Understanding water management in platinum group metal-free electrodes using neutron imaging
Source abstract
Abstract
Platinum group metal-free (PGM-free) catalysts are a low-cost alternative to expensive PGM catalysts for polymer electrolyte fuel cells. However, due to the low volumetric activity of PGM-free catalysts, the catalyst layer thickness of the PGM-free catalyst electrode is an order of magnitude higher than PGM based electrodes. The thick PGM-free electrodes suffer from increased transport resistance and poor water management, which ultimately limits the fuel cell performance. This manuscript presents the study of water management in the PGM-free electrodes to understand the transport limitations and improve fuel cell performance. In-operando neutron imaging is performed to estimate the water content in different components across the fuel cell thickness. Water saturation in thick PGM electrodes, with similar catalyst layer thickness to PGM-free electrodes, is lower than in the PGM-free electrodes irrespective of the operating conditions, due to high water retention by PGM-free catalysts. Improvements in fuel cell performance are accomplished by enhancing water removal from the flooded PGM-free electrode in three ways: (i) enhanced water removal with a novel microporous layer with hydrophilic pathways incorporated through hydrophilic additives, (ii) water removal through anode via novel GDL in the anode, and (iii) lower water saturation in PGM-free electrode structures with increased catalyst porosity.
Source: europepmc · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Fuel Cells and Related Materials · Electrocatalysts for Energy Conversion · Electrochemical Analysis and Applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (52)
Show source-provided references
1. Identifying contributing degradation phenomena in PEM fuel cell membrane electrode assemblies via electron microscopy10.1149/1.2356192 ↗
2. Papageorgopoulos · 2019
3. Direct atomic-level insight into the active sites of a high-performance PGM-free ORR catalyst10.1126/science.aan2255 ↗
4. Recent advances in non-precious metal catalysis for oxygen-reduction reaction in polymer electrolyte fuelcells10.1039/C0EE00011F ↗
5. High-performance electrocatalysts for oxygen reduction derived from polyaniline, iron, and cobalt10.1126/science.1200832 ↗
6. Oxygen reduction activities compared in rotating-disk electrode and proton exchange membrane fuel cells for highly active FeNC catalysts10.1016/j.electacta.2012.09.057 ↗
7. Identification of catalytic sites for oxygen reduction in iron- and nitrogen-doped graphene materials10.1038/nmat4367 ↗
8. Modeling hierarchical non-precious metal catalyst cathodes for PEFCs using multi-scale X-ray CT imaging10.1149/06403.0281ecst ↗
9. Understanding the role of interfaces for water management in platinum group metal-free electrodes in polymer electrolyte fuel cells10.1021/acsaem.9b00292 ↗
10. Activity benchmarks and requirements for Pt, Pt-alloy, and non-Pt oxygen reduction catalysts for PEMFCs10.1016/j.apcatb.2004.06.021 ↗
11. Resolving electrode morphology's impact on platinum group metal-free cathode performance using nano-CT of 3D hierarchical pore and ionomer distribution10.1021/acsami.6b08844 ↗
12. Advanced PGM-free cathode engineering for high power density and durability
13. Effects of MEA fabrication and ionomer composition on fuel cell performance of PGM-free ORR catalyst
14. Critical advancements in achieving high power and stable nonprecious metal catalyst-based MEAs for real-world proton exchange membrane fuel cell applications10.1126/sciadv.aar7180 ↗
15. Modeling electrochemical performance of the hierarchical morphology of precious group metal-free cathode for polymer electrolyte fuel cell10.1149/2.0041712jes ↗
16. Durability challenges and perspective in the development of PGM-free electrocatalysts for the oxygen reduction reaction10.1016/j.coelec.2018.04.010 ↗
17. Is the rapid initial performance loss of Fe/N/C non precious metal catalysts due to micropore flooding?10.1039/C6EE03005J ↗
18. 3D printed flow field and fixture for visualization of water distribution in fuel cells by X-ray computed tomography10.1149/2.0461613jes ↗
19. In situ diagnostics for polymer electrolyte membrane fuel cells10.1016/j.coelec.2017.08.010 ↗
20. In situ and operando characterization of proton exchange membrane fuel cells10.1002/adma.201901900 ↗
