BIOFEAT: Biodiesel fuel processor for a vehicle fuel cell auxiliary power unit
Source abstract
Abstract
An integrated auxiliary power unit (APU) based on a 10 kW e integrated biodiesel fuel processor has been designed and is being developed. Auto-thermal reforming (ATR) and thermal cracking (TC) were considered for converting the fuel into a hydrogen-rich gas suitable for PEM fuel cells. The fuel processor includes also a gas clean-up system that will reduce the carbon monoxide in the primary processor exit gas to below 10 ppm via a new heat-integrated CO clean-up unit, based on the assembly of catalytic heat exchange plates, so as to meet the operational requirements of a PEMFC stack. This article is devoted to the study and selection of the proper feed strategy for the primary fuel processor. Different pre-treatment and feed alternatives (e.g. based on nozzles or simple coils) were devised and tested for the ATR processors, which turned out to be the preferred primary processing route. A nozzle-based strategy was finally selected along with special recommendations about the constituent materials and the operating procedures to be adopted to avoid coking and nozzle corrosion as well as to allow a wide turn down ratio.
Source: expertdata · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Fuel Cells and Related Materials · Biodiesel Production and Applications · Electrocatalysts for Energy Conversion
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (10)
Show source-provided references
1. Fifth FP EU Commission Funded Project BIOFEAT, Biodiesel Fuel Processor for a Fuel Cell Auxiliary Power Unit for a Vehicle, ENK-CT-2002-00612, 2002.
2. CEC, Green Paper: Towards a EU Strategy for the Security of Energy Supply, COM 769 Final, 2000.
3. Bauen · J. Power Sources · 2000 · 86 · 48210.1016/S0378-7753(99)00445-0 ↗
4. Biodiesel fuel processing by catalytic cracking for APU applications
5. Fifth EU Commission Funded Project PROFUEL, On Board Gasoline Processor for Fuel Cell Vehicle Application, ERK6-CT-1999-00023, 1999.
6. Conceptual design and selection of a biodiesel fuel processor for a vehicle fuel cell A.P.U.
7. S. Specchia, F.W.A. Tillemans, P.F. van den Oosterkamp, G. Saracco, Conceptual design and selection of a biodiesel fuel processor for a vehicle fuel cell auxiliary power unit, J. Power Sources, in press.10.1016/j.jpowsour.2004.12.076 ↗
8. Twigg · 1989
9. The Official Site of the National Biodiesel Board (www.biodiesel.org).
10. International Organization of Standards (ISO 5167-1), Measurement of fluid flow by means of pressure differential devices, Part 1: orifice plates, nozzles, and venturi tubes inserted in circular cross-section conduits running full. Reference number: ISO 5167-1:1991(E).