A multiphysics microstructure-resolved model for silicon anode lithium-ion batteries
Source abstract
Abstract
Abstract Silicon (Si) is one of the most promising next generation anode materials for lithium-ion batteries (LIBs), but the use of Si in LIBs has been rather limited. The main challenge is its large volume change (up to 300%) during battery cycling. This can lead to the fracture of Si, failure at the interfaces between electrode components, and large dimensional change on the cell level. To optimize the Si electrode/battery design, a model that considers the interactions of different cell components is needed. This paper presents the development of a multiphysics microstructure-resolved model (MRM) for LIB cells with a-Si anode. The model considered the electrochemical reactions, Li transports in electrolyte and electrodes, dimensional changes and stresses, property evolution with the structure, and the coupling relationships. Important model parameters, such as the diffusivity, reaction rate constant, and apparent transfer coefficient, were determined by correlating the simulation results to experiments. The model was validated with experimental results in the literature. The use of this model was demonstrated in a parameter study of Si nanowall|Li cells. The specific and volumetric capacities of the cell as a function of the size, length/size ratio, spacing of the nanostructure, and Li+ concentration in electrolyte were investigated.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Advancements in Battery Materials · Advanced Battery Technologies Research · Advanced Battery Materials and Technologies
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (78)
Show source-provided references
1. A high capacity nano Si composite anode material for lithium rechargeable batteries10.1149/1.1390899 ↗
2. Nano- and bulk-silicon-based insertion anodes for lithium-ion secondary cells10.1016/j.jpowsour.2006.09.084 ↗
3. Isotropic volume expansion of particles of amorphous metallic alloys in composite negative electrodes for Li-Ion batteries10.1149/1.2711075 ↗
4. Polymers with tailored electronic structure for high capacity lithium battery electrodes10.1002/adma.201102421 ↗
5. Conductive polymer binder-enabled cycling of pure tin nanoparticle composite anode electrodes for a lithium-ion battery10.1149/2.087306jes ↗
6. Lithium insertion into amorphous silicon thin-film electrodes10.1016/j.jelechem.2006.07.002 ↗
7. Amorphous silicon as a possible anode material for Li-ion batteries10.1016/S0378-7753(99)00194-9 ↗
8. A thin film silicon anode for Li-ion batteries having a very large specific capacity and long cycle life10.1016/j.jpowsour.2004.03.014 ↗
9. Amorphous silicon thin-film negative electrode prepared by low pressure chemical vapor deposition for lithium-ion batteries10.1016/S0038-1098(02)00849-9 ↗
10. High-performance lithium battery anodes using silicon nanowires10.1038/nnano.2007.411 ↗
11. Silicon nanowires for rechargeable lithium-ion battery anodes10.1063/1.2929373 ↗
12. Interconnected silicon hollow nanospheres for lithium-ion battery anodes with long cycle life10.1021/nl201470j ↗
13. Electrochemical behaviors of silicon based anode material10.1016/j.jpowsour.2005.03.143 ↗
14. Electrochemical characterizations on Si and C-Coated Si particle electrodes for lithium-ion batteries10.1149/1.1954967 ↗
