Sticking probabilities of Cu, Zn, Sn, and S atoms in magnetron sputtering plasmas employing a Cu2ZnSnS4 stoichiometric target
Source abstract
Abstract
Abstract Investigations on the density decays in the afterglow of pulsed magnetron sputtering plasmas employing a Cu 2 ZnSnS 4 (CZTS) stoichiometric target were performed to evaluate the sticking probabilities of Cu, Zn, Sn and S atoms. The sticking probabilities were evaluated from the linear relationships between the decay time constants of the atom densities and the discharge pressure. It has been found that the sticking probabilities of Cu, Zn, and Sn are almost the same. On the other hand, the sticking probability of S atom was found to be as low as 0.7 ± 0.1, if we assume unity for the sticking probabilities of Cu, Zn, and Sn. Therefore, it has been shown that the less-abundant composition of S atoms in sputter-deposited CZTS thin films is attributed to the small sticking probability of S.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Chalcogenide Semiconductor Thin Films · ZnO doping and properties · Metal and Thin Film Mechanics
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (32