Application of mercury porosimetry to the study of xerogels used as stone consolidants

Abstract Alkoxysilanes, low-viscosity monomers that polymerize into the porous network of stone by a sol–gel process, are widely used in the restoration of stone buildings. We have used the mercury porosimetry technique to characterize changes in microstructure of three granites following their consolidation with two popular commercial products (Wacker OH and Tegovakon V). The suitability of this technique is questioned because a surprising increase of stone porosity is observed. In order to investigate the feasibility of porosimetry, we analyze the behavior of xerogels prepared from the two commercial products, under mercury pressure. Gels are basically compacted and not intruded by mercury. Thus, the increase of stone porosity after consolidation can actually be associated with gel shrinkage. Mercury porosimetry, therefore, has been found unsuitable for characterizing the microstructure of consolidated rocks. However, it can be employed usefully to evaluate shrinkage of gels under mercury pressure, which permits the behavior of a consolidant during the process of drying in stone to be predicted. It is a key factor because many problems of consolidants are related to their drying process within the stone. Gels under study exhibit a high rigidity and an elastic behavior, as consequence of their microporous structure. Finally, the reduction in the porous volume of gels after the porosimetry test demonstrates that the shrinkage mechanism is based on pore collapse.