journal article·2020-08

LaScO3-based electrolyte for protonic ceramic fuel cells: Influence of sintering additives on the transport properties and electrochemical performance

A.V. Kuzmin, A.S. Lesnichyova, E.S. Tropin, A. Yu Stroeva, V.A. Vorotnikov, D.M. Solodyankina, S.A. Belyakov, M.S. Plekhanov, A.S. Farlenkov, D.A. Osinkin, S.M. Beresnev, M.V. Ananyev

Publisher page

Abstract

Abstract In this work, the effect of the content of CuO, ZnO, Al2O3, NiO, Fe2O3, Co3O4 and MoO3 additives on the sinterability, microstructure, and electrical properties of La0.9Sr0.1ScO3-α proton-conducting oxide in a form of tubes produced by slip casting is studied. It is shown that the relative density of La0.9Sr0.1ScO3-α tubes without sintering aids is ~86%. The introduction of 1.0 wt % ZnO, Al2O3, NiO or 0.5 ÷ 1.0 wt % Co3O4 leads to a relative density of ceramics higher than 95%. Among dense ceramic tubes, LSS +0.5 wt % Co3O4 has the highest electrical conductivity. The introduction of 1 wt % Fe2O3 additive does not affect the sinterability of the LSS, and 1 wt % CuO and MoO3 inhibits LSS sintering. Single protonic ceramic fuel cells based on LSS +0.5 wt % Co3O4 and LSS +1.0 wt % NiO supporting electrolyte tubes with a thickness of 300 μm are studied. The maximum power density of about 30 mW/cm2 at 800 °C was obtained for a cell based on LSS +0.5 wt % Co3O4 using wet hydrogen as fuel and air as an oxidizing gas.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Advancements in Solid Oxide Fuel Cells · Fuel Cells and Related Materials · Chemical Looping and Thermochemical Processes

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (63)

