The effect of mixing methods and polymer infiltration and pyrolysis (PIP) cycles on the densification of silicon carbide inert matrix fuel through a polymer precursor route

Abstract The effect of mixing methods on the fabrication of silicon carbide (SiC) inert matrix fuel through a polymer precursor route was investigated in order to break up the agglomerates of the SiC particles observed in earlier studies. It was found that a high energy shaker mill could effectively break up the agglomerates and thereby achieve a higher pellet density. Moreover, it was found that the pellet density depended less on the pressing pressure, when the particles are well mixed. SEM images showed cracks caused by the springback effect on pellets with a high cold pressing pressure of 600 MPa, but no signs of springback effect were observed for the 200 MPa pressed pellets. The polymer infiltration and pyrolysis (PIP) cycles were used to further increase the pellet density and close the open pores. The first PIP cycle was found to increase the theoretical density of the pellets from 81.2% to 86.0% and close ∼50% of the open pores. The pore size distribution showed that most of the remaining open pores had diameters smaller than 10 nm. The successive second PIP cycle is not as effective on either the density or the pore size distribution because the small pores present before the second PIP cycle made the infiltration process difficult.