Dynamic pressure monitoring in the front-end vacuum systems at the TPS facility
Source abstract
Abstract
Abstract The Taiwan Photon Source Front End (TPS FE) vacuum systems are located between the storage ring and beam lines and include various high-heat-load (HHL) components. We investigate the change in dynamic pressure over time in the FE vacuum system, including measurements of HHL component temperatures, residual gas analyzer (RGA) data analysis, and the effect of changing the insertion device (ID) gap during beam current operation. Our results reveal that the exponential slopes of dynamic pressures in the FE versus accumulated beam dose is nearly −0.5 for all cases. With beam current at 400 mA and ID gap close to 7 mm, the dynamic pressure and HHL component temperature are 1.5 × 10−8 Pa and 45 °C, respectively. The RGA data show that the main dynamic pressure contributions are H2, H2O, CO and CO2. H2O, CO and CO2 come from the chamber surface, while H2 comes from the vacuum chamber materials. The dynamic pressure was ∼2.3 × 10−11 Pa/mA at 1000 Ah, and it continues to decrease with an increase in accumulated beam dose. These results indicate that the total dynamic pressure reaches to a value of 10−7 Pa at full operation current in the FE systems.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Particle Accelerators and Free-Electron Lasers · Particle Detector Development and Performance · Photocathodes and Microchannel Plates
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (9)
Show source-provided references
1. TPS front end design in NSRRC
2. High heat load components in TPS front ends
3. Kuan · 2017
4. Design of the front end for the very long in-vacuum X-ray undulator at SPring-810.1016/S0168-9002(01)00488-0 ↗
5. Thermal analysis of the first canted-undulator front-end components at SSRF10.1016/j.nima.2014.11.082 ↗
6. Investigations of medium-temperature heat treatments to achieve low outgassing rates in stainless steel ultrahigh vacuum chambers J10.1116/1.4983211 ↗
7. Replacement of the TPS bending chamber with an on-site cutting method10.1016/j.vacuum.2017.06.019 ↗
8. Conditioning of the vacuum system of the TPS storage ring without baking in situ10.1016/j.nima.2017.01.027 ↗
9. Insertion devices control plans for the Taiwan photon source