control tool for the rapid detection of polymer-electrolyte-membrane-fuel-cell catalyst-layer-thickness variations10.1016/j.jpowsour.2012.02.030 ↗
7. Detecting and localizing failure points in proton exchange membrane fuel cells using IR thermography10.1016/j.jpowsour.2013.12.045 ↗
8. 3D failure analysis of pure mechanical and pure chemical degradation in fuel cell membranes10.1149/2.0451713jes ↗
9. Impact of heat and water management on proton exchange membrane fuel cells degradation in automotive application10.1016/j.jpowsour.2016.07.004 ↗
10. Perfluorosulfonic acid membrane degradation in the hydrogen inlet region: a macroscopic approach10.1016/j.ijhydene.2015.10.066 ↗
11. In-situ diagnostics and degradation mapping of a mixed-mode accelerated stress test for proton exchange membranes10.1016/j.jpowsour.2014.10.116 ↗
12. Microstructural and mechanical characterization of catalyst coated membranes subjected to in situ hygrothermal fatigue10.1149/2.0471514jes ↗
13. Degradation of a PEM fuel cell stack with Nafion® membranes of different thicknesses. Part II: ex situ diagnosis10.1016/j.jpowsour.2012.01.074 ↗
14. Membrane electrode assembly degradation under idle conditions via unsymmetrical reactant relative humidity cycling10.1016/j.jpowsour.2012.01.133 ↗
15. Understanding membrane failure in PEMFC: comparison of diagnostic tools at different observation scales10.1002/fuce.201100161 ↗
16. Characterizing fracture energy of proton exchange membranes using a knife slit test10.1002/polb.21894 ↗
17. 3D visualization of membrane failures in fuel cells10.1016/j.jpowsour.2017.01.129 ↗
18. Local degradation at membrane defects in polymer electrolyte fuel cells10.1149/1.023306jes ↗
19. Factors determining the gas crossover through pinholes in polymer electrolyte fuel cell membranes10.1016/j.electacta.2012.07.013 ↗
20. Investigation of membrane degradation in polymer electrolyte fuel cells using local gas permeation analysis10.1016/j.jpowsour.2012.03.071 ↗
21. Mechanical response of fuel cell membranes subjected to a hygro-thermal cycle10.1016/j.jpowsour.2006.05.020 ↗
22. On the use of pressure-loaded blister tests to characterize the strength and durability of proton exchange membranes10.1115/1.3007431 ↗
23. Fatigue and creep to leak tests of proton exchange membranes using pressure-loaded blisters10.1016/j.jpowsour.2009.06.083 ↗
24. Effect of cation contamination and hydrated pressure loading on the mechanical properties of proton exchange membranes10.1016/j.jpowsour.2010.12.066 ↗
25. In-plane biaxial cyclic mechanical behavior of proton exchange membranes10.1016/j.jpowsour.2017.06.040 ↗
26. Biaxial elastic–viscoplastic behavior of Nafion membranes10.1016/j.polymer.2010.11.032 ↗
27. Research on the long-term stability of a PEMFC stack: analysis of pinhole evolution10.1016/j.ijhydene.2014.03.072 ↗
28. Characteristics of hydrogen crossover through pinhole in polymer electrolyte membrane fuel cells10.1016/j.memsci.2016.09.009 ↗
29. Ex situ measurement and modelling of crack propagation in fuel cell membranes under mechanical fatigue loading10.1016/j.ijhydene.2017.06.151 ↗
30. Numerical evaluation of crack growth in polymer electrolyte fuel cell membranes based on plastically dissipated energy10.1016/j.jpowsour.2016.03.031 ↗
31. A mechanistic model for pinhole growth in fuel-cell membranes during cyclic loads10.1149/2.036408jes ↗
32. In-plane biaxial ratcheting behavior of PVDF UF membrane10.1016/j.polymertesting.2015.12.003 ↗
33. ASTM E647–11 · 2011
34. A practical methodology for elastic-plastic fatigue crack growth
35. Fully plastic J-integral solutions for surface cracked plates under biaxial loading10.1016/j.engfracmech.2005.12.014 ↗
36. Effects of the transverse stress on biaxial fatigue crack growth predicted by plasticity-corrected stress intensity factor10.1016/j.ijfatigue.2013.12.010 ↗
37. Numerical simulation of fatigue crack propagation under biaxial tensile loadings with phase differences10.1016/j.marstruc.2015.03.003 ↗
38. On the crack extension in plates under plane loading and transverse shear10.1115/1.3656897 ↗
39. Crack growth behavior under biaxial fatigue with phase difference10.1016/j.ijfatigue.2015.01.005 ↗
40. ΔK-dependency of fatigue growth of single and mixed mode cracks under biaxial stress
41. Decay in mechanical properties of catalyst coated membranes subjected to combined chemical and mechanical membrane degradation10.1002/fuce.201400040 ↗
42. Membrane degradation during combined chemical and mechanical accelerated stress testing of polymer electrolyte fuel cells10.1016/j.jpowsour.2014.01.106 ↗
43. Structure/property relationship of Nafion XL composite membranes10.1016/j.memsci.2016.06.004 ↗