journal article·2021-03Open access

Investigation of the transient freeze start behavior of polymer electrolyte fuel cells

Mayank Sabharwal, Felix N. Büchi, Shinya Nagashima, Federica Marone, Jens Eller

Abstract

Understanding the water management in polymer electrolyte fuel cells during sub-zero operation is crucial for designing effective freeze start strategies. This study uses sub-second operando X-ray tomographic microscopy to study the effect of warm-up rate and pre-drying on the water dynamics during non-isothermal freeze starts from −30 °C. A faster warm-up rate and cell pre-drying before freezing improved the cell performance during the freeze start. Imaging showed that during the freeze starts no new water clusters were formed in the cathode gas diffusion layer. Temporary catalyst layer detachment from the micro-porous layer was also observed between −20 to 18 °C due to the hygro-mechanical stresses during the sub-zero operation. Isothermal freeze starts were also performed to study the effect of membrane conductivity and local water flux in the catalyst layer during the sub-zero operation. Higher temperatures and lower operating current densities resulted in an increase in the operation time. Imaging results showed water clusters in the cathode gas diffusion layer for the isothermal freeze starts from −15 to 0 °C after 6 C/cm2 charge was produced.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Fuel Cells and Related Materials · Electrocatalysts for Energy Conversion · Membrane-based Ion Separation Techniques

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (43)

Show source-provided references
1. Development of system control for rapid warm-up operation of fuel cell10.4271/2012-01-1230 ↗
2. Maruo · 2017
3. Patterson · 2008
4. Characteristics of the PEMFC repetitively brought to temperatures below 0 C10.1149/1.1621877 ↗
5. Effects of water removal on the performance degradation of PEMFCs repetitively brought to <0 C10.1149/1.1683580 ↗
6. Analysis of PEMFC freeze degradation at −20 °C after gas purging10.1016/j.jpowsour.2006.07.010 ↗
7. Statistic analysis of operational influences on the cold start behaviour of PEM fuel cells10.1016/j.jpowsour.2005.02.058 ↗
8. Experimental investigation of parameters influencing the freeze start ability of a fuel cell system10.1016/j.jpowsour.2008.11.130 ↗
9. Isothermal cold start of polymer electrolyte fuel cells10.1149/1.2402124 ↗
10. Cold start characteristics and freezing mechanism dependence on start-up temperature in a polymer electrolyte membrane fuel cell10.1016/j.jpowsour.2012.02.052 ↗
11. Ice formation in PEM fuel cells operated isothermally at sub-freezing temperatures10.1149/1.3210585 ↗
12. Cold-start of a PEFC visualized with high resolution dynamic in-plane neutron imaging10.1149/2.085202jes ↗
13. Statistical analysis of isothermal cold starts of PEFCs: Impact of gas diffusion layer properties10.1149/2.1071610jes ↗
14. Characteristic behavior of polymer electrolyte fuel cell resistance during cold start10.1149/1.2975189 ↗
15. An investigation of PEFC sub-zero startup: Evidence of local freezing effects10.1149/2.0771614jes ↗
16. Performance and durability of PEM fuel cells operated at sub-freezing temperatures10.1149/1.2982034 ↗
17. Effect of sub-freezing temperatures on a PEM fuel cell performance, startup and fuel cell components10.1016/j.jpowsour.2006.02.075 ↗
18. Consistency analysis of polymer electrolyte membrane fuel cell stack during cold start10.1016/j.apenergy.2019.03.091 ↗
19. PEM fuel cell operation at −20 °C.: I. Electrode and membrane water (charge) storage10.1149/1.2905857 ↗
20. PEM fuel cell operation at −20 °C. II. Ice formation dynamics, current distribution, and voltage losses within electrodes10.1149/1.2943203 ↗
21. Physical degradation of membrane electrode assemblies undergoing freeze/thaw cycling: Micro-structure effects10.1016/j.jpowsour.2007.08.111 ↗
22. Physical degradation of membrane electrode assemblies undergoing freeze/thaw cycling: Diffusion media effects10.1016/j.jpowsour.2007.12.114 ↗
23. Low temperature durability and consistency analysis of proton exchange membrane fuel cell stack based on comprehensive characterizations10.1016/j.apenergy.2020.114626 ↗
24. In situ and operando characterization of proton exchange membrane fuel cells10.1002/adma.201901900 ↗
25. 3D neutron tomography of a polymer electrolyte membrane fuel cell under sub-zero conditions10.1016/j.ijhydene.2012.04.093 ↗
26. Behavior of water below the freezing point in PEFCs10.1016/j.jpowsour.2006.08.026 ↗
27. Super-cooled water behavior inside polymer electrolyte fuel cell cross-section below freezing temperature10.1016/j.jpowsour.2008.01.031 ↗
28. Fast X-ray tomographic microscopy: Investigating mechanisms of performance drop during freeze starts of polymer electrolyte fuel cells10.1002/celc.201500132 ↗
29. Operando properties of gas diffusion layers: Saturation and liquid permeability10.1149/2.0881702jes ↗
30. Trends in synchrotron-based tomographic imaging: The SLS experience
31. Exploring sub-second and sub-micron X-ray tomographic imaging of liquid water in PEFC gas diffusion layers10.1149/09208.0011ecst ↗
32. GigaFRoST: The gigabit fast readout system for tomography10.1107/S1600577517013522 ↗
33. High-numerical-aperture macroscope optics for time-resolved experiments10.1107/S1600577519004119 ↗
34. Towards on-the-fly data post-processing for real-time tomographic imaging at TOMCAT10.1186/s40679-016-0035-9 ↗
35. K. Marstal, F. Berendsen, M. Staring, S. Klein, SimpleElastix: A user-friendly, multi-lingual library for medical image registration, in: Proceedings of the IEEE Conference on Computer Vision and Pattern Recognition Workshops, 2016, pp. 134–142.10.1109/CVPRW.2016.78 ↗
36. Effect of sub-freezing temperatures on a PEM fuel cell performance, startup and fuel cell components10.1016/j.jpowsour.2006.02.075 ↗
37. The state of water in Nafion 117 of various cation forms10.5796/kogyobutsurikagaku.64.718 ↗
38. On the water transport behavior and phase transition mechanisms in cold start operation of PEM fuel cell10.1016/j.apenergy.2018.10.068 ↗
39. Ice formation and distribution in the catalyst layer during freeze-start process–CRYO-SEM investigation10.1016/j.electacta.2008.02.077 ↗
40. Thompson · 2007
41. Cold start of proton exchange membrane fuel cell10.1016/j.pecs.2017.10.003 ↗
42. When size matters: Active area dependence of PEFC cold start capability10.1149/2.0871510jes ↗
43. Isothermal ice crystallization kinetics in the gas-diffusion layer of a proton-exchange-membrane fuel cell10.1021/la2033737 ↗