journal article·2016-05Open access

Exchange current model for (La0.8Sr0.2)0.95MnO3 (LSM) porous cathode for solid oxide fuel cells

Kota Miyoshi, Takuma Miyamae, Hiroshi Iwai, Motohiro Saito, Masashi Kishimoto, Hideo Yoshida

Abstract

In this paper, we propose an empirical formula for i0, TPB, the exchange current density per unit triple-phase boundary (TPB) length, for porous lanthanum strontium manganite (LSM) cathodes of solid oxide fuel cells (SOFCs); the evaluation of i0, TPB is of crucial importance in numerical simulations of electrodes based on reconstructed microstructures obtained by a dual beam focused ion beam scanning electron microscopy (FIB-SEM) and tomography techniques. To derive a widely applicable empirical formula for i0, TPB, electrochemical measurements of porous LSM cathodes are conducted under various oxygen partial pressures (0.05–0.25 atm) and temperatures (800–950 °C). By comparing the derived formula with that derived from a thin and dense patterned LSM electrode used in previous studies, it is found that at an air temperature of 800 °C, i0, TPB derived from a porous LSM cathode is approximately 40% smaller than that for the patterned electrode. This can be attributed to the fact that the electrochemical reaction in thin and dense electrodes can occur not only at the TPBs but also at the LSM surface owing to the non-negligible ionic conductivity of LSM. The derived formula is also applied to a three-dimensional numerical simulation to confirm its validity.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Advancements in Solid Oxide Fuel Cells · Electronic and Structural Properties of Oxides · Magnetic and transport properties of perovskites and related materials

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (22)

Show source-provided references
1. Three-dimensional reconstruction of a solid-oxide fuel-cell anode10.1038/nmat1668 ↗
2. Quantification of SOFC anode microstructure based on dual beam FIB-SEM technique10.1016/j.jpowsour.2009.09.005 ↗
3. Quantitative evaluation of solid oxide fuel cell porous anode microstructure based on focused ion beam and scanning electron microscope technique and prediction of anode overpotentials10.1016/j.jpowsour.2010.12.100 ↗
4. Three-dimensional simulation of SOFC anode polarization characteristics based on sub-grid scale modeling of microstructure10.1149/2.086203jes ↗
5. Improvement of the sub-grid-scale model designed for 3D numerical simulation of solid oxide fuel cell electrodes using an adaptive power index10.1016/j.jpowsour.2012.09.077 ↗
6. Three-dimensional numerical analysis of mixed ionic and electronic conducting cathode reconstructed by focused ion beam scanning electron microscope10.1016/j.jpowsour.2010.11.142 ↗
7. 3D finite element model for reconstructed mixed-conducting cathodes: I. Performance quantification10.1016/j.electacta.2012.04.109 ↗
8. Effect of composition ratio of Ni-YSZ anode on distribution of effective three-phase boundary and power generation performance10.1002/fuce.201200174 ↗
9. Evaluation of SOFC anode polarization simulation using three-dimensional microstructures reconstructed by FIB tomography10.1016/j.electacta.2011.02.010 ↗
10. Estimation of charge-transfer resistivity of La0.8Sr0.2MnO3 cathode on Y0.16Zr0.84O2 electrolyte using patterned electrodes10.1149/1.1829415 ↗
11. A corrugated mesoscale structure on electrode–electrolyte interface for enhancing cell performance in anode-supported SOFC10.1016/j.jpowsour.2011.04.051 ↗
12. The geometry dependence of the polarization resistance of Sr-doped LaMnO3 microelectrodes on yttria-stabilized zirconia10.1016/S0167-2738(02)00379-X ↗
13. Active sites imaging for oxygen reduction at the La0.9Sr0.1MnO3 − x/yttria-stabilized zirconia interface by secondary-ion mass spectrometry10.1149/1.1838786 ↗
14. Oxygen tracer diffusion coefficient of LSM10.1016/0167-2738(96)00287-1 ↗
15. Modeling of oxygen reduction mechanism for 3PB and 2PB pathways at solid oxide fuel cell cathode from multi-step charge transfer10.1016/j.jpowsour.2011.11.002 ↗
16. Experimental and modeling study of solid oxide fuel cell operating with syngas fuel10.1016/j.jpowsour.2006.03.080 ↗
17. An analysis of biogas reforming process on Ni/YSZ and Ni/SDC catalysts
18. Three-dimensional numerical simulation for various geometries of solid oxide fuel cells10.1016/0378-7753(95)02269-4 ↗
19. Electrical properties and oxygen diffusion in yttria-stabilised zirconia (YSZ)–LaSrMnO (LSM) composites10.1016/j.ssi.2004.11.019 ↗
20. Electronic transport in 8 mole percent Y2O3-ZrO210.1149/1.2096302 ↗
21. A mathematical model of a solid oxide fuel cell10.1149/1.2048415 ↗
22. Performance/structure correlation for composite SOFC cathodes10.1016/S0378-7753(96)02361-0 ↗