journal article·2017-11

A new dropper-type gas flow measuring method based on weighing principle

Shiwei Zhang, Kun Sun, Feng Han, Fan Zhao

Vacuum· Volume 145
Publisher page

Abstract

Abstract The dropper-type gas flow measuring apparatus is widely used in the vacuum pumping speed measurement. An innovative method based on the weighing principle was proposed in the paper. The structure and working principle of the dropper-type gas flow measuring apparatus is introduced. An electronic scale was placed under the storage tank to measure the oil mass into dropper. The corresponding formulas of gas flow are deduced and the error analysis of measuring accuracy is carried out. Comparing to the disadvantages of the original measuring method, the characteristics of new method was analyzed. A miniature measuring apparatus was set up in the laboratory, and the pumping speed curve of a K-200 diffusion pump was measured by experiment. The feasibility and convenience of the measuring apparatus were verified. This improvement can provide theoretical support and reference method for achieving automatic measurement of vacuum pumping speed and minimal gas flow.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Flow Measurement and Analysis · Advanced Sensor Technologies Research · Electrical and Bioimpedance Tomography

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (12)

Show source-provided references
1. The performance determination of steam flow vacuum pumps - Part 1: Determination of Pumping Rate (Volumetric Flow Rate), Machinery Industry Standards, China, JB/T8472.1–1996: 3-4.
2. Da · 1991
3. Leak rate calibration with gas flow standard apparatus
4. Measurement of small gas flow rate by the conductance modulation method10.1016/S0042-207X(97)00061-4 ↗
5. A new correlation for wet gas flow rate measurement with Venturi meter based on two-phase massflow coefficient10.1016/j.measurement.2014.08.014 ↗
6. Gas flow measurement by means of orifices and Venturi tubes10.1016/S0042-207X(98)00352-2 ↗
7. Gas flow measurement by the thin orifice and the classical Venturi tube10.1016/j.vacuum.2004.05.014 ↗
8. The IMGC-CNR flowmeter for automatic measurements of low-range gas flows10.1016/S0263-2241(03)00029-0 ↗
9. Intercomparison of gas flow-rate measurements at IMGC, Italy, and UASG, Germany, in the range from 10−8 to 10−3 Pa m3/s10.1016/j.vacuum.2005.09.005 ↗
10. A precision gas flowmeter for vacuum metrology10.1016/0042-207X(93)90362-E ↗
11. Disk spin-down measurements in the free-molecular flow regime: A new method for measurement of tangential momentum accommodation coefficients10.1016/j.vacuum.2016.01.012 ↗
12. High vacuum measurements and calibrations, molecular flow fluid transient effects10.1016/j.vacuum.2015.04.030 ↗