Show source-provided references
1. Proton conduction in sintered oxides and its application to steam electrolysis for hydrogen production10.1016/0167-2738(81)90113-2 ↗
3. Solid-state protonic conductors: principles, properties, progress and prospects10.1016/S0167-2738(99)00152-6 ↗
4. Materials challenges toward proton-conducting oxide fuel cells: a critical review10.1039/b902343g ↗
5. Oxide-ion and proton conducting electrolyte materials for clean energy applications: structural and mechanistic features10.1039/b915141a ↗
6. On the development of proton conducting materials for technological applications10.1016/S0167-2738(97)00082-9 ↗
7. Prospect of hydrogen technology using proton-conducting ceramics10.1016/j.ssi.2003.03.001 ↗
8. Proton conductivity: materials and applications10.1021/cm950192a ↗
9. Protonic SOFCs using perovskite-type conductors10.4028/www.scientific.net/AST.95.66 ↗
10. Prospect of hydrogen technology using proton-conducting ceramics10.1016/j.ssi.2003.03.001 ↗
11. Perovskite solid electrolytes: structure, transport properties and fuel cell application10.1016/0167-2738(95)00056-C ↗
12. Protonic conduction in calcium, strontium and barium zirconates10.1016/0167-2738(93)90335-Z ↗
13. Proton conduction in sintered oxides based on BaCeO310.1149/1.2095649 ↗
14. BaCeO3: materials development, properties and application10.1016/j.pmatsci.2013.08.001 ↗
15. Recent activity in the development of proton conducting oxides for high-temperature applications10.1039/C6RA13347A ↗
16. Matsumoto · 2009 · 243
17. Advanced materials for SOFC application: strategies for the development of highly conductive and stable solid oxide proton electrolytes10.1016/j.pmatsci.2015.08.001 ↗
18. Stability of BaCeO3-based proton conductors in water-containing atmospheres10.1149/1.1391888 ↗
19. Proton conducting oxides: a review of materials and applications for renewable energy conversion and storage10.1016/j.rser.2019.04.042 ↗
20. Review: recent progress in low-temperature proton-conducting ceramics10.1007/s10853-019-03559-9 ↗
21. Proton-conducting oxide and applications to hydrogen energy devices10.1351/PAC-CON-12-07-11 ↗
22. Structural consideration on the ionic conductivity of perovskite-type oxides10.1016/S0167-2738(99)00066-1 ↗
23. Electrical behavior in (La0.9Sr0.1)MO3-δ (M = Al, Ga, Sc, In, and Lu) perovskites10.1016/S0167-2738(97)00101-X ↗
24. Proton and oxide ion conductivity of doped LaScO310.1016/S0167-2738(99)00194-0 ↗
25. Conductivity of A- and B-site doped LaAlO3, LaGaO3, LaScO3 and LaInO3 perovskites10.1016/S0167-2738(99)00337-9 ↗
26. Proton transport properties of La0.9M0.1YbO3−δ (M = Ba, Sr, Ca, Mg)10.1016/j.electacta.2013.01.156 ↗
27. Proton conduction in (La0.9Sr0.1)MIIIO3-δ (MIII= Sc, In, and Lu) perovskites10.1016/S0167-2738(02)00512-X ↗
28. Phase formation and electrical conductivity of Ba-doped LaScO3
29. Proton conduction in La0.6Ba0.4ScO2.8 cubic perovskite10.1016/S0167-2738(01)00887-6 ↗
30. Solid proton conducting electrolytes based on LaScO310.1134/S1023193512100084 ↗
31. Incorporation and conduction of proton in Sr-doped LaMO3 (M = Al, Sc, in, Yb, Y), electrochim
32. Proton conduction in doped LaScO3 perovskites10.1016/j.ssi.2004.02.076 ↗
33. Water uptake and transport properties of La1-xCaxScO3-α proton-conducting oxides10.3390/ma12142219 ↗
34. Incorporation and conduction of proton in Sr-doped LaMO3 (M = Al, Sc, in, Yb, Y), electrochim
35. Proton conduction in doped LaScO3 perovskites10.1016/j.ssi.2004.02.076 ↗
36. Phase composition and conductivity of La1–xSrxScO3–α (x = 0.01–0.20) under oxidative conditions10.1134/S1023193512050114 ↗
37. Nature of conductivity of perovskites La 1-xSrxScO3-α (x = 0.01-0.15) under oxidative and reducing conditions10.1134/S1023193512110158 ↗
38. Investigation of micro-tube solid oxide fuel cell fabrication using extrusion method10.1016/j.ijhydene.2015.12.203 ↗
39. Optimisation parameters for the extrusion of thin YSZ tubes for SOFC electrolytes10.1016/S0955-2219(99)00220-4 ↗
40. Studies on slip casting behavior of lanthanum strontium manganite10.1016/j.ceramint.2011.01.044 ↗
41. Porous electrolyte-supported tubular micro-SOFC design10.1016/j.ssi.2010.07.010 ↗
42. Dobrovol’skii · 1977
43. A study of multilayer tape casting method for anode-supported planar type solid oxide fuel cells (SOFCs)10.1016/j.jallcom.2006.07.110 ↗
44. Fabrication characteristics of an anode-supported thin-film electrolyte fabricated by the tape casting method for IT-SOFC10.1016/j.jmatprotec.2007.07.030 ↗
45. Dip coating fabrication process for micro-tubular SOFCs10.1016/j.ssi.2010.09.050 ↗
46. Fabrication of electrolyte supported micro-tubular SOFCs using extrusion and dip-coating10.1016/j.ijhydene.2012.12.056 ↗
47. Novel Ni cermets for anode-supported proton ceramic fuel cells10.1007/s10008-019-04233-5 ↗
48. Phase transitions in the BaCe1–xNdxO3–δ system (x = 0–0.15)10.1023/A:1023856322311 ↗
49. Phase transitions in undoped BaCeO310.1016/S0167-2738(03)00247-9 ↗
50. Sintering aids for proton-conducting oxides – a double-edged sword? A mini review10.1016/j.elecom.2020.106672 ↗
51. Sintering and properties of nanosized ceria solid solutions10.1016/S0167-2738(00)00437-9 ↗
52. The effect of cobalt oxide sintering aid on electronic transport in Ce0.80Gd0.20O2−δ electrolyte10.1016/S0013-4686(02)00816-2 ↗
53. Transitional metal-doped 8 mol.% yttria-stabilized zirconia electrolytes10.1016/j.ssi.2009.08.004 ↗
54. Formation of dense electrolytes based on BaCeO3 and BaZrO3 for application in solid oxide fuel cells: the role of solid-state reactive sintering10.1134/S2079978015030024 ↗
55. Influence of the transition-metal doping on conductivity of a BaCeO3-based protonic conductor10.1016/j.ssi.2005.09.027 ↗
56. Oxygen isotope exchange in proton-conducting oxides based on lanthanum scandates10.1016/j.ijhydene.2019.08.088 ↗
57. M.S. Plekhanov, A.V. Kuzmin, E.S. Tropin, D.A. Korolev, M.V. Ananyev, New mixed ionic and electronic conductors based on LaScO3: protonic ceramic fuel cells electrodes, J. Power Sources 449 (2020), 227476. doi: 10.1016/j.jpowsour.2019.227476.10.1016/j.jpowsour.2019.227476 ↗
58. Alumina–silica glass–ceramic sealants for tubular solid oxide fuel cells10.1007/s10853-018-3181-8 ↗
59. Hydrogen oxidation kinetics at Ni – Zr0.9Sc0.1O1.95 anode: influence of the difference of potential in the dense part of the double electric layer10.1016/j.electacta.2018.06.039 ↗
60. Single fuel cell with supported LSM cathode10.1134/S1023193512100035 ↗
61. Grain growth for CuO-BaO mixtures added BaTi1+xO3+2x ceramics10.1016/S0025-5408(97)00156-6 ↗
62. Phase diagram of the BaO–CuO binary system10.1111/j.1151-2916.1990.tb05252.x ↗
63. Synthesis and characterization of dense proton-conducting La1-xSrxScO3-α ceramics10.1016/j.ijhydene.2018.11.041 ↗