journal article·2020-08

Effect of cathode recirculation on high potential limitation and self-humidification of hydrogen fuel cell system

Qinguo Zhang, Zheming Tong, Shuiguang Tong

Publisher page

Abstract

Abstract The high potential at the start and stop of the stack, as well as the flooding and film drying phenomena that occur during operation, will seriously cause the performance degradation of PEMFC. In this study, the effects of the cathode cycle on the high-voltage limiting strategy and water management characteristics of the hydrogen fuel cell system under different operating conditions was measured using the orthogonal test and the AC impedance measurement methods. The experimental results show that by reducing the fresh airflow and increasing the amount of air recirculation, the oxygen concentration can be reduced and the single piece voltage can always be kept below 0.8 V under a small load. Air recirculation improves the relative humidity at the cathode inlet close to the humidifier, thereby improving the output performance of the stack and having better dynamic characteristics. Furthermore, air recirculation can also enhance the water removal capacity of the stack outlet under high power operation with less pump power, thereby significantly improves the consistency of the distribution of oxygen along the flow channel and increasing the durability of the stack. The conclusion can provide more specific guidance for fuel cell performance improvement and control optimization.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Fuel Cells and Related Materials · Electrocatalysts for Energy Conversion · Advancements in Solid Oxide Fuel Cells

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (46)

