A semi-empirical voltage degradation model for a low-pressure proton exchange membrane fuel cell stack under bus city driving cycles
Source abstract
Abstract
A voltage degradation model for the low-pressure proton exchange membrane fuel cell (PEMFC) stack used in a fuel cell bus is presented: (1) the oxygen concentration term was derived from the PEMFC output voltage equation, and the concept of oxygen concentration resistance coefficient was introduced; (2) a 5 kW low-pressure PEMFC stack was used in this study. Two similar tests were carried out before and after the stack operating in the driving cycle for 640 h. First, the ohmic losses under different temperatures were measured using the current interrupt method and formulized with linear fitting method. Then, the oxygen concentration term was studied by the experiments with different air stoichiometric ratios while keeping the other operating parameters unchanged. The oxygen concentration resistance coefficient was obtained from the difference of voltages for the PEMFC stack in different air stoichiometric ratios using the genetic optimization algorithm. Then, the activation loss was obtained based on the PEMFC output voltage, the ohmic loss, and the concentration loss. The degradation model of the stack was built finally by comparing the two test results; (3) the correlation of the model to the actual experimental data is good; (4) the overvoltage of the stack with aging was analyzed using this model. The analysis showed that the activation overvoltage dominated the stack loss with about 80% of the total losses, followed by the ohmic loss. The concentration loss almost does not change with aging in the driving cycle condition; (5) the comparison of the simulation with the actual data from the PEMFC bus running for 30,000 km indicated that after 36,000 km the rated power of the PEMFC bus must be reduced.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Fuel Cells and Related Materials · Electrocatalysts for Energy Conversion · Advanced Battery Technologies Research
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (20)
Show source-provided references
1. Yi · 2003
2. High energy efficiency and high power density proton exchange membrane fuel cells-electrode kinetics and mass transport10.1016/0378-7753(91)87009-Z ↗
3. Modeling of proton exchange membrane fuel cell performance with an empirical equation10.1149/1.2050072 ↗
4. Modeling fuel cell stack systems10.1016/S0378-7753(97)02812-7 ↗
5. Modeling electrochemical performance in large scale proton exchange membrane fuel cell stack10.1016/S0378-7753(97)02683-9 ↗
6. Performance modeling of the Ballard Mark IV solid polymer electrolyte fuel cell, I. mechanistic model development10.1149/1.2043866 ↗
7. Performance modeling of the Ballard Mark IV solid polymer electrolyte fuel cell, II. empirical model development10.1149/1.2043959 ↗
8. Parametric modeling of the performance of a 5kW proton-exchange membrane fuel cell stack10.1016/0378-7753(93)01835-6 ↗
9. A practical PEM fuel cell model for simulating vehicle power sources, battery conference on applications and advances
10. Andrew Richard Balkin. Modeling a 500W polymer electrolyte membrane fuel cell. Dissertation for engineering bachelor degree, Sydney University of Technology, Sydney, 2002.
11. Development and application of a generalized steady-state electrochemical model for a PEM fuel cell10.1016/S0378-7753(99)00484-X ↗
12. Simulation and analysis of transient fuel cell system performance based on a dynamic reactant flow model
13. Modeling and control for PEM fuel cell stack system
14. Incorporation of voltage degradation into a generalized steady state electrochemical model for a PEM fuel cell10.1016/S0378-7753(01)01029-1 ↗
15. Larminie · 2003
16. Investigation of the transversal water profile in Nafion membranes in polymer electrolyte fuel cells10.1149/1.1345868 ↗
17. The genetic optimization algorithm for energy distribution of the hybrid power system of a fuel cell bus
18. Effect of potential cycling on loss of electrochemical surface area of platinum catalyst in polymer electrolyte membrane fuel cells
19. Shao jingyue, Experimental method for fuel cell stack performance estimation, Dissertation for engineering bachelor degree, Tsinghua University, Beijing, 2005, pp. 54–68.
20. Aging mechanisms and lifetime of PEFC and DMFC10.1016/j.jpowsour.2003.09.033 ↗