Lignocellulosic composites with grafted polystyrene interfaces

Abstract The effects of surface grafting of a polymer onto lignocellulosic fiber surface and processing methods on both the interfacial interactions and the resulting composite properties of the fiber-reinforced thermoplastic composites were investigated. Chemithermomechanical pulp (CTMP) wood fiber was used as a reinforcement, which has been chemically modified by radical polymer grafting of styrene onto the fiber surfaces. The chemically modified CTMP fiber was then compounded with polystyrene (PS). Two different processing methods, both compression and injection moldings, were performed to prepare the wood-fiber-reinforced composites. Experimental results showed that surface modification of wood fiber leads to an obvious increase in mechanical properties of the fiber-reinforced composites as compared to the untreated fiber composites. The enhancement of mechanical properties is much greater through injection molding compared with compression molding owing to occurrence of orientation, and better mixing and interaction between the fiber and the matrix by injection molding. An improvement in fiber wetting properties and adhesion by the matrix was observed through scanning electron microscopy for the surface grafted fiber reinforced composites. Untreated wood fiber exhibited a smooth surface without adhered polymer, indicating poor adhesion, while polymer attached to the surface was seen on treated cellulose fiber due to the higher fiber-matrix interactions. Keywords: THERMOPLASTICSCOMPOSITESWOOD FIBERSINTERFACES/INTERPHASESMECHANICAL PROPERTIES