journal article·2021-04Open access

Pulse resistance based online temperature estimation for lithium-ion cells

S. Ludwig, I. Zilberman, M.F. Horsche, T. Wohlers, A. Jossen

Abstract

Knowing the temperature distribution within a battery pack is vital, because of the impact on capacity loss, power degradation and safety. Temperature measurements are usually realized with temperature sensors attached to a limited number of cells throughout the battery pack, leaving the majority of cells in larger battery systems unattended. This work presents a novel sensorless method for determining the temperature of a cell by exploiting the relation of the cell’s overpotential and temperature exemplary using a 18650 nickel-rich/silicon–graphite cell, although the method is basically applicable to any cell. Current changes in the battery load are utilized as pulse excitation for the calculation of a direct-current resistance RDC,Δt determined after a certain time Δt. Reference pulses at 10/20/30/40 °C are recorded to investigate the influence of state-of-charge and pulse rise/fall-time, as well as the pulse-current amplitude and direction on RDC,Δt. The analysis of the reference pulses shows that a Δt in the 10 ms to 100 ms regime has the greatest sensitivity to temperature and the least dependence on other parameters. The method is finally validated using a 6s1p-module with an externally constant temperature gradient applied to the serial connection, showing an average estimation error smaller than 1 K for each cell.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Advanced Battery Technologies Research · Advancements in Battery Materials · Advanced DC-DC Converters

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (70)

