journal article·2019-03

Investigation into the influence of surface conditions on the tube conductance for the molecular flow regime

Tim Verbovšek, Barbara Šetina Batič, Janez Šetina

Vacuum· Volume 161
Publisher page

Abstract

Abstract The flow of different gases in a long, circular tube was investigated with a focus on the influence of the surface condition on the conductance in the molecular regime. The measurements of conductance were made with an uncertainty below 0.5%. A stainless-steel tube with a uniform diameter and roundness was used. The precisely known geometry of the tube allows an accurate calculation of the conductance in the molecular regime under the assumption of a perfectly diffuse scattering of molecules on the surface. Any deviation from diffuse scattering on the surface influences the molecular conductance of the tube. A comparison of the measured and calculated conductance in the molecular regime allows an estimation of the effective tangential momentum accommodation coefficient (ETMAC) of the tube's surface. The tube was first measured in the as-received condition (electropolished surface), and after that exposed to different treatments that altered the surface condition and influenced the ETMAC. In addition, the same tube was chemically etched to increase the surface roughness. Both surface types were treated by heating in vacuum, oxygen and hydrogen. A large variation in the conductance of 10%–20% was observed after etching, depending on the gas (He, CH4, Ne, N2, Ar, Kr).
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Gas Dynamics and Kinetic Theory · Microfluidic and Capillary Electrophoresis Applications · Nanopore and Nanochannel Transport Studies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (21)

Show source-provided references
1. Chapter 4, gas flow
2. Free molecule transmission probabilities10.1063/1.1702984 ↗
3. Rarefied gas flow through a long tube at any pressure ratio10.1116/1.578969 ↗
4. Simulation of gas flow through tubes of finite length over the whole range of rarefaction for various pressure drop ratios10.1116/1.3248273 ↗
5. Comparison between Monte Carlo and analytical calculation of the conductance of cylindrical and conical tubes10.1116/1.1568746 ↗
6. Maxwell · 1890
7. Accommodation coefficient of tangential momentum on atomically clean and contaminated surfaces10.1116/1.1388622 ↗
8. Die äußere reibung der Gase10.1002/andp.19133460706 ↗
9. Internal rarefied gas flows with backscattering10.1063/1.1693983 ↗
10. Effect of ``Rougher‐than‐Rough’’ surfaces on molecular flow through short ducts10.1063/1.1713407 ↗
11. Rarefied gas flow between two flat plates with two dimensional surface roughness10.1016/0042-207X(96)00068-1 ↗
12. Experimental investigation of rarefied gas flow in different channels10.1017/S0022112074002485 ↗
13. Tangential momentum transfer in spinning rotor molecular gauges
14. Spinning rotor vacuum gauges10.1016/0042-207X(82)94048-9 ↗
15. The molecular drag gauge as a calibration standard10.1116/1.576150 ↗
16. Precision calibration of a static pressure divider by means of a spinning rotor gauge10.1116/1.574865 ↗
17. Measuring volume ratios of vacuum vessels using non-evaporable getters10.1016/j.vacuum.2012.11.010 ↗
18. Effect of surface material and roughness on conductance of channel between parallel disks at molecular flow10.1116/1.3306024 ↗
19. Molecular drag on freely rotating balls and vanes
20. The effect of housing tubes on the zero stability of spinning rotor gauges10.1016/0042-207X(90)94194-U ↗
21. The effect of surface roughness on internal free molecular gas flow