Source abstract
Abstract
High Resolution Image Download MS PowerPoint Slide Palladium nanoparticles supported on alumina are widely used as catalysts in emissions after-treatment. The evolution of Pd particle size distributions during sintering is influenced by the initial Pd nanoparticle size distribution, surface heterogeneities of Pd and the oxide support, and the reduction or oxidizing gas environments. Here, we synthesized Pd nanoparticles of similar average particle sizes and different distributions using either colloidal synthesis (normally distributed) or incipient wetness impregnation (log-normally distributed) on different amorphous Al 2 O 3 supports (γ-Al 2 O 3, La-doped γ-Al 2 O 3 ). Under oxidative (O 2, 1073 K) and reductive (H 2, 1073 K) aging conditions, Pd showed similar sintering rates on γ-Al 2 O 3 and La-doped Al 2 O 3 (quantified by TEM, O 2 chemisorption and XRD). Starting from the same average Pd particle sizes, reductive conditions resulted in a greater extent of Pd sintering for samples prepared by incipient wetness impregnation, while oxidative conditions resulted in a greater extent of sintering for samples prepared by colloidal synthesis methods. This contrast between samples was rationalized using Ostwald ripening kinetic models that show colloidally synthesized particles are formed in different regions of the support and have a lower chemical potential upon exposure to dihydrogen rather than dioxygen. Consistent with these findings, samples prepared using incipient wetness impregnation with the Pd precursors used for colloidal synthesis approaches show reductive and oxidative sintering rates similar to those of colloidally prepared materials. Our results show that the average particle size is an incomplete predictor for particle sintering behavior, and colloidal synthesis methods may alter nanoparticle deposition and surface chemistry along with particle size distributions.
Source: openalex_inverted_index · Quality: baseline
Affiliations
Charles D. Davidson School of Chemical Engineering, Purdue University, 480 Stadium Mall Drive, West Lafayette, Indiana 47907, United States
Department of Chemical Engineering
University of Virginia
Department of Chemistry, Purdue University, 560 Oval Drive, West Lafayette, Indiana 47907, United States
Research and Advanced Engineering, Ford Motor Company, 2101 Village Road, Dearborn, Michigan 48124, United States
Funding
Ford Motor Company · Division of Chemical, Bioengineering, Environmental, and Transport Systems