Study on the influence of coil configuration on electromagnetic characteristics of inductively coupled plasma superimposed frequency selective surface
Source abstract
Abstract
Abstract Aiming at the limitation of frequency selective surface (FSS) used in radome, a new type of active frequency selective surface (AFSS) based on inductively coupled plasma (ICP) is proposed. The structure consists of a square plasma discharge cavity with a size of 20 × 20 × 5 cm3 and a FSS with broadband bandpass response. By comparing the simulation results of COMSOL Multiphysics with the experimental results of microwave interference diagnosis, the influence of coil configuration on the characteristic parameters of ICP source is analyzed. The transmissivity of ICP-FSS with different coil configurations was measured by time domain measurement system. The experimental results show that the bandwidth of passband of the structure is 6.4 GHz–19.1 GHz when the ICP source is not excited. When the ICP source is excited, the ICP-FSS structure presents different stopband transmission characteristics under different coil configurations. The bandwidth of stopband widens as the RF power increases, and the transmission coefficient valley also increases, which can effectively reduce the detection probability of the radar in the off state. Therefore, the proposed AFSS based on inductively coupled plasma is an effective candidate for radome application.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Advanced Antenna and Metasurface Technologies · Antenna Design and Analysis · RFID technology advancements
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (32)
Show source-provided references
1. Analysis on the stealth characteristics of two dimensional cylinder plasma envelopes10.2528/PIERL09100903 ↗
2. A three-layered adjustable frequency-selective surface for wireless applications[J]10.1109/TAP.2019.2934894 ↗
3. Simpkin · 1994
4. Frequency selective surfaces
5. Design of frequency selective surface structure with high angular stability for radome application10.1109/LAWP.2017.2778078 ↗
6. Active frequency-selective surfaces based on loaded ring slot resonators[J]10.1049/el:20057774 ↗
7. Novel multifunctional reconfigurable active frequency selective surface[J]10.1109/TAP.2018.2889002 ↗
8. “Frequency selective surfaces on biased ferrite substrates,”10.1049/el:19940823 ↗
9. A reconfigurable FSS using a spring resonator element[J]10.1109/LAWP.2013.2270950 ↗
10. “Fluidically tunable frequency selective/phase shifting surfaces for high-power microwave applications,”10.1109/TAP.2012.2194645 ↗
11. “Frequency-switchable metamaterial absorber injecting eutectic gallium-indium (EGaIn) liquid metal alloy,”10.3390/s151128154 ↗
12. “A multifunctional reconfigurable frequency-selective surface using liquid-metal alloy,”10.1109/TAP.2018.2851455 ↗
13. Adaptive radar absorbing structure with PIN diode controlled active frequency selective surface[J]10.1088/0964-1726/13/1/013 ↗
14. Active frequency selective surfaces using incorporated PIN diodes[J]10.1093/ietele/e91-c.12.1917 ↗
15. An angular-stable multi-layer reconfigurable frequency selective surface based on varactor with wide tuning range[J]10.1002/mmce.22049 ↗
16. "Broadband microwave absorption and standing wave effect in helium capacitively coupled plasma."10.1063/1.4997614 ↗
17. Numerical and experimental investigation on the attenuation of electromagnetic waves in unmagnetized plasmas using inductively coupled plasma actuator[J]
18. Tunability study of plasma frequency selective surface based on FDTD[J]10.1109/TPS.2019.2894414 ↗
19. Plasma frequency selective surfaces10.1109/TPS.2007.892676 ↗
20. Development of large-area switchable plasma device for X-band Applications[J]10.1109/TPS.2013.2251369 ↗
21. Electromagnetic wave attenuation measurements in a ring-shaped inductively coupled air plasma[J]10.1063/1.4921533 ↗
22. Comparison study of electromagnetic wave propagation in high and low pressure Ar inductively coupled plasma[J]
23. Modeling and experimental study of molecular nitrogen dissociation in an Ar–N2 ICP discharge
24. Electron dynamics and frequency coupling in a radio-frequency capacitively biased planar coil inductively coupled plasma system[J]
25. Measurements of the electron energy distribution function in molecular gases in an inductively coupled plasma[J]10.1063/1.373036 ↗
26. Effect of antenna configuration on power transfer efficiency for planar inductively coupled plasmas[J]10.7498/aps.55.5311 ↗
27. Polarization-independent single-layer ultra-wideband frequency-selective surface[J]10.1017/S1759078715001439 ↗
28. Optical diagnostics for characterization of electron energy distributions: argon inductively coupled plasmas
29. Fast and reliable simulations of argon inductively coupled plasma using COMSOL10.1016/j.vacuum.2015.03.002 ↗
30. Investigation on the parameter distribution of Ar/O2 inductively coupled plasmas10.1016/j.vacuum.2019.108821 ↗
31. Microwave interference diagnosis of plasma based on fluid dynamics modeling[J]10.1088/1742-6596/1053/1/012065 ↗
32. Influence of discharge parameters on electromagnetic scattering