21. Liquid water visualization in PEM fuel cells: a review10.1016/j.ijhydene.2009.02.084 ↗
22. Neutron imaging of fuel cells - recent trends and future prospects10.1016/j.coelec.2017.07.012 ↗
23. In situ neutron imaging technique for evaluation of water management systems in operating PEM fuel cells10.1016/j.jpowsour.2003.11.068 ↗
24. In situ diagnostic of two-phase flow phenomena in polymer electrolyte fuel cells by neutron imaging: Part A. Experimental, data treatment, and quantification10.1016/j.electacta.2004.11.005 ↗
25. Durability of polymer electrolyte membrane fuel cells operated at subfreezing temperatures10.1149/2.0191613jes ↗
26. Visualising liquid water in PEM fuel cells using neutron imaging10.1002/fuce.200800050 ↗
27. 3D neutron tomography of a polymer electrolyte membrane fuel cell under sub-zero conditions10.1016/j.ijhydene.2012.04.093 ↗
28. Cold-start of a PEFC visualized with high resolution dynamic in-plane neutron imaging10.1149/2.085202jes ↗
29. Measurement of water content in polymer electrolyte membranes using high resolution neutron imaging
30. Neutron imaging technique for in situ measurement of water transport gradients within Nafion in polymer electrolyte fuel cells10.1149/1.1391727 ↗
31. Impact of channel wall hydrophobicity on through-plane water distribution and flooding behavior in a polymer electrolyte fuel cell10.1016/j.electacta.2009.11.095 ↗
32. Anode-design strategies for improved performance of polymer-electrolyte fuel cells with ultra-thin electrodes10.1016/j.joule.2018.03.022 ↗
33. Imaging of water profiles in PEM fuel cells using neutron radiography: effect of operating conditions and GDL composition10.1149/1.2780955 ↗
34. Enhanced water management of polymer electrolyte fuel cells with additive-containing microporous layers10.1021/acsaem.8b01059 ↗
35. Effect of gas diffusion layer properties on water distribution across air-cooled, open-cathode polymer electrolyte fuel cells: a combined ex-situ X-ray tomography and in-operando neutron imaging study10.1016/j.electacta.2016.06.068 ↗
36. Measurement of liquid water accumulation in a PEMFC with dead-ended anode10.1149/1.2976356 ↗
37. Experimental approaches for distribution and behavior of water in PEMFC under flow direction and differential pressure using neutron imaging technique10.1016/j.nima.2008.11.083 ↗
38. In situ comparison of water content and dynamics in parallel, single-serpentine, and interdigitated flow fields of polymer electrolyte membrane fuel cells10.1016/j.jpowsour.2009.12.031 ↗
39. Effects of cathode corrosion on through-plane water transport in proton exchange membrane fuel cells10.1149/2.024309jes ↗
40. Influence of the microporous layer on carbon corrosion in the catalyst layer of a polymer electrolyte membrane fuel cell10.1016/j.jpowsour.2012.04.086 ↗
41. The hydro-electro-thermal performance of air-cooled, open-cathode polymer electrolyte fuel cells: combined localised current density, temperature and water mapping10.1016/j.electacta.2015.08.106 ↗
42. Nitrogen blanketing and hydrogen starvation in dead-ended-anode polymer electrolyte fuel cells revealed by hydro-electro-thermal analysis10.1016/j.electacta.2016.04.018 ↗
43. Developing a 3D neutron tomography method for proton exchange membrane fuel cells10.1016/j.jpowsour.2010.03.060 ↗
44. Neutron tomographic investigations of water distributions in polymer electrolyte membrane fuel cell stacks10.1016/j.jpowsour.2012.07.043 ↗
45. Direct atomic-level insight into the active sites of a high-performance PGM-free ORR catalyst10.1126/science.aan2255 ↗
46. Catalyst durability in PEM fuel cells with low platinum loading10.1149/2.jes113064 ↗
47. Accurate measurement of the through-plane water content of proton-exchange membranes using neutron radiography10.1063/1.4767118 ↗
48. Membrane/electrode assembly water content measured with 2 μm spatial resolution neutron imaging10.1149/08008.0385ecst ↗
49. Resolving electrode morphology's impact on platinum group metal-free cathode performance using nano-CT of 3D hierarchical pore and ionomer distribution10.1021/acsami.6b08844 ↗
50. Analysis of flooding as a stochastic process in polymer electrolyte membrane (PEM) fuel cells by impedance techniques10.1016/j.jpowsour.2008.06.014 ↗
51. Multiwall carbon nanotube-based microporous layers for polymer electrolyte membrane fuel cells10.1149/2.0861712jes ↗
52. Non-Precious metal fuel cell cathodes: catalyst development and electrode structure design