journal article·2009-12

Thermodynamic analysis of diesel reforming process: Mapping of carbon formation boundary and representative independent reactions

Rajesh D. Parmar, Arunabha Kundu, Kunal Karan

Journal of Power Sources· Volume 194· Issue 2
Publisher page

Abstract

Abstract This paper presents thermodynamic analysis of commercial diesel with 50 ppm sulfur content for the three common modes of reforming operations. Thermodynamic analysis is done to get boundary data for carbon formation and to get the composition of various species for all modes and entire range of operations. For steam reforming operation, steam-to-carbon (S/C) ratio equal to or greater than 2 is required for carbon-free operation in entire temperature range (400–800 °C). However, selection of S/C ratio requires the balance between maximizing the hydrogen yield and minimizing the energy input both of which increase with increasing S/C ratio. For partial oxidation operation, O 2 /C ratio of 0.75 is preferable to maximize hydrogen yield but carbon formation can occur if regions of reactor experience temperatures lower than 700 °C. In case of autothermal reforming, for carbon-free operation, temperature of 750 °C, O 2 /C ratio in the range of 0.125–0.25 and S/C ratio greater than 1.25 and ideally 1.75 is recommended. However, enthalpy analysis indicates that it is not possible to reach to thermoneutral point at this condition so it is better to operate O 2 /C ratio 0.25 or little higher with constant heat supply. A set of three independent reactions is proposed that along with element balance equations can adequately describe the equilibrium composition of six major species—H 2 , CO 2 , CO, H 2 O, CH 4 , and C for the entire range of reforming operation.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Catalysts for Methane Reforming · Catalysis and Hydrodesulfurization Studies · Catalysis and Oxidation Reactions

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (25)

Show source-provided references
1. No Breathing Room—National Illness Costs of Air Pollution, Summary Report, August 2008, Canadian Medical Association.
2. Ahmed · Electrochem. Soc. Proc. · 2003 · 7 · 1240
3. Liu · Int. J. Hydrogen Energy · 2004 · 29 · 103510.1016/j.ijhydene.2003.11.009 ↗
4. Mumdschau · Catal. Today · 2008 · 136 · 19010.1016/j.cattod.2008.02.003 ↗
5. Argonne National laboratory, 2007, http://www.transportation.anl.gov/engines/idling.html (accessed October 25, 2008).
6. Bartholomew · Catal. Rev. Sci. Eng. · 1982 · 24 · 6710.1080/03602458208079650 ↗
7. Shekhawat · Catalysis · 2006 · 19 · 18410.1039/9781847555229-00184 ↗
8. Lutz · Int. J. Hydrogen Energy · 2003 · 28 · 15910.1016/S0360-3199(02)00053-8 ↗
9. Lutz · Int. J. Hydrogen Energy · 2004 · 29 · 80910.1016/j.ijhydene.2003.09.015 ↗
10. Lindetrmeir · Appl. Catal. B: Environ. · 2007 · 70 · 48810.1016/j.apcatb.2006.02.025 ↗
11. Kang · J. Power Sources · 2006 · 159 · 128310.1016/j.jpowsour.2005.12.048 ↗
12. Kang · J. Power Sources · 2006 · 163 · 53810.1016/j.jpowsour.2006.09.035 ↗
13. Olah · 1995
14. Kolb · 2008
15. Sahin · Energy Fuels · 2008 · 22 · 320110.1021/ef800236y ↗
16. Brown · Int. J. Hydrogen Energy · 2001 · 26 · 38110.1016/S0360-3199(00)00092-6 ↗
17. Amphlett · J. Power Sources · 1998 · 71 · 17910.1016/S0378-7753(97)02752-3 ↗
18. Wang · Electrochem. Commun. · 2007 · 9 · 221210.1016/j.elecom.2007.06.022 ↗
19. Cheekatamarla · J. Power Sources · 2006 · 154 · 22310.1016/j.jpowsour.2005.04.011 ↗
20. Smith · 1982
21. Garcia · Int. J. Hydrogen Energy · 1991 · 16 · 30710.1016/0360-3199(91)90166-G ↗
22. NIST-JANAF Thermochemical Tables
23. Pamidimukkala · J. Phys. Chem. Ref. Data · 1982 · 11 · 8310.1063/1.555656 ↗
24. Yaws · 1999
25. Cimenti · J. Power Sources · 2009 · 186 · 37710.1016/j.jpowsour.2008.10.043 ↗