A metallographic and quantitative analysis of the influence of stacking fault energy on shock-hardening in Cu and Cu–Al alloys

Abstract This paper deals with the mechanical behavior of Cu and solid–solution Cu–Al alloys that were shock-deformed to 10 and 35 GPa. All the shock-deformed materials showed shock-strengthening that was greater at higher shock pressure and decreased with decreasing stacking fault energy (SFE) at both shock pressures. In the literature, shock-strengthening has been qualitatively ascribed to a greater dislocation density and the formation of deformation twins without addressing the question as to why shock-strengthening is lower in low SFE materials. This question is addressed in the present work by quantifying the twin contribution to the total post-shock strength. The twin contribution was found to increase with decreasing SFE suggesting that the contribution of dislocations concurrently decreases. The stored energy of as-shock-deformed materials was measured and found to decrease with decreasing SFE implying a lower net stored dislocation density in the lower SFE alloys. It is suggested that a lower net stored dislocation density in low SFE alloys results in the observed lower shock strengthening.