journal article·2016-09Open access

Investigation of the chemo-mechanical coupling in lithiation/delithiation of amorphous Si through simulations of Si thin films and Si nanospheres

Miao Wang, Xinran Xiao

Abstract

Abstract A strong asymmetric rate behavior between lithiation and delithiation has been observed in amorphous Si (a-Si) anode in the form of thin films, but not in other geometries, such as Si nanospheres. This work investigated the rate behavior of the two geometries through numerical simulations. The results reveal that the rate behavior is affected by the geometry and the constraint of the electrode, the chemo-mechanical coupling, and the prior process. A substrate-constrained film has a relatively low surface/volume ratio and a constant surface area. Its lithiation has a great tendency to be hindered by surface limitation. The chemo-mechanical coupling also plays an important role. The stress profiles differ in the two geometries but both affect the lithiation process more than the delithiation process. The overall delithiation capacity is affected very little by the chemo-mechanical coupling. In cyclic loading, the delithiation capacity is reduced at the same rate as the lithiation capacity because of the low initial state of charge in the electrode. The asymmetric rate behavior was absent under cyclic loading. On the other hand, a slow charging process resulted in a better retained delithiation capacity and an asymmetric rate behavior at higher rates.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Advancements in Battery Materials · Semiconductor materials and devices · Semiconductor materials and interfaces

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (59)