15. Carbon−Silicon Core−Shell nanowires as high capacity electrode for lithium ion batteries10.1021/nl901670t ↗
16. In Situ TEM investigation of congruent phase transition and structural evolution of nanostructured silicon/carbon anode for lithium ion batteries10.1021/nl204559u ↗
17. Self-aligned Cu–Si core–shell nanowire array as a high-performance anode for Li-ion batteries10.1016/j.jpowsour.2011.10.004 ↗
18. Metal current collector-free freestanding silicon–carbon 1D nanocomposites for ultralight anodes in lithium ion batteries10.1016/j.jpowsour.2010.06.108 ↗
19. The effect of battery design parameters on heat generation and utilization in a Li-ion cell10.1016/j.electacta.2012.07.081 ↗
20. Thermal-electrochemical modeling of battery systems10.1149/1.1393625 ↗
21. Thermal model for a Li-Ion cell10.1149/1.2817888 ↗
22. A multi-scale approach for the stress analysis of polymeric separators in a lithium-ion battery10.1016/j.jpowsour.2010.06.020 ↗
23. A multiphysics model for the in situ stress analysis of the separator in a lithium-ion battery cell10.1016/j.commatsci.2013.10.002 ↗
24. Computational analysis of chemomechanical behaviors of composite electrodes in Li-ion batteries10.1557/jmr.2016.302 ↗
25. The effect of microstructure on the galvanostatic discharge of graphite anode electrodes in LiCoO2-based rocking-chair rechargeable batteries10.1149/1.3216000 ↗
26. Micro-scale modeling of Li-Ion batteries: parameterization and validation10.1149/2.096205jes ↗
27. Three dimensional simulation of galvanostatic discharge of LiCoO2 cathode based on x-ray nano-CT images10.1149/2.024210jes ↗
28. Mesoscale modeling of a Li-Ion polymer cell10.1149/1.2778285 ↗
29. Coupled mechanical-electrical-thermal modeling for short-circuit prediction in a lithium-ion cell under mechanical abuse10.1016/j.jpowsour.2015.04.162 ↗
30. Multiscale modeling and characterization for performance and safety of lithium-ion batteries10.1063/1.4927817 ↗
31. Study of lithium diffusivity in amorphous silicon via finite element analysis10.1016/j.jpowsour.2015.12.082 ↗
32. Investigation of the chemo-mechanical coupling in lithiation/delithiation of amorphous Si through simulations of Si thin films and Si nanospheres10.1016/j.jpowsour.2016.07.011 ↗
33. A microstructural resolved model for the stress analysis of lithium-ion batteries10.1149/2.082405jes ↗
34. Shewmon · 1991
35. Barsoum · 2002
36. Alloy design for lithium-ion battery anodes10.1149/1.2752985 ↗
37. Wiley: Lithium Ion Batteries: Fundamentals and Performance - Masataka Wakihara, Osamu Yamamoto, (n.d.). http://www.wiley.com/WileyCDA/WileyTitle/productCd-3527611983.html (accessed 6 May 2016).
38. Materials challenges and opportunities of lithium ion batteries10.1021/jz1015422 ↗
39. Analysis of electrochemical lithiation and delithiation kinetics in silicon10.1149/2.008303jes ↗
40. First principles model of amorphous silicon lithiation10.1149/1.3111037 ↗
41. Newman · 2004
42. Modeling of galvanostatic charge and discharge of the lithium/polymer/insertion cell10.1149/1.2221597 ↗
43. Analysis of the lithium-ion insertion silicon composite electrode/separator/lithium foil cell10.1149/1.3589301 ↗
44. Standards & Properties: Mechanical Properties of Copper and Copper Alloys at Low Temperatures, (n.d.). https://www.copper.org/resources/properties/144_8/(accessed 29 October 2016).
