journal article·2003-02

The performance of PEM fuel cells fed with oxygen through the free-convection mode

Pei-Wen Li, Tao Zhang, Qing-Ming Wang, Laura Schaefer, Minking K. Chyu

Journal of Power Sources· Volume 114· Issue 1
Publisher page

Abstract

The feasibility and restrictions of feeding oxygen to a PEM fuel cell through free-convection mass transfer were studied through theoretical analysis and experimental testing. It was understood through the theoretical analysis that the free-convection mass-transfer coefficient strongly depends on the difference in mass fraction or concentration of oxygen at the cathode surface and in the quiescent air. Thus, the mass-transfer rate has a strong dependence on the oxygen concentration at the cathode surface, which can be viewed in terms of the relationship of the fuel cell current density and the fuel cell voltage. Through this analysis, the maximum applicable current density was derived, beyond which there will be an abrupt drop in the output voltage, which results in excessively low power in the fuel cell. Experimental tests were conducted for one PEM fuel cell stack and two single PEM fuel cell units. An excessive drop in output voltage was observed when the free-convection mass-transfer mode was utilized. It was also found that the orientation of the cathode surface affects the performance of the fuel cell, which is mainly due to the fact that the free-convection mass-transfer coefficient depends on the orientation of the involved mass-transfer surface, which is analogous to free-convection heat transfer.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Fuel Cells and Related Materials · Electrocatalysts for Energy Conversion · Advancements in Solid Oxide Fuel Cells

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (12)

Show source-provided references
1. Fuel cells: reaching the era of clean and efficient power generation in the twenty-first century10.1146/annurev.energy.24.1.281 ↗
2. Approaches and technical challenges to high temperature operation of proton change membrane fuel cells10.1016/S0378-7753(01)00812-6 ↗
3. Development of a 1 kW polymer electrolyte fuel cell power source10.1016/S0378-7753(00)00513-9 ↗
4. Design of stationary PEFC system configurations to meet heat and power demands10.1016/S0378-7753(01)01058-8 ↗
5. Modeling polymer electrolyte fuel cells: an innovative approach10.1016/S0378-7753(01)00758-3 ↗
6. Numerical simulation of a new operational regime for a polymer electrolyte fuel cell10.1016/S1388-2481(01)00164-3 ↗
7. E.R.G. Eckert, R.M. Drake, Analysis of Heat and Mass Transfer, McGraw-Hill, New York, 1972.
8. F.P. Incropera, D.P. DeWitt, Introduction to Heat Transfer, 4th ed., Wiley, New York, 2002.
9. Y.A. Cengel, M.A. Boles, Thermodynamics: An Engineering Approach, 2nd ed., McGraw-Hill, New York, 1994.
10. Two-dimensional simulation of water transport in polymer electrolyte fuel cells10.1016/S0009-2509(00)00066-X ↗
11. Development and application of a generalized steady-state electrochemical model for a PEM fuel cell10.1016/S0378-7753(99)00484-X ↗
12. Polymer electrolyte fuel cell model10.1149/1.2085971 ↗