Bulk amorphous FC20 (Fe–C–Si) alloys with small amounts of B and their crystallized structure and mechanical properties

The addition of a small amount (0.4 mass%) of B to a commercial FC20 cast iron was found to cause the formation of an amorphous phase in melt-spun ribbon and cast cylinders with a diameter of up to 0.5 mm. The structure of a melt-spun B-free FC20 alloy consisted of {alpha}-Fe, {gamma}-Fe and Fe{sub 3}C. The effectiveness of additional B is presumably due to the generation of attractive bonding nature among the constituent elements. The amorphous alloy ribbon exhibits a high tensile strength of 3,480 MPa and good bending ductility. The annealing causes the formation of an amorphous phase containing {alpha}-Fe particles with a size of about 30 nm. The mixed phase alloy exhibits an improved tensile strength of 3,800 MPa without detriment to good ductility. With further increasing temperature, the mixed amorphous and {alpha}-Fe structure changes to {alpha}-Fe + Fe{sub 3}C + graphite through the metastable structure of {alpha}-Fe + Fe{sub 3}C. The structure after annealing for 900s at 1,200 K has fine grain sizes of about 0.5 {micro}m for {alpha}-Fe, 0.3 {micro}m for Fe{sub 3}C and 1 {micro}m for graphite. The graphite-containing alloy exhibits high tensile strength of 1,200--2,000 MPa and large elongation of 5--13%. The high tensilemore » strength and good ductility were also obtained for the 0.5 mm cylinder annealed at 1,200 K. The good mechanical properties are due to the combination of fine subdivision of crack initiation sites by the homogeneous dispersion of small graphite particles and the dispersion strengthening of Fe{sub 3}C particles against the deformation of the {alpha}-Fe phase. The synthesis of the finely mixed {alpha}-Fe + Fe{sub 3}C + graphite alloys having good mechanical properties by crystallization of the new amorphous alloy in the melt-spun ribbon and cast cylinder forms is encouraging for the future development of a new Fe-based high-strength and high-ductility material.« less