journal article·2017-06Open access

The evolution of the deformation substructure in a Ni-Co-Cr equiatomic solid solution alloy

J. Miao, C.E. Slone, T.M. Smith, C. Niu, H. Bei, M. Ghazisaeidi, G.M. Pharr, M.J. Mills

Acta Materialia· Volume 132

Abstract

Abstract The equiatomic NiCoCr alloy exhibits an excellent combination of strength and ductility, even greater than the FeNiCrCoMn high entropy alloy, and also displays a simultaneous increase in strength and ductility with decreasing the testing temperature. To systemically investigate the origin of the exceptional properties of NiCoCr alloy, which are related to the evolution of the deformation substructure with strain, interrupted tensile testing was conducted on the equiatomic NiCoCr single-phase solid solution alloy at both cryogenic and room temperatures at five different plastic strain levels of 1.5%, 6.5%, 29%, 50% and 70%. The evolution of deformation substructure was examined using electron backscatter diffraction (EBSD), transmission Kikuchi diffraction (TKD), conventional transmission electron microscopy (CTEM), diffraction contrast imaging using STEM (DCI-STEM) and atomic resolution scanning transmission electron microscopy. While the deformation substructure mainly consisted of planar dislocation slip and the dissociation of dislocations into stacking faults at small strain levels (≤6.5%), at larger strain levels, additional substructures including nanotwins and a new phase with hexagonal close packed (HCP) lamellae also appeared. The volume fraction of the HCP lamellae increases with increasing deformation, especially at cryogenic temperature. First principles calculations at 0 K indicate that the HCP phase is indeed energetically favorable relative to FCC for this composition. The effects of the nanotwin and HCP lamellar structures on hardening rate and ductility at both cryogenic and room temperature are qualitatively discussed.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: High Entropy Alloys Studies · High-Temperature Coating Behaviors · Advanced materials and composites

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (40)

Show source-provided references
1. Nanostructured high-entropy alloys with multiple principal elements: novel alloy design concepts and outcomes10.1002/adem.200300567 ↗
2. Microstructural development in equiatomic multicomponent alloys10.1016/j.msea.2003.10.257 ↗
3. Investigation of phases in Al23Co15Cr23Cu8Fe15Ni16 and Al8Co17Cr17Cu8Fe17Ni33 high entropy alloys and comparison with equilibrium phases predicted by Thermo-Calc10.1016/j.jallcom.2012.11.074 ↗
4. Atomic-scale compositional characterization of a nanocrystalline AlCrCuFeNiZn high-entropy alloy using atom probe tomography10.1016/j.actamat.2013.04.059 ↗
5. Phase stability of low-density, multiprincipal component alloys containing aluminum, magnesium, and lithium10.1007/s11837-014-1059-z ↗
6. Decomposition of the single-phase high-entropy alloy CrMnFeCoNi after prolonged anneals at intermediate temperatures10.1016/j.actamat.2016.04.005 ↗
7. Solid solutioning in equiatomic alloys: limit set by topological instability10.1016/j.jallcom.2013.08.213 ↗
8. Phase selection in high-entropy alloys: from nonequilibrium to equilibrium10.1007/s11837-014-0953-8 ↗
9. Tensile properties of high- and medium-entropy alloys10.1016/j.intermet.2013.03.018 ↗
10. The influences of temperature and microstructure on the tensile properties of a CoCrFeMnNi high-entropy alloy10.1016/j.actamat.2013.06.018 ↗
11. Temperature dependence of the mechanical properties of equiatomic solid solution alloys with face-centered cubic crystal structures10.1016/j.actamat.2014.08.026 ↗
12. A fracture-resistant high-entropy alloy for cryogenic applications10.1126/science.1254581 ↗
13. Microstructure evolution and critical stress for twinning in the CrMnFeCoNi high-entropy alloy10.1016/j.actamat.2016.07.038 ↗
14. Exceptional damage-tolerance of a medium-entropy alloy CrCoNi at cryogenic temperatures10.1038/ncomms10602 ↗
15. Nanoscale origins of the damage tolerance of the high-entropy alloy CrMnFeCoNi10.1038/ncomms10143 ↗
16. Correlations between the calculated stacking fault energy and the plasticity mechanisms in Fe-Mn-C alloys10.1016/j.msea.2004.01.059 ↗
17. Mechanical properties and stacking fault energies of NiFeCrCoMn high-entropy alloy10.1007/s11837-013-0771-4 ↗
18. Atomic-scale characterization and modeling of 60 dislocations in a high -entropy alloy10.1016/j.actamat.2016.03.045 ↗
19. Design of a twinning-induced plasticity high entropy alloy10.1016/j.actamat.2015.04.014 ↗
20. Temperature dependent stacking fault energy of FeCrCoNiMn high entropy alloy10.1016/j.scriptamat.2015.05.041 ↗
21. From high-entropy alloys to high-entropy steels10.1002/srin.201500133 ↗
22. Metastable high-entropy dual-phase alloys overcome the strength-ductility trade-off10.1038/nature17981 ↗
23. Reason for the superior mechanical properties of medium-entropy CrCoNi compared to high entropy CrMnFeCoNi alloy10.1016/j.actamat.2017.02.036 ↗
24. Recovery, recrystallization, grain growth and phase stability of a family of FCC-structured multi-component equiatomic solid solution alloys10.1016/j.intermet.2013.10.024 ↗
25. Systematic row and zone axis STEM defect image simulations10.1080/14786435.2010.547526 ↗
26. Atomic-resolution defect contrast in low angle annular dark-field STEM’10.1016/j.ultramic.2012.03.013 ↗
27. Correcting nonlinear drift distortion of scanning probe and scanning transmission electron microscopies from image pairs with orthogonal scan directions10.1016/j.ultramic.2015.12.002 ↗
28. Dislocation nodes in face-centered cubic lattices10.1088/0370-1301/66/6/304 ↗
29. High resolution electron microscopy of dislocation ribbons in a CMSX-4 superalloy single crystal10.1016/j.actamat.2012.05.014 ↗
30. Efficient iterative schemes for ab initio total-energy calculations using a plane-wave basis set10.1103/PhysRevB.54.11169 ↗
31. From ultrasoft pseudopotentials to the projector augmented-wave method10.1103/PhysRevB.59.1758 ↗
32. Generalized gradient approximation made simple10.1103/PhysRevLett.77.3865 ↗
33. Special quasirandom structures10.1103/PhysRevLett.65.353 ↗
34. Efficient stochastic generation of special quasi random structures10.1016/j.calphad.2013.06.006 ↗
35. The nanostructured origin of deformation twinning10.1021/nl203937t ↗
36. Deformation behavior of HCP Ti-Al alloy single crystals10.1007/s11661-002-0153-y ↗
37. Correlation between stacking fault energy and deformation microstructure in high-interstitial-alloyedaustenitic steels10.1016/j.actamat.2010.01.056 ↗
38. The influence of stacking fault energy on the microstructural and strain-hardening evolution of Fe–Mn–Al–Si steels during tensile deformation10.1016/j.actamat.2015.08.030 ↗
39. Stacking faults and FCC -> HCP transformations in 18/8-type stainless steel10.1016/0001-6160(72)90104-6 ↗
40. Deformation induced FCC to HCP transformation in a Co-27Cr-5Mo-0.05C alloy10.1016/j.msea.2010.12.024 ↗