journal article·2016-07

Measurement of effective bulk and contact resistance of gas diffusion layer under inhomogeneous compression – Part II: Thermal conductivity

Prabudhya Roy Chowdhury, Ajit Vikram, Ryan K. Phillips, Mina Hoorfar

Publisher page

Abstract

The gas diffusion layer (GDL) is a thin porous layer sandwiched between a bipolar plate (BPP) and a catalyst coated membrane in a fuel cell. Besides providing passage for water and gas transport from and to the catalyst layer, it is responsible for electron and heat transfer from and to the BPP. In this paper, a method has been developed to measure the GDL bulk thermal conductivity and the contact resistance at the GDL/BPP interface under inhomogeneous compression occurring in an actual fuel cell assembly. Toray carbon paper GDL TGP-H-060 was tested under a range of compression pressure of 0.34 to 1.71 MPa. The results showed that the thermal contact resistance decreases non-linearly (from 3.8 × 10 −4 to 1.17 × 10 −4 Km 2 W −1 ) with increasing pressure due to increase in microscopic contact area between the GDL and BPP; while the effective bulk thermal conductivity increases (from 0.56 to 1.42 Wm −1 K −1 ) with increasing the compression pressure. The thermal contact resistance was found to be greater (by a factor of 1.6–2.8) than the effective bulk thermal resistance for all compression pressure ranges applied here. This measurement technique can be used to identify optimum GDL based on minimum bulk and contact resistances measured under inhomogeneous compression.
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Fuel Cells and Related Materials · Advancements in Solid Oxide Fuel Cells · Electrocatalysts for Energy Conversion

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (43)

