Variant selection of primary, secondary and tertiary twins in a deformed Mg alloy

Abstract Samples of magnesium alloy AZ31 were deformed in plane strain compression in a channel die at 100 °C and a strain rate of 5 × 10−3 s−1. The initial texture was favorably oriented for extension twinning. At a true strain of e = −0.11, many primary extension twins were observed to consume their parent grains completely. Furthermore, numerous secondary contraction twins formed within the primary extension twins and some tertiary extension twins grew within the secondary contraction twins. The orientations of the parent grains and all three generations of twins were measured. The twin variants selected during each of the three stages of twinning were determined by electron backscatter diffraction techniques and the absent potential twin variants were also identified. The way in which the selected primary extension twins grow so as to consume the parent grains and contact all the neighboring grains is explained in terms of the accommodation strains imposed on the neighboring grains. The analysis shows that the primary twin selected is not necessarily the variant with the highest Schmid factor but the one that requires the least accommodation work in most of the neighboring grains. The same principle was found to hold for the secondary and tertiary twins. By contrast, potential high Schmid factor twins that required the consumption of appreciable accommodation energy did not form. A Taylor simulation produced similar results and indicates that the accommodation strain concept is consistent with the principle of the minimization of plastic work.