A novel thermal management system for improving discharge/charge performance of Li-ion battery packs under abuse
Source abstract
Abstract
Abstract Parasitic load, which describes electrical energy consumed by battery thermal management system (TMS), is an important design criterion for battery packs. Passive TMSs using phase change materials (PCMs) are thus generating much interest. However, PCMs suffer from low thermal conductivities. Most current thermal conductivity enhancement techniques involve addition of foreign particles to PCMs. Adding foreign particles increases effective thermal conductivity of PCM-systems but at expense of their latent heat capacity. This paper presents an alternate approach for improving thermal performance of PCM-based TMSs. The introduced technique involves placing battery cells in a vertically inverted position within the battery-pack. It is demonstrated through experiments that inverted cell-layout facilitates build-up of convection current in the pack, which in turn minimises thermal variations within the PCM matrix by enabling PCM mass transfer between the top and the bottom regions of the battery pack. The proposed system is found capable of maintaining tight control over battery cell temperature even during abusive usage, defined as high-rate repetitive cycling with minimal rest periods. In addition, this novel TMS can recover waste heat from PCM-matrix through thermoelectric devices, thereby resulting in a negative parasitic load for TMS.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Advanced Battery Technologies Research · Advanced Battery Materials and Technologies · Advanced battery technologies research
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (42)
Show source-provided references
1. Experimental investigation on thermal management of electric vehicle battery with heat pipe10.1016/j.enconman.2012.08.014 ↗
2. Thermal behavior analysis of lithium-ion batteries for electric and hybrid vehicles10.1016/S0378-7753(01)00478-5 ↗
3. Coupled electrochemical thermal modelling of a novel Li-ion battery pack thermal management system10.1016/j.apenergy.2016.08.049 ↗
4. Heat transfer in phase change materials for thermal management of electric vehicle battery modules10.1016/j.ijheatmasstransfer.2010.07.044 ↗
5. Nelson · 2011
6. Thermal management of lithium-ion batteries for electric vehicles10.1002/er.1956 ↗
7. Heat transfer in phase change materials for thermal management of electric vehicle battery modules10.1016/j.ijheatmasstransfer.2010.07.044 ↗
8. Failure propagation in multi-cell lithium ion batteries10.1016/j.jpowsour.2014.10.081 ↗
9. Physical and chemical analysis of lithium-ion battery cell-to-cell failure events inside custom fire chamber10.1016/j.jpowsour.2015.01.068 ↗
10. Review of mechanical design and strategic placement technique of a robust battery pack for electric vehicles10.1016/j.rser.2016.03.013 ↗
11. Non-steady experimental investigation on an integrated thermal management system for power battery with phase change materials10.1016/j.enconman.2017.01.069 ↗
12. An alternative cooling system to enhance the safety of Li-ion battery packs10.1016/j.jpowsour.2009.06.074 ↗
13. A novel thermal management system for electric vehicle batteries using phase-change material10.1149/1.1393888 ↗
14. A review of power battery thermal energy management10.1016/j.rser.2011.07.096 ↗
15. Graphene-enhanced hybrid phase change materials for thermal management of Li-ion batteries10.1016/j.jpowsour.2013.08.135 ↗
16. Effect of relaxation periods over cycling performance of a Li-Ion battery10.1149/2.0201502jes ↗
17. Critical analysis of open circuit voltage and its effect on estimation of irreversible heat for Li-ion pouch cells10.1016/j.jpowsour.2017.03.062 ↗
18. Heat transfer enhancement for thermal energy storage using metal foams embedded within phase change materials (PCMs)10.1016/j.solener.2010.04.022 ↗
19. Thermal management of Li-ion battery with phase change material for electric scooters: experimental validation10.1016/j.jpowsour.2004.09.033 ↗
20. Paraffin and paraffin/aluminum foam composite phase change material heat storage experimental study based on thermal management of Li-ion battery10.1016/j.applthermaleng.2015.01.009 ↗
21. Experimental study of a passive thermal management system for high-powered lithium ion batteries using porous metal foam saturated with phase change materials10.1016/j.jpowsour.2014.01.006 ↗
22. Thermal management of a LiFePO4 battery pack at high temperature environment using a composite of phase change materials and aluminum wire mesh plates10.1016/j.enconman.2016.09.081 ↗
23. Thermal management of a Li-ion battery using carbon fiber-PCM composites10.1016/j.applthermaleng.2015.02.068 ↗
24. Effect of nanoparticles on heat capacity of nanofluids based on molten salts as PCM for thermal energy storage10.1186/1556-276X-8-448 ↗
25. An investigation of melting/freezing characteristics of nanoparticle-enhanced phase change materials10.1007/s10973-011-2080-x ↗
26. Experimental and numerical study of constrained melting of n-octadecene with CuO nanoparticle dispersions in a horizontal cylindrical capsule subjected to a constant heat flux10.1016/j.ijheatmasstransfer.2013.08.001 ↗
27. Experimental study of a cylindrical lithium ion battery thermal management using phase change material composites10.1016/j.est.2016.08.005 ↗
28. Performance enhancement in latent heat thermal storage system: a review10.1016/j.rser.2009.06.024 ↗
29. Thermal conductivity enhancement of phase change materials for thermal energy storage: a review10.1016/j.rser.2010.08.007 ↗
30. CreativeMechanisms · 2016
31. Experimental and numerical study of melting in a cylinder10.1016/j.ijheatmasstransfer.2006.01.006 ↗
32. Numerical and experimental investigation of melting and freezing processes in phase change material storage10.1016/j.ijthermalsci.2003.07.001 ↗
33. Narasimhan
34. Scaling theory of melting with natural convection in an enclosure10.1016/0017-9310(88)90065-8 ↗
35. Kowalewski · 2004
36. An overview of cooling of thermoelectric devices10.1016/j.rser.2017.04.098 ↗
37. Thermoelectric generators: a review of applications10.1016/j.enconman.2017.02.070 ↗
38. TEGMART · 2017
39. JaycarElectronics · 2017
40. Evaluation of thermoelectric modules for power generation10.1016/S0378-7753(97)02801-2 ↗
41. Experimental study on thermoelectric modules for power generation at various operating conditions10.1016/j.energy.2012.06.076 ↗
42. Optics · 2017