journal article·2017-05Open access

In-situ X-ray tomographic study of the morphological changes of a Si/C paper anode for Li-ion batteries

V. Vanpeene, A. Etiemble, A. Bonnin, E. Maire, L. Roué

Abstract

The evolution of the three-dimensional (3D) morphology of a Si-based electrode upon cycling (1st discharge, 1st charge and 2nd discharge) is studied by in-situ synchrotron X-ray tomography. The Si-based electrode is constituted of silicon/carbon black/carboxymethylcellulose (Si/CB/CMC) embedded in a commercial carbon fiber paper, acting as a flexible 3D current collector. Its initial areal discharge capacity is 4.9 mAh cm −2. A reconstructed volume of 293 × 293 × 137 μm 3 is analyzed with a resolution of ∼0.3 μm. Three phases are identified: (i) the solid phase (C fibers + Si + CB + CMC), (ii) the electrolyte phase (pores filled with electrolyte) and (iii) the gas phase (electrolyte-free pores). Their respective volume fraction, size distribution and connectivity, and also the dimensional changes of the electrode along the three axes are quantified during cycling. At the beginning of the 1st discharge (lithiation), the formation of gas channels attributed to the reductive electrolyte decomposition is observed. During the 1st charge, large cracks are formed through the electrode, which reclose during the subsequent discharge. The electrode expansion/contraction due to the Si volume change is partially irreversible, occurs mainly in the transverse direction and is much larger in the bottom part of the electrode.
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Advancements in Battery Materials · Supercapacitor Materials and Fabrication · Advanced Battery Technologies Research

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (31)

Show source-provided references
1. Structural changes in silicon anodes during lithium insertion-extraction10.1149/1.1652421 ↗
2. An in situ x-ray diffraction study of the reaction of Li with crystalline Si10.1149/1.2409862 ↗
3. Reversible cycling of crystalline silicon powder10.1149/1.2402112 ↗
4. Nanostructured silicon for high capacity lithium battery anodes10.1039/C0EE00281J ↗
5. Silicon-based nanomaterials for lithium-ion batteries: a review10.1002/aenm.201300882 ↗
6. Bulk-nanoporous-silicon negative electrode with extremely high cyclability for lithium-ion batteries prepared using a top-down process10.1021/nl501500g ↗
7. Very high surface capacity observed with Si negative electrodes embedded in copper foam as 3D current collector10.1002/aenm.201301718 ↗
8. Carbon–fiber–silicon-nanocomposites for lithium-ion battery anodes by microwave plasma chemical vapor deposition10.1016/j.jpowsour.2008.07.035 ↗
9. Silicon nanoparticles supported on graphitic carbon paper as a hybrid anode for Li-ion batteries10.1016/j.nanoen.2013.09.004 ↗
10. Silicon nanoparticles–graphene paper composites for Li ion battery anodes10.1039/b919738a ↗
11. In-Operando x-ray tomography study of lithiation induced delamination of Si based anodes for lithium-ion batteries10.1149/2.0081407eel ↗
12. Three dimensional studies of particle failure in silicon based composite electrodes for lithium ion batteries10.1016/j.jpowsour.2014.07.001 ↗
13. Three-dimensional visualization of gas evolution and channel formation inside a lithium-ion battery10.1021/acsami.6b00708 ↗
14. Investigation of failure mechanisms in silicon based half cells during the first cycle by micro X-ray tomography and radiography10.1016/j.jpowsour.2016.04.126 ↗
15. 4D analysis of the microstructural evolution of Si-based electrodes during lithiation: time-lapse X-ray imaging and digital volume correlation10.1016/j.jpowsour.2016.04.076 ↗
16. Combining operando synchrotron X-ray tomographic microscopy and scanning X-ray diffraction to study lithium ion batteries10.1038/srep27994 ↗
17. The application of phase contrast X-ray techniques for imaging Li-ion battery electrodes10.1016/j.nimb.2013.08.066 ↗
18. A low-cost and high performance ball-milled Si-based negative electrode for high-energy Li-ion batteries10.1039/c3ee41318g ↗
19. Threshold-like dependence of silicon-based electrode performance on active mass loading and nature of carbon conductive additive10.1016/j.electacta.2016.08.118 ↗
20. Silicon composite electrode with high capacity and long cycle life10.1149/1.3212894 ↗
21. Impact of the slurry pH on the expansion/contraction behavior of silicon/carbon/carboxymethylcellulose electrodes for Li-ion batteries10.1149/2.1071606jes ↗
22. Image processing pipeline for synchrotron-radiation-based tomographic microscopy10.1107/S0909049510011830 ↗
23. Fast reconstruction algorithm dealing with tomography artifacts
24. Regridding reconstruction algorithm for real time tomographic imaging10.1107/S0909049512032864 ↗
25. Fiji: an open-source platform for biological-image analysis10.1038/nmeth.2019 ↗
26. Situ spectro–electrochemical insight revealing distinctive silicon anode solid electrolyte interphase formation in a lithium–ion battery10.1002/slct.201600119 ↗
27. Nano silicon for lithium-ion batteries10.1016/j.electacta.2006.06.034 ↗
28. Exceptional electrochemical performance of Si-nanowires in 1,3-dioxolane solutions: a surface chemical investigation10.1021/la300306v ↗
29. New insights into the silicon-based electrode's irreversibility along cycle life through simple gravimetric method10.1016/j.jpowsour.2012.08.007 ↗
30. Influence of the Si particle size on the mechanical stability of Si-based electrodes evaluated by in-operando dilatometry and acoustic emission10.1016/j.jpowsour.2016.09.017 ↗
31. In-situ acoustic emission study of Si-based electrodes for Li-ion batteries10.1016/j.jpowsour.2014.12.126 ↗