45. International · 2002
46. In Situ TEM of two-phase lithiation of amorphous silicon nanospheres10.1021/nl3044508 ↗
47. Lithium-assisted plastic deformation of silicon electrodes in lithium-ion batteries: a first-principles theoretical study10.1021/nl201501s ↗
48. Elastic softening of amorphous and crystalline Li–Si Phases with increasing Li concentration: a first-principles study10.1016/j.jpowsour.2010.04.044 ↗
49. Reactive flow in silicon electrodes assisted by the insertion of lithium10.1021/nl302261w ↗
50. Measurement and modeling of the mechanical and electrochemical response of amorphous Si thin film electrodes during cyclic lithiation10.1016/j.jmps.2013.10.005 ↗
51. In situ measurements of stress evolution in silicon thin films during electrochemical lithiation and delithiation10.1016/j.jpowsour.2010.02.013 ↗
52. S.-I. Lee, U.-H. Jung, Y.-S. Kim, M.-H. Kim, D.-J. Ahn, H.-S. Chun, A study of electrochemical kinetics of lithium ion in organic electrolytes, Korean J. Chem. Eng. 19 (n.d.) 638–644. http://dx.doi.org/10.1007/BF02699310.10.1007/BF02699310 ↗
53. Viscosity and carbon dioxide solubility for LiPF6, LiTFSI, and LiFAP in alkyl carbonates: lithium salt nature and concentration effect10.1021/jp500063c ↗
54. Transport properties of LiPF6-based Li-Ion battery electrolytes10.1149/1.1872737 ↗
55. Comparison of modeling predictions with experimental data from plastic lithium ion cells10.1149/1.1836921 ↗
56. Comparative study of EC/DMC LiTFSI and LiPF6 electrolytes for electrochemical storage10.1016/j.jpowsour.2011.07.071 ↗
57. Conductivity study of porous plasticized polymer electrolytes based on poly(vinylidene fluoride) a comparison with polypropylene separators10.1149/1.1393886 ↗
58. LiPF6–EC–EMC electrolyte for Li-ion battery10.1016/S0378-7753(01)00968-5 ↗
59. R. Wenige, M. Niemann, U. Heider, M. Jungnitz, V. Hilarius, Liquid Electrolyte Systems For Advanced Lithium Batteries. Merck KGaA, D-64271 Darmtadt, Germany., (n.d.). https://www.cheric.org/PDF/Symposium/S-J2-0063.pdf (accessed 7 July 2016).
60. Single nanostructure electrochemical devices for studying electronic properties and structural changes in lithiated Si nanowires10.1002/aenm.201100258 ↗
61. Analysis of lithium insertion/deinsertion in a silicon electrode particle at room temperature10.1149/1.3474225 ↗
62. High energy density all-solid-state batteries: a challenging concept towards 3D integration10.1002/adfm.200701245 ↗
63. Potentiostatic intermittent titration technique for electrodes governed by diffusion and interfacial reaction10.1021/jp207919q ↗
64. On the electrochemistry of an anode stack for all-solid-state 3D-integrated batteries10.1016/j.jpowsour.2008.07.076 ↗
65. Electrochemical charge transfer reaction kinetics at the silicon-liquid electrolyte interface10.1149/2.0181513jes ↗
66. Modeling the delamination of amorphous-silicon thin film anode for lithium-ion battery10.1016/j.jpowsour.2013.06.089 ↗
67. The tension of metallic films deposited by electrolysis10.1098/rspa.1909.0021 ↗
68. Celebrating the 100th anniversary of the Stoney equation for film stress: developments from polycrystalline steel strips to single crystal silicon wafers10.1016/j.tsf.2008.07.014 ↗
69. Bower · 2009
70. Large plastic deformation in high-capacity lithium-ion batteries caused by charge and discharge10.1111/j.1551-2916.2011.04432.x ↗
71. Cyclic plasticity and shakedown in high-capacity electrodes of lithium-ion batteries10.1016/j.ijsolstr.2012.12.019 ↗
72. A finite deformation stress-dependent chemical potential and its applications to lithium ion batteries10.1016/j.jmps.2012.03.008 ↗
73. Combining mechanical and chemical effects in the deformation and failure of a cylindrical electrode particle in a Li-ion battery10.1016/j.ijsolstr.2014.11.006 ↗
74. Anisotropic compositional expansion and chemical potential for amorphous lithiated silicon under stress tensor10.1038/srep01615 ↗
75. A finite strain model of stress, diffusion, plastic flow, and electrochemical reactions in a lithium-ion half-cell10.1016/j.jmps.2011.01.003 ↗
76. Intercalation-induced stress and heat generation within single lithium-ion battery cathode particles10.1149/1.2926617 ↗
77. Jirasek · 2002
78. 2014