Show source-provided references
1. Effects of porosity change of gas diffuser on performance of proton exchange membrane fuel cell10.1016/S0378-7753(02)00605-5 ↗
2. Heterogeneous through-plane porosity distributions for treated PEMFC GDLs. II. Effect of MPL cracks10.1149/1.3594636 ↗
3. Microscale tomography investigations of heterogeneous porosity distributions of PEMFC GDLs10.1149/1.3481443 ↗
4. X-ray tomographic analysis of porosity distributions in gas diffusion layers of proton exchange membrane fuel cells10.1016/j.electacta.2014.11.143 ↗
5. Different methods for determining porosity of gas diffusion layer using x-ray microtomography10.1016/j.electacta.2015.10.083 ↗
6. Effects of porosity distribution variation on the liquid water flux through gas diffusion layers of PEM fuel cells10.1016/j.jpowsour.2006.02.060 ↗
7. Experimental measurement of effective diffusion coefficient of gas diffusion layer/microporous layer in PEM fuel cells10.1016/j.electacta.2011.12.110 ↗
8. Effective-diffusivity measurement of partially-saturated fuel-cell gas-diffusion layers10.1149/2.024211jes ↗
9. Absolute permeability and Knudsen diffusivity measurements in PEMFC gas diffusion layers and micro porous layers10.1016/j.jpowsour.2012.01.099 ↗
10. Experimental characterization of in-plane permeability of gas diffusion layers10.1016/j.jpowsour.2006.07.058 ↗
11. A fractal model for predicting permeability and liquid water relative permeability in the gas diffusion layer (GDL) of PEMFCs10.1016/j.jpowsour.2006.09.054 ↗
12. A fractal permeability model for the gas diffusion layer of PEM fuel cells10.1016/j.jpowsour.2006.01.032 ↗
13. Decreasing contact resistance in proton-exchange membrane fuel cells with metal bipolar plates10.1016/j.jpowsour.2012.11.012 ↗
14. An analytical model and parametric study of electrical contact resistance in proton exchange membrane fuel cells10.1016/j.jpowsour.2008.12.129 ↗
15. Bulk and contact resistances of gas diffusion layers in proton exchange membrane fuel cells10.1016/j.jpowsour.2014.01.082 ↗
16. Separate measurement of current density under the channel and the shoulder in PEM fuel cells10.1016/j.jpowsour.2008.01.091 ↗
17. Thermal conductivities from temperature profiles in the polymer electrolyte fuel cell10.1016/j.electacta.2003.10.018 ↗
18. Direct measurement of through-plane thermal conductivity and contact resistance in fuel cell materials10.1016/j.jpowsour.2006.06.092 ↗
19. Thermal conductivity and contact resistance of compressed gas diffusion layer of PEM fuel cell10.1002/fuce.200700054 ↗
20. Modelling the effect of inhomogeneous compression of GDL on local transport phenomena in a PEM fuel cell10.1002/fuce.200700058 ↗
21. Measurement of through-plane effective thermal conductivity and contact resistance in PEM fuel cell diffusion media10.1016/j.electacta.2009.10.035 ↗
22. Estimation of the effective thermal conductivity of carbon felts used as PEMFC Gas Diffusion Layers10.1016/j.ijthermalsci.2007.01.018 ↗
23. Measurement of in-plane thermal conductivity of carbon paper diffusion media in the temperature range of -20°C to +120°C10.1016/j.apenergy.2011.02.037 ↗
24. Measurement of the through-plane thermal conductivity of carbon paper diffusion media for the temperature range from -50 to +120°C10.1016/j.ijhydene.2011.06.097 ↗
25. Determining the effective thermal conductivity of compressed PEMFC GDLs through thermal resistance modelling10.1016/j.jpowsour.2012.06.011 ↗
26. Characterization techniques for gas diffusion layers for proton exchange membrane fuel cells e A review10.1016/j.jpowsour.2012.04.026 ↗
27. Thermal management issues in a PEMFC stack - a brief review of current status10.1016/j.applthermaleng.2008.05.009 ↗
28. Water management in a PEMFC: water transport mechanism and material degradation in gas diffusion layers10.1002/fuce.201000172 ↗
29. Ex situ measurements of through-plane thermal conductivities in a polymer electrolyte fuel cell10.1016/j.jpowsour.2009.06.077 ↗
30. Effective thermal conductivity of gas diffusion layers used in PEMFC: measured with guarded-hot-plate method and predicted by a fractal model
31. Effective thermal conductivity and thermal contact resistance of gas diffusion layers in proton exchange membrane fuel cells. Part 2: hysteresis effect under cyclic compressive load10.1016/j.jpowsour.2010.07.051 ↗
32. Effective thermal conductivity and thermal contact resistance of gas diffusion layers in proton exchange membrane fuel cells. Part 1: effect of compressive load10.1016/j.jpowsour.2010.06.039 ↗
33. Three-dimensional study of compressed gas diffusion layers using synchrotron X-ray imaging10.1016/j.jpowsour.2013.12.062 ↗
34. 3D microstructure modeling of compressed fiber-based materials10.1016/j.jpowsour.2014.01.095 ↗
35. Effect of compression on liquid water transport and microstructure of PEMFC gas diffusion layers10.1016/j.jpowsour.2006.09.045 ↗
36. Inhomogeneous compression of PEMFC gas diffusion layer10.1016/j.jpowsour.2006.11.018 ↗
37. Deposition and diffusion of platinum nanoparticles in porous carbon assisted by plasma sputtering10.1016/j.surfcoat.2005.01.033 ↗
38. Effects of sputtering parameters on the performance of electrodes fabricated for proton exchange membrane fuel cells10.1016/j.jpowsour.2005.05.088 ↗
39. Characterisation of mechanical behaviour and coupled electrical properties of polymer electrolyte membrane fuel cell gas diffusion layers10.1016/j.jpowsour.2008.09.026 ↗
40. Diffusion media materials and characterisation
41. Effect of gas diffusion layer anisotropy on mechanical stresses in a polymer electrolyte membrane10.1016/j.jpowsour.2010.06.026 ↗
42. PEM fuel cells
43. Determination of material properties of gas diffusion layers: experiments and simulations using phase contrast tomographic microscopy10.1149/1.3176876 ↗