Show source-provided references
1. Temperature effect and thermal impact in lithium-ion batteries: A review10.1016/j.pnsc.2018.11.002 ↗
2. Temperature dependent ageing mechanisms in Lithium-ion batteries – A Post-Mortem study10.1016/j.jpowsour.2014.03.112 ↗
3. Analysis and modeling of calendar aging of a commercial LiFePO4/graphite cell10.1016/j.est.2018.01.019 ↗
4. Correlation between capacity and impedance of lithium-ion cells during calendar and cycle life10.1016/j.jpowsour.2015.11.096 ↗
5. Interaction of cyclic ageing at high-rate and low temperatures and safety in lithium-ion batteries10.1016/j.jpowsour.2014.08.135 ↗
6. Impact of cycling at low temperatures on the safety behavior of 18650-type lithium ion cells: Combined study of mechanical and thermal abuse testing accompanied by post-mortem analysis10.1016/j.jpowsour.2016.09.120 ↗
7. Research on the heat dissipation performance of battery pack based on forced air cooling10.1016/j.jpowsour.2013.03.004 ↗
8. Coupled thermal–electrochemical modelling of uneven heat generation in lithium-ion battery packs10.1016/j.jpowsour.2013.05.164 ↗
9. Thermal behavior study of discharging/charging cylindrical lithium-ion battery module cooled by channeled liquid flow10.1016/j.ijheatmasstransfer.2017.12.083 ↗
10. Optimization design and numerical study on water cooling structure for power lithium battery pack10.1016/j.applthermaleng.2019.113760 ↗
11. The effect of cell-to-cell variations and thermal gradients on the performance and degradation of lithium-ion battery packs10.1016/j.apenergy.2019.04.108 ↗
12. Online aging determination in lithium-ion battery module with forced temperature gradient10.1016/j.est.2019.101170 ↗
13. Instantaneous estimation of internal temperature in lithium–ion battery by impedance measurement
14. Optimization on uniformity of lithium-ion cylindrical battery module by different arrangement strategy10.1016/j.applthermaleng.2019.04.093 ↗
15. Algorithm for the detection of a single cell contact loss within parallel-connected cells based on continuous resistance ratio estimation10.1016/j.est.2019.101049 ↗
16. R. Koch, A. Jossen, Temperature measurement of large format pouch cells with impedance spectroscopy, in: EVS28 International Electric Vehicle Symposium and Exhibition, 2015.
17. Measurement of the internal cell temperature via impedance: Evaluation and application of a new method10.1016/j.jpowsour.2013.06.013 ↗
18. Sensorless battery temperature measurements based on electrochemical impedance spectroscopy10.1016/j.jpowsour.2013.09.005 ↗
19. Non-zero intercept frequency: An accurate method to determine the integral temperature of li-ion batteries10.1109/TIE.2016.2516961 ↗
20. Battery internal temperature estimation by combined impedance and surface temperature measurement10.1016/j.jpowsour.2014.04.129 ↗
21. Instantaneous measurement of the internal temperature in lithium-ion rechargeable cells10.1016/j.electacta.2011.03.136 ↗
22. Monitoring dynamic thermal behavior of the carbon anode in a lithium-ion cell using a four-probe technique10.1016/j.jpowsour.2011.09.077 ↗
23. Materials insights into low-temperature performances of lithium-ion batteries10.1016/j.jpowsour.2015.09.056 ↗
24. Lithium-ion battery temperature on-line estimation based on fast impedance calculation10.1016/j.est.2019.100952 ↗
25. Comparative analysis of lithium-ion battery resistance estimation techniques for battery management systems10.3390/en11061490 ↗
26. Lithium dendrite-free and fast-charging for high voltage nickel-rich lithium metal batteries enabled by bifunctional sulfone-containing electrolyte additives10.1016/j.jpowsour.2020.227833 ↗
27. Protective coatings on silicon particles and their effect on energy density and specific energy in lithium ion battery cells: A model study10.1016/j.est.2020.101376 ↗
28. Improving the cyclability of silicon anodes for lithium-ion batteries using a simple pre-lithiation method10.1016/j.jpowsour.2020.228066 ↗
29. Modeling and simulation of inhomogeneities in a 18650 nickel-rich, silicon-graphite lithium-ion cell during fast charging10.1016/j.jpowsour.2018.11.043 ↗
30. Reversible self-discharge and calendar aging of 18650 nickel-rich, silicon-graphite lithium-ion cells10.1016/j.jpowsour.2019.03.109 ↗
31. Cell-to-cell variation of calendar aging and reversible self-discharge in 18650 nickel-rich, silicon–graphite lithium-ion cells10.1016/j.est.2019.100900 ↗
32. Long-term equalization effects in Li-ion batteries due to local state of charge inhomogeneities and their impact on impedance measurements10.1016/j.electacta.2015.10.108 ↗
33. A study on the impact of lithium-ion cell relaxation on electrochemical impedance spectroscopy10.1016/j.jpowsour.2015.01.097 ↗
34. Impedance characteristics and diagnoses of automotive lithium-ion batteries at 7.5% to 93.0% state of charge10.1016/j.electacta.2016.09.154 ↗
35. A consistent derivation of the impedance of a lithium-ion battery electrode and its dependency on the state-of-charge10.1016/j.electacta.2017.05.009 ↗
36. Simulation and measurement of local potentials of modified commercial cylindrical cells10.1149/2.0561510jes ↗
37. Validation and benchmark methods for battery management system functionalities: State of charge estimation algorithms10.1016/j.est.2016.05.007 ↗
38. Lithium fluoroalkylphosphates: A new class of conducting salts for electrolytes for high energy lithium-ion batteries10.1016/S0378-7753(01)00640-1 ↗
39. Characterization of electronic and ionic transport in li1−xni 0.33mn0.33co0.33o2 (nmc333) and li1−xni0.50mn0.20co0.30o2 (nmc523) as a function of li content10.1149/2.0131608jes ↗
40. Separating electronic and ionic conductivity in mix-conducting layered lithium transition-metal oxides10.1016/j.jpowsour.2018.05.005 ↗
41. The low temperature performance of Li-ion batteries10.1016/S0378-7753(02)00618-3 ↗
42. Impedance based time-domain modeling of lithium-ion batteries: Part I10.1016/j.jpowsour.2018.01.043 ↗
43. Fundamentals of battery dynamics10.1016/j.jpowsour.2005.10.041 ↗
44. Review—Dynamic models of li-ion batteries for diagnosis and operation: A review and perspective10.1149/2.1061814jes ↗
45. A review of conduction phenomena in Li-ion batteries10.1016/j.jpowsour.2010.06.060 ↗
46. Analysis of the polarization in a li-ion battery cell by numerical simulations10.1149/1.3486161 ↗
47. Separation of charge transfer and contact resistance in lifepo 4 -cathodes by impedance modeling10.1149/2.030207jes ↗
48. The thermal and electrical conductivity of carbon and graphite to high temperatures
49. Thermal and electrical conductivity of graphite and carbon at low temperatures10.1063/1.1707454 ↗
50. The preparation and properties of amorphous silicon10.1149/1.2411779 ↗
51. Comparative study of LiBF4, LiAsF6, LiPF6, and LiClO4 as electrolytes in propylene carbonate–diethyl carbonate solutions for Li/LiMn2O4 cells10.1016/S0378-7753(03)00348-3 ↗
52. Experimental investigation of the lithium-ion battery impedance characteristic at various conditions and aging states and its influence on the application10.1016/j.apenergy.2012.09.030 ↗
53. Low-temperature performance of Li-ion batteries: The behavior of lithiated graphite10.1016/j.jpowsour.2015.02.008 ↗
54. The state of understanding of the lithium-ion-battery graphite solid electrolyte interphase (SEI) and its relationship to formation cycling10.1016/j.carbon.2016.04.008 ↗
55. A new kinetic equation for intercalation electrodes10.1149/1.2142287 ↗
56. The limits of low-temperature performance of li-ion cells10.1149/1.1393622 ↗
57. In operando detection of lithium diffusion behaviors at low temperature in 18650 Li-ion battery anode10.1016/j.physb.2018.02.032 ↗
58. Modeling of galvanostatic charge and discharge of the lithium/polymer/insertion cell10.1149/1.2221597 ↗
59. Simulation and optimization of the dual lithium ion insertion cell10.1149/1.2054684 ↗
60. A study of the influence of measurement timescale on internal resistance characterisation methodologies for lithium-ion cells10.1038/s41598-017-18424-5 ↗
61. Thermodynamic derivation of a Butler–Volmer model for intercalation in Li-ion batteries10.1016/j.electacta.2013.06.043 ↗
62. Toward reliable values of electrochemical stability limits for electrolytes10.1149/1.1392609 ↗
63. Relaxation phenomena in lithium-ion-insertion cells10.1149/1.2054868 ↗
64. Enhanced coulomb counting method for estimating state-of-charge and state-of-health of lithium-ion batteries10.1016/j.apenergy.2008.11.021 ↗
65. Enhancement of the Coulomb counter estimator by the on-board vehicle determination of battery initial state of charge10.3182/20120902-4-FR-2032.00109 ↗
66. Accuracy improvement of SOC estimation in lithium-ion batteries10.1016/j.est.2016.03.003 ↗
67. Combined state of charge and state of health estimation over lithium-ion battery cell cycle lifespan for electric vehicles10.1016/j.jpowsour.2014.09.146 ↗
68. Impedance change and capacity fade of lithium nickel manganese cobalt oxide-based batteries during calendar aging10.1016/j.jpowsour.2017.03.090 ↗
69. A review of lithium-ion battery state of charge estimation and management system in electric vehicle applications: Challenges and recommendations10.1016/j.rser.2017.05.001 ↗
70. A review of stochastic battery models and health management10.1016/j.rser.2017.05.127 ↗