Show source-provided references
1. 2007
2. In situ measurements of stress evolution in silicon thin films during electrochemical lithiation and delithiation10.1016/j.jpowsour.2010.02.013 ↗
3. Reactive Flow in silicon electrodes assisted by the insertion of lithium10.1021/nl302261w ↗
4. Variation of stress with charging rate due to strain-rate sensitivity of silicon electrodes of Li-ion batteries10.1016/j.jpowsour.2014.07.153 ↗
5. Measurement and modeling of the mechanical and electrochemical response of amorphous Si thin film electrodes during cyclic lithiation10.1016/j.jmps.2013.10.005 ↗
6. Studying the kinetics of crystalline silicon nanoparticle lithiation with in situ transmission electron microscopy10.1002/adma.201202744 ↗
7. Dynamics of electrochemical lithiation/delithiation of graphene-encapsulated silicon nanoparticles studied by in-situ TEM10.1038/srep04322 ↗
8. A model for electromigration-induced degradation mechanisms in dual-inlaid copper interconnects: effect of microstructure10.1063/1.2775538 ↗
9. Mechanical reliability of alloy-based electrode materials for rechargeable Li-ion batteries10.1007/s12206-013-0401-7 ↗
10. A surface locking instability for atomic intercalation into a solid electrode,10.1063/1.3330940 ↗
11. Kim · 2011
12. Charging efficiency improvement by structuring lithium battery electrodes10.1063/1.4723553 ↗
13. Concurrent reaction and plasticity during initial lithiation of crystalline silicon in lithium-ion batteries10.1149/2.020203jes ↗
14. A finite strain model of stress, diffusion, plastic flow, and electrochemical reactions in a lithium-ion half-cell10.1016/j.jmps.2011.01.003 ↗
15. A finite deformation stress-dependent chemical potential and its applications to lithium ion batteries10.1016/j.jmps.2012.03.008 ↗
16. Anisotropic compositional expansion in elastoplastic materials and corresponding chemical potential: large-strain formulation and application to amorphous lithiated silicon10.1016/j.jmps.2014.04.012 ↗
17. Combining mechanical and chemical effects in the deformation and failure of a cylindrical electrode particle in a Li-ion battery10.1016/j.ijsolstr.2014.11.006 ↗
18. Interaction between diffusion and chemical stresses10.1016/j.msea.2005.05.117 ↗
19. Continuum and atomistic models of strongly coupled diffusion, stress, and solute concentration10.1016/j.jpowsour.2010.06.080 ↗
20. A finite element simulation on transient large deformation and mass diffusion in electrodes for lithium ion batteries10.1088/0965-0393/21/7/074007 ↗
21. Interactions between non-stoichiometric stresses and defect transport in a tubular electrolyte10.1002/fuce.200700027 ↗
22. Situ Measurements of stress-potential coupling in lithiated silicon10.1149/1.3489378 ↗
23. Stress and strain in silicon electrode models10.1149/2.0091507jes ↗
24. Asymmetric rate behavior of Si anodes for lithium-ion batteries: ultrafast de-lithiation versus sluggish lithiation at high current densities10.1002/aenm.201401627 ↗
25. A yolk-shell design for stabilized and scalable Li-ion battery alloy anodes10.1021/nl3014814 ↗
26. Study of lithium diffusivity in amorphous silicon via finite element analysis10.1016/j.jpowsour.2015.12.082 ↗
27. Barsoum · 2002
28. Shewmon · 1991
29. The influence of surface mechanics on diffusion induced stresses within spherical nanoparticles10.1063/1.3000442 ↗
30. Large plastic deformation in high-capacity Lithium-ion batteries caused by charge and discharge10.1111/j.1551-2916.2011.04432.x ↗
31. Stress generation in silicon particles during lithium insertion10.1063/1.3458707 ↗
32. Analysis of the lithium-ion insertion silicon composite electrode/separator/lithium foil cell10.1149/1.3589301 ↗
33. Novel size and surface oxide effects in silicon nanowires as lithium battery anodes10.1021/nl202630n ↗
34. Stress generation and fracture in lithium insertion materials10.1007/s10008-006-0095-1 ↗
35. Effects of composition-dependent modulus, finite concentration and boundary constraint on Li-ion diffusion and stresses in a bilayer Cu-coated Si nano-anode10.1016/j.jpowsour.2012.01.029 ↗
36. Diffusion-induced stress, interfacial charge transfer, and criteria for avoiding crack initiation of electrode particles10.1149/1.3298892 ↗
37. Numerical simulation of intercalation-induced stress in Li-ion battery electrode particles10.1149/1.2759840 ↗
38. Chemical potential for diffusion in a stressed solid10.1016/0036-9748(81)90130-7 ↗
39. Alloy design for lithium-ion battery anodes10.1149/1.2752985 ↗
40. Bower · 2009
41. Cyclic plasticity and shakedown in high-capacity electrodes of lithium-ion batteries10.1016/j.ijsolstr.2012.12.019 ↗
42. Anisotropic compositional expansion and chemical potential for amorphous lithiated silicon under stress tensor10.1038/srep01615 ↗
43. A multi-scale approach for the stress analysis of polymeric separators in a lithium-ion battery10.1016/j.jpowsour.2010.06.020 ↗
44. The effect of battery design parameters on heat generation and utilization in a Li-ion cell10.1016/j.electacta.2012.07.081 ↗
45. A microstructural resolved model for the stress analysis of lithium-ion batteries10.1149/2.082405jes ↗
46. Intercalation-induced stress and heat generation within single lithium-ion battery cathode particles10.1149/1.2926617 ↗
47. Jirasek · 2002
48. 2008
49. Fu · 2001
50. Bergman · 2011
51. 2014
52. In situ tem of two-phase lithiation of amorphous silicon nanospheres10.1021/nl3044508 ↗
53. Lithium-assisted plastic deformation of silicon electrodes in lithium-ion batteries: a first-principles theoretical study10.1021/nl201501s ↗
54. Elastic softening of amorphous and crystalline Li–Si Phases with increasing Li concentration: a first-principles study10.1016/j.jpowsour.2010.04.044 ↗
55. Lithiation-induced tensile stress and surface cracking in silicon thin film anode for rechargeable lithium battery10.1063/1.4764329 ↗
56. The tension of metallic films deposited by electrolysis10.1098/rspa.1909.0021 ↗
57. Celebrating the 100th anniversary of the Stoney equation for film stress: developments from polycrystalline steel strips to single crystal silicon wafers10.1016/j.tsf.2008.07.014 ↗
58. Interconnected silicon hollow nanospheres for lithium-ion battery anodes with long cycle life10.1021/nl201470j ↗
59. Stable cycling of double-walled silicon nanotube battery anodes through solid-electrolyte interphase control10.1038/nnano.2012.35 ↗