Direct methanol fuel cell operation with pre-stretched recast Nafion®
Source abstract
Abstract
Abstract Direct methanol fuel cell operation with uniaxially pre-stretched recast Nafion ® membranes (draw ratio of 4) was investigated and compared to that with commercial (un-stretched) Nafion ® . The effects of membrane thickness (60–250 μm) and methanol feed concentration (0.5–10.0 M) on fuel cell power output were quantified for a cell temperature of 60 °C, ambient pressure air, and anode/cathode catalyst loadings of 4.0 mg cm −2 . Pre-stretched recast Nafion ® in the 130–180 μm thickness range produced the highest power at 0.4 V (84 mW cm −2 ), as compared to 58 mW cm −2 for Nafion ® 117. MEAs with pre-stretched recast Nafion ® consistently out-performed Nafion ® 117 at all methanol feed concentrations, with 33–48% higher power densities at 0.4 V, due to a combination of low area-specific resistance (the use of a thinner pre-stretched membrane, where the conductivity was the same as that for commercial Nafion ® ) and low methanol crossover (due to low methanol solubility in the membrane). Very high power was generated with a 180-μm thick pre-stretched recast Nafion ® membrane by increasing the cell temperature to 80 °C, increasing the anode/cathode catalyst loading to 8.0 mg cm −2 , and increasing the cathode air pressure to 25 psig. Under these conditions the power density at 0.4 V for a 1.0-M methanol feed solution was 240 mW cm −2 and the maximum power density was 252 mW cm −2 .
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Fuel Cells and Related Materials · Electrocatalysts for Energy Conversion · Advanced battery technologies research
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (26)
Show source-provided references
1. Kim · Polymer · 2003 · 44 · 572910.1016/S0032-3861(03)00580-9 ↗
2. Yang · Electrochem. Solid-State Lett. · 2003 · 6 · A22910.1149/1.1613073 ↗
3. Wycisk · J. Electrochem. Soc. · 2005 · 152 · A89210.1149/1.1874692 ↗
4. Lin · J. Appl. Polym. Sci. · 1998 · 70 · 12110.1002/(SICI)1097-4628(19981003)70:1<121::AID-APP12>3.0.CO;2-A ↗
5. Song · J. Power Sources · 2003 · 117 · 1410.1016/S0378-7753(03)00166-6 ↗
6. Lin · J. Electrochem. Soc. · 2006 · 153 · A132510.1149/1.2196687 ↗
7. Antonucci · Solid State Ionics · 1999 · 125 · 43110.1016/S0167-2738(99)00206-4 ↗
8. Dimitrova · J. Electroanal. Chem. · 2002 · 532 · 7510.1016/S0022-0728(02)01006-9 ↗
9. Jung · J. Power Sources · 2003 · 118 · 20510.1016/S0378-7753(03)00095-8 ↗
10. Tricoli · Electrochim. Acta · 2003 · 48 · 262510.1016/S0013-4686(03)00306-2 ↗
11. Lin · Electrochem. Solid-State Lett. · 2007 · 1 · B1910.1149/1.2382264 ↗
12. Carter · Electrochem. Solid-State Lett. · 2002 · 5 · A19510.1149/1.1495916 ↗
13. Loppinet · J. Phys. Chem. B · 1997 · 101 · 188410.1021/jp9623047 ↗
14. Skou · Solid State Ionics · 1997 · 97 · 33310.1016/S0167-2738(97)00033-7 ↗
15. Ren · J. Electrochem. Soc. · 2000 · 147 · 46610.1149/1.1393219 ↗
16. Hallinan · J. Phys. Chem. B · 2007 · 111 · 1322110.1021/jp075178n ↗
17. J. Lin, P.-H. Wu, R. Wycisk, P.N. Pintauro, Z. Shi, Macromolecules, (2008) ASAP Article; doi:10.1021/ma800194z.10.1021/ma800194z ↗
18. Hikita · JSAE Rev. · 2001 · 22 · 15110.1016/S0389-4304(01)00086-8 ↗
19. Jung · J. Fuel Cell Sci. Technol. · 2005 · 2 · 8110.1115/1.1840887 ↗
20. Liu · J. Power Sources · 2006 · 153 · 6110.1016/j.jpowsour.2005.03.190 ↗
21. Kim · J. Electrochem. Soc. · 2004 · 151 · A215010.1149/1.1819837 ↗
22. Ren · J. Electrochem. Soc. · 1996 · 143 · L1210.1149/1.1836375 ↗
23. Jung · J. Power Sources · 1998 · 71 · 16910.1016/S0378-7753(97)02793-6 ↗
24. Argyropoulos · Electrochim. Acta · 2000 · 45 · 198310.1016/S0013-4686(99)00420-X ↗
25. Ravikumar · J. Electrochem. Soc. · 1996 · 143 · 260110.1149/1.1837054 ↗
26. Ge · J. Power Sources · 2005 · 142 · 5610.1016/j.jpowsour.2004.11.022 ↗