Dynamic extension – A new principle for a vacuum primary standard for UHV-range (10−6–10−10 Pa) calibration of hot cathode ionisation gauges
Source abstract
Abstract
Abstract The main obstacle in the construction of primary vacuum standards for very low pressures – ultra-high vacuum (UHV) – is outgassing from the walls of the apparatus. Thus, principles utilising a higher pumping rate in the calibration chamber, e.g., the pressure ratio technique, seem to be more useful for this range. However, a serious problem is inherent in this method, namely, that the gas in the calibration chamber is not in equilibrium and thus cannot be characterised by a single scalar pressure value, although such a value is then used to evaluate the measurement. This discrepancy can be overcome by using a hot cathode ionisation gauge as a transfer standard calibrated by the dynamic extension method. The dynamic extension method is explained and compared with the pressure ratio technique. The basic conditions for achieving acceptable uncertainty values are considered.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Scientific Measurement and Uncertainty Evaluation · Advanced Electrical Measurement Techniques · Advanced Sensor Technologies Research
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (8)
Show source-provided references
1. Attaining an ultralow outgassing rate of 10−12 Pa m3 s−1 m−2 from an oxygen-free high conductivity copper chamber with beryllium–copper–alloy flanges10.1116/1.579455 ↗
2. Low outgassing residual gas analyzer with a beryllium–copper-alloy-flanged ion source10.1116/1.579387 ↗
3. Mechanism of ultralow outgassing rates in pure copper and chromium–copper alloy vacuum chambers: reexamination by the pressure-rise method10.1116/1.1339009 ↗
4. Extremely low-outgassing material: 0.2% beryllium copper alloy10.1116/1.1635390 ↗
5. Gosselin Ch M, Beitel G A, Development of UHV measurement, Report No NASA CR-1600, May 1970.
6. Primary vacuum standard for UHV range - Standing experience and present problems
7. Comparison of the standards for HV and UHV at three national standard laboratories10.1116/1.580754 ↗
8. Uncertainty analysis of the high vacuum part of the orifice-flow-type pressure standard10.1016/j.vacuum.2004.05.009 ↗