Effect of cooling rate on the composition and chemical heterogeneity of quench-induced grain boundary η-phase precipitates in 7xxx aluminium alloys

The mechanical properties and stress corrosion cracking (SCC) resistance of 7xxx series aluminium alloys are significantly affected by the composition and distribution of precipitates formed during heat treatment. In particular, their quench sensitivity is related to the formation of η-phase precipitates that nucleate heterogeneously on grain boundaries at lower cooling rates after solution treatment, which has been a key factor restricting the gauge of hot rolled plates in the aerospace industry. To better understand the effects of slower cooling rates on the composition of quench-induced grain boundary precipitates (Q-GBPs) found in thick plate 7xxx alloys, plasma focused ion beam and high-resolution scanning transmission electron microscopy were used to obtain accurate composition data. The η-phase Q-GBPs have a complex- branched morphology, which develops higher aspect ratios and secondary arms as the cooling rate is reduced. Only a small change in average composition of Q-GBPs was found with cooling rate; but a large scatter was observed. This is caused by significant Zn/Cu/Al composition gradients developing along their principal growth directions in both AA7050 and AA7085 alloys. This concentration gradient did not reduce significantly after a T76 treatment. Simulations of Q-GBP growth with different cooling rates using a CALPHAD-informed phase-field model, with the η-phase represented by a two-sublattice model, gave results consistent with experimental observations. Chemical gradients were predicted to develop in the Q-GBPs due to the changing local equilibrium at the growth front during the cooling. The influence of this non-homogeneous microchemistry on the SCC behaviour of 7xxx alloys is briefly discussed.