Show source-provided references
1. A review of automotive proton exchange membrane fuel cell degradation under start-stop operating condition10.1016/j.apenergy.2018.04.049 ↗
2. Bi-directional nozzle control of multistage radial-inflow turbine for optimal part-load operation of compressed air energy storage10.1016/j.enconman.2018.12.014 ↗
3. Failure mechanism of PEM fuel cell under high back pressures operation10.1016/j.ijhydene.2019.03.221 ↗
4. Main factors affecting the lifetime of Proton Exchange Membrane fuel cells in vehicle applications: a review10.1016/j.apenergy.2014.03.048 ↗
5. Numerical analysis of the effect of different gas feeding modes in a proton exchange membrane fuel cell with serpentine flow-field10.1016/j.jpowsour.2011.01.079 ↗
6. Stack shut-down strategy optimisation of proton exchange membrane fuel cell with the segment stack technology10.1016/j.ijhydene.2019.10.218 ↗
7. Electrode for proton exchange membrane fuel cells: a review10.1016/j.rser.2018.03.007 ↗
8. Evolution of the degradation mechanisms with the number of stress cycles during an accelerated stress test of carbon supported platinum nanoparticles10.1016/j.jelechem.2019.02.052 ↗
9. SnO2 nanocluster supported Pt catalyst with high stability for proton exchange membrane fuel cells10.1016/j.electacta.2013.01.070 ↗
10. Cathode performance and high potential durability of Ta-SnO2 − δ-supported Pt catalysts for PEFC cathodes10.1016/j.elecom.2014.12.005 ↗
11. Scalable preparation of PtPd/carbon nanowires in the form of membrane as highly stable electrocatalysts for oxygen reduction reaction10.1016/j.ijhydene.2018.12.003 ↗
12. Corrosion behavior of TiN, TiAlN, TiAlSiN-coated 316L stainless steel in simulated proton exchange membrane fuel cell environment10.1016/j.jpowsour.2014.05.144 ↗
13. An investigation of the typical corrosion parameters used to test polymer electrolyte fuel cell bipolar plate coatings, with titanium nitride coated stainless steel as a case study10.1016/j.jpowsour.2015.03.111 ↗
14. Study on voltage clamping and self-humidification effects of pem fuel cell system with dual recirculation based on orthogonal test method10.1016/j.ijhydene.2018.06.172 ↗
15. Platinum dissolution and deposition in the polymer electrolyte membrane of a PEM fuel cell as studied by potential cycling10.1039/B514342J ↗
16. Impact of humidification by cathode exhaust gases recirculation on a PEMFC system for automotive applications10.1016/j.ijhydene.2018.11.139 ↗
17. Studies on the cathode humidification by exhaust gas recirculation for PEM fuel cell10.1016/j.ijhydene.2011.11.103 ↗
18. Three-dimensional simulation of a new cooling strategy for proton exchange membrane fuel cell stack using a non-isothermal multiphase model10.1016/j.apenergy.2019.113865 ↗
19. Investigation on cold start of polymer electrolyte membrane fuel cells with different cathode serpentine flow fields10.1016/j.ijhydene.2019.01.266 ↗
20. Evolution of thermal drifting during and after cold start of proton exchange membrane fuel cell by segmented cell technology10.1016/j.ijhydene.2015.04.045 ↗
21. Modeling two-phase flow in three-dimensional complex flow-fields of proton exchange membrane fuel cells10.1016/j.jpowsour.2017.09.003 ↗
22. Numerical investigation of the coupled water and thermal management in PEM fuel cell10.1016/j.apenergy.2013.02.031 ↗
23. A numerical multiphase CFD simulation for PEMFC with parallel sinusoidal flow fields10.1007/s10973-018-7270-3 ↗
24. Numerical investigation of liquid water transport dynamics in novel Hybrid sinusoidal flow channel designs for PEMFC10.3390/en12214030 ↗
25. Effect of inserting obstacles in flow field on a membrane humidifier performance for PEMFC application: a CFD model10.1016/j.ijhydene.2019.09.189 ↗
26. Flow field plates with trap-shape channels to enhance power density of polymer electrolyte membrane fuel cells10.1016/j.ijheatmasstransfer.2018.10.050 ↗
27. Performance of unit PEM fuel cells with a leaf-vein-simulating flow field-patterned bipolar plate10.1016/j.ijhydene.2019.07.120 ↗
28. Analysis of single- and two-phase flow characteristics of 3-D fine mesh flow field of proton exchange membrane fuel cells10.1016/j.jpowsour.2019.226995 ↗
29. Polytetrafluorethylene effects on liquid water flowing through the gas diffusion layer of polymer electrolyte membrane fuel cells10.1016/j.jpowsour.2019.226975 ↗
30. Numerical investigation of hydrogen consumption in Proton Exchange Membrane Fuel Cell by using computational fluid dynamics (CFD) simulation10.13171/mjc7618121415ya ↗
31. Humidification strategy for polymer electrolyte membrane fuel cells-A review10.1016/j.apenergy.2018.08.125 ↗
32. Internal flow structure, fault detection, and performance optimization of centrifugal pumps10.1631/jzus.A1900608 ↗
33. Real-time reconstruction of contaminant dispersion from sparse sensor observations with gappy POD method10.3390/en13081956 ↗
34. Preliminary design of multistage radial turbines based on rotor loss characteristics under variable operating conditions10.3390/en12132550 ↗
35. Effects of H2 on the number concentration of particulate matter in diesel engines using a low-pressure loop exhaust-gas recirculation system10.1016/j.ijhydene.2014.02.039 ↗
36. Generating efficiency and NOx emissions of a gas engine generator fueled with a biogasehydrogen blend and using an exhaust gas recirculation system10.1016/j.ijhydene.2010.03.076 ↗
37. Experimental investigation on effects of compression ratio and exhaust gas recirculation on backfire, performance and emission characteristics in a hydrogen fuelled spark ignition engine10.1016/j.ijhydene.2016.02.026 ↗
38. Effect of anodeecathode exhaust gas recirculation on energy recuperation in a solid oxide fuel cell-gas turbine hybrid power system10.1016/j.energy.2015.10.138 ↗
39. Development of 1-D multiphysics PEMFC model with dry limiting current experimental validation10.1016/j.electacta.2019.134601 ↗
40. Effects of operating conditions on water and heat management by a transient multi-dimensional PEMFC system model10.1016/j.energy.2019.06.148 ↗
41. Numerical analysis of operating conditions effects on PEMFC with anode recirculation10.1016/j.energy.2019.02.115 ↗
42. Comparison of self-humidification effect on polymer electrolyte membrane fuel cell with anodic and cathodic exhaust gas recirculation10.1016/j.ijhydene.2019.11.150 ↗
43. A quasi-2D transient model of proton exchange membrane fuel cell with anode recirculation10.1016/j.enconman.2018.06.091 ↗
44. Investigation of the liquid water distributions in a 50 cm2 PEM fuel cell: effects of reactants relative humidity, current density, and cathode stoichiometry10.1016/j.energy.2015.01.101 ↗
45. Energy efficiency improvements by investigating the water flooding management on proton exchange membrane fuel cell (PEMFC)10.1016/j.energy.2019.04.074 ↗
46. 3D experimental visualization of water flooding in proton exchange membrane fuel cells10.1016/j.energy.2019.03.128 ↗