journal article·2016-02

Development of a polymer electrolyte membrane fuel cell stack for an underwater vehicle

In-Su Han, Back-Kyun Kho, Sungbaek Cho

Publisher page

Abstract

Abstract This paper presents a polymer electrolyte membrane (PEM) fuel cell stack that is specifically designed for the propulsion of an underwater vehicle (UV). The stack for a UV must be continuously operated in a closed space using hydrogen and pure oxygen; it should meet various performance requirements such as high hydrogen and oxygen utilizations, low hydrogen and oxygen consumptions, a high ramp-up rate, and a long lifetime. To this end, a cascade-type stack design is employed and the cell components, including the membrane electrode assembly and bipolar plate, are evaluated using long-term performance tests. The feasibility of a fabricated 4-kW-class stack was confirmed through various performance evaluations. The proposed cascade-type stack exhibited a high efficiency of 65% and high hydrogen and oxygen utilizations of 99.89% and 99.68%, respectively, resulting in significantly lesser purge-gas emissions to the outside of the stack. The load-following test was successfully performed at a high ramp-up rate. The lifetime of the stack was confirmed by a 3500-h performance test, from which the degradation rate of the cell voltage was obtained. The advantages of the cascade-type stack were also confirmed by comparing its performance with that of a single-stage stack operating in dead-end mode.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Fuel Cells and Related Materials · Advanced battery technologies research · Advanced Battery Technologies Research

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (48)

Show source-provided references
1. Status of hydrogen fuel cell electric buses worldwide10.1016/j.jpowsour.2014.06.055 ↗
2. A review of polymer electrolyte membrane fuel cells: technology, applications, and needs on fundamental research10.1016/j.apenergy.2010.09.030 ↗
3. Development of a 25 kW-class PEM fuel cell system for the propulsion of a leisure boat10.7316/KHNES.2014.25.3.271 ↗
4. Performance of the fuel cell underwater vehicle URASHIMA10.1250/ast.26.249 ↗
5. Development of fuel cell AUV “URASHIMA”
6. 2004
7. Now, voyager? The increasing marine use of fuel cells
8. Davies · 2006
9. A reactive obstacle avoidance system for an autonomous underwater vehicle
10. DeepC: the new deep water AUV generation
11. Review of power systems and environmental energy conversion for unmanned underwater vehicles10.1016/j.rser.2011.12.016 ↗
12. Fuel cell systems for submarines: from the first idea to serial production10.1016/S0378-7753(01)01044-8 ↗
13. A sizing-design methodology for hybrid fuel cell power systems and its application to an unmanned underwater vehicle10.1016/j.jpowsour.2010.04.078 ↗
14. Analysis of 3000T class submarines equipped with polymer electrolyte fuel cells10.1016/j.energy.2011.03.003 ↗
15. Liquid droplet behavior and instability in a polymer electrolyte fuel cell flow channel10.1016/j.jpowsour.2006.04.093 ↗
16. Experimental investigations on liquid water removal from the gas diffusion layer by reactant flow in a PEM fuel cell10.1016/j.apenergy.2009.04.041 ↗
17. A review of accelerated stress tests of MEA durability in PEM fuel cells10.1016/j.ijhydene.2008.10.012 ↗
18. A review of the main parameters influencing long-term performance and durability of PEM fuel cells10.1016/j.jpowsour.2008.01.070 ↗
19. Mench · 2012
20. Degradation aspect of water formation and transport in proton exchange membrane fuel cell: a review10.1016/j.jpowsour.2013.04.044 ↗
21. Experimental and modeling studies on the effect of oxygen partial pressure on membrane degradation in PEMFCs10.1149/1.3110985 ↗
22. Effects of residual oxygen partial pressure on the degradation of polymer electrolyte membrane fuel cells under reverse current conditions10.1016/j.jpowsour.2011.09.085 ↗
23. Gas crossover and membrane degradation in polymer electrolyte fuel cells10.1016/j.electacta.2006.03.008 ↗
24. An experimental study on the purge characteristics of the cathodic dead-end mode PEMFC for the submarine or aerospace applications and performance improvement with the pulsation effects10.1016/j.ijhydene.2010.01.133 ↗
25. Effect of nitrogen crossover on purge strategy in PEM fuel cell systems10.1016/j.apenergy.2013.06.057 ↗
26. Reactant recirculation system utilizing pressure swing for proton exchange membrane fuel cell10.1016/j.jpowsour.2010.10.094 ↗
27. Larminie · 2003
28. Investigation of oxygen gain in polymer electrolyte membrane fuel cells10.1016/j.jpowsour.2004.05.034 ↗
29. A performance and degradation study of Nafion 212 membrane for proton exchange membrane fuel cells10.1016/j.jpowsour.2009.04.038 ↗
30. Measurement of liquid water accumulation in a PEMFC with dead-end anode10.1149/1.2976356 ↗
31. Optimization of purge cycle for dead-end anode fuel cell operation10.1016/j.ijhydene.2013.02.022 ↗
32. P.A. Rapaport, J.A. Rock, A.D. Bosco, J.P. Salvador, H.A. Gasteiger, L.A. Paine, Fuel cell stack design and method of operation, Patent US 6794068B2, 2002.
33. D. Bai, J.-G. Chouinard, D. Elkaim, Fuel cell stack with multiple groups of cells and flow passes, Patent US 7479333B2, 2004.
34. R. Schaefer, S. Lienkamp, Laminar bypass for cascaded stack, Patent US 7704620B2, 2005.
35. I.-S. Han, J. Jeong, H. K. Shin, T. Hur, D.-H. Kim, Cascade typed stack assembly in fuel cell system, Patent KR 1020100076046, 2010.
36. K. Strasser, Method and apparatus for disposing of water and/or inert gas from a fuel cell block, Patent US 5478662A, 1992.
37. Mobile fuel cell development at Siemens10.1016/0378-7753(92)80079-Q ↗
38. PEM fuel-cell stack design for improved fuel utilization10.1016/j.ijhydene.2013.06.136 ↗
39. Degradation of a polymer exchange membrane fuel cell stack with Nafion membranes of different thicknesses: part I. In situ diagnosis10.1016/j.jpowsour.2010.06.023 ↗
40. Degradation of a PEM fuel cell stack with Nafion membranes of different thickness. Part II: Ex situ diagnosis10.1016/j.jpowsour.2012.01.074 ↗
41. Local measurements of hydrogen crossover rate in polymer electrolyte membrane fuel cells10.1016/j.apenergy.2012.06.034 ↗
42. Understanding and approaches for the durability issues of Pt-based catalysts for PEM fuel cell10.1016/j.jpowsour.2007.07.004 ↗
43. Effect of PTFE content in microporous layer on water management in PEM fuel cells10.1016/j.jpowsour.2007.11.055 ↗
44. The effect of hydrogen crossover on open-circuit voltage in polymer electrolyte membrane fuel cells10.1016/j.jpowsour.2009.10.023 ↗
45. High fuel utilization operation of pure hydrogen fuel cells10.1016/j.ijhydene.2008.07.019 ↗
46. Critical flow rate of anode fuel exhaust in a PEM fuel cell system10.1016/j.jpowsour.2005.05.068 ↗
47. A polymer electrolyte fuel cell life test: 3 years of continuous operation10.1016/j.jpowsour.2005.09.062 ↗
48. 30,000 h operation of a 70 kW stationary PEM fuel cell system using hydrogen from a chlorine factory10.1016/j.ijhydene.2013.01.152 ↗