Effect of electrode configuration and electronic conductivity on current density distribution measurements in PEM fuel cells
Source abstract
Abstract
Abstract Current density and potential distribution measurements were conducted using a segmented current collector and flow field setup on membrane electrode assemblies prepared with segmented and unsegmented electrodes made from two different types of commercially available gas diffusion layers. Both galvanostatic and potentiostatic discharge modes were employed. Irrespective of the type of gas diffusion layer, when a common electrode was employed, significant performance variations were encountered between current collector segments in the constant voltage mode, while the segment to segment variations were minimal in the constant current mode. Both types of discharge modes showed negligible variations between segments in the case of segmented electrode. A simple mathematical model was developed to assist in the interpretation of the experimental results. The differences in contact resistances between the current collectors and the gas diffusion layer, especially on the cathode side have been identified as the primary reason for the experimentally observed behavior. Based on the results presented here, segmenting the electrode along with the current collector is recommended for current distribution studies. When using a common electrode, only the galvanostatic mode is preferred to minimize contact artifacts.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Fuel Cells and Related Materials · Electrocatalysts for Energy Conversion · Advanced Battery Technologies Research
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (36)
Show source-provided references
1. S. Gottesfeld, T.A. Zawodzinski, Polymer electrolyte fuel cells, in: R.C. Alkire, H. Gerischer, D.M. Kolb, C.W. Tobias (Eds.), Advances in Electrochemical Science and Engineering, vol. 5, Wiley/VCH, New York, 1997, p. 195.10.1002/9783527616794.ch4 ↗
2. Nguyen · J. Electrochem. Soc. · 1996 · 143 · L10510.1149/1.1836666 ↗
3. Springer · J. Electrochem. Soc. · 1993 · 140 · 351310.1149/1.2221120 ↗
4. Mosdale · J. Electrochim. Acta · 1995 · 40 · 41310.1016/0013-4686(94)00289-D ↗
5. Bernardi · J. Electrochem. Soc. · 1992 · 139 · 247710.1149/1.2221251 ↗
6. Perry · J. Electrochem. Soc. · 1998 · 145 · 510.1149/1.1838202 ↗
7. Nguyen · J. Electrochem. Soc. · 1993 · 140 · 217810.1149/1.2220792 ↗
8. West · J. Appl. Electrochem. · 1996 · 26 · 5710.1007/BF00253453 ↗
9. Gurau · AIChE J. · 1998 · 44 · 241010.1002/aic.690441109 ↗
10. Singh · Int. J. Eng. Sci. · 1999 · 37 · 43110.1016/S0020-7225(98)00079-2 ↗
11. Dutta · J. Appl. Electrochem. · 2000 · 30 · 13510.1023/A:1003964201327 ↗
12. Shimpalee · J. Numer. Heat Transfer, Part A · 2000 · 38 · 11110.1080/10407780050135360 ↗
13. Natarajan · J. Electrochem. Soc. · 2001 · 148 · 132410.1149/1.1415032 ↗
14. Natarajan · J. Power Sour. · 2003 · 115 · 6610.1016/S0378-7753(02)00624-9 ↗
15. Yi · J. Electrochem. Soc. · 1999 · 146 · 3810.1149/1.1391561 ↗
16. J.S. Yi, T.V. Nguyen, A two-phase flow model to investigate the hydrodynamics of gas and liquid water in the cathode of PEM fuel cells with interdigitated gas distributors, in: Proceedings of the AIChE Meeting, Paper 107b, Miami Beach, FL, 15–20 November 1998.
17. He · AIChE J. · 2000 · 46 · 205310.1002/aic.690461016 ↗
18. Wang · Int. J. Heat Mass Transfer · 1996 · 39 · 361910.1016/0017-9310(96)00037-3 ↗
19. Cleghorn · J. Appl. Electrochem. · 1998 · 28 · 66310.1023/A:1003206513954 ↗
20. Stumper · Electrochim. Acta · 1998 · 43 · 377310.1016/S0013-4686(98)00137-6 ↗
21. Wieser · J. Appl. Electrochem. · 2000 · 30 · 80310.1023/A:1004047412066 ↗
22. D. Natarajan, T.V. Nguyen, Experimental investigation of spatial–temporal current distribution in a PEM fuel cell, in: Proceedings of the AIChE 2000 Annual Meeting and Symposium on Fuel Cells, Systems and Processors II, Paper No. 4, Los Angeles, CA, 12–17 November 2000.
23. Brett · Electrochem. Commun. · 2001 · 3 · 62810.1016/S1388-2481(01)00234-X ↗
24. Mench · J. Electrochem. Soc. · 2003 · 150 · A7910.1149/1.1526108 ↗
25. Mench · J. Electrochem. Soc. · 2003 · 150 · A105210.1149/1.1584440 ↗
26. Nopenen · J. Power Sour. · 2002 · 106 · 30410.1016/S0378-7753(01)01063-1 ↗
27. Hottinen · J. Appl. Electrochem. · 2003 · 33 · 26510.1023/A:1024184824662 ↗
28. Nguyen · Comput. Chem. Eng. · 1987 · 11 · 54310.1016/0098-1354(87)80029-7 ↗
29. Parthasarathy · J. Electrochem. Soc. · 1992 · 139 · 253010.1149/1.2221258 ↗
30. Paik · J. Electrochem. Soc. · 1989 · 136 · 64410.1149/1.2096703 ↗
31. G.O. Mepsted, J.M. Moore, Performance and durability of bipolar plate materials, in: W. Vielstich, A. Lamm, H.A. Gasteiger (Eds.), Handbook of Fuel Cells, vol. 3, Wiley, 2003, p. 286.
32. Barbir · J. New Mater. Electrochem. Syst. · 1999 · 2 · 197
33. He · J. Electrochem. Soc. · 2004 · 151 · A18510.1149/1.1634272 ↗
34. D. Natarajan, T.V. Nguyen, in: Proceedings of the 201st Meeting of The Electrochemical Society, Meeting Abstracts, Abstract No. 129, vol. 2002-1, 2002.
35. J. Newman, Electrochemical Systems, Prentice-Hall, Englewood Cliffs, NJ, 1973.
36. T.V. Nguyen, W. He, Interdigitated flow field design, in: W. Vielstich, A. Lamm, H.A. Gasteiger (Eds.), Handbook of Fuel Cells, vol. 3, Wiley, 2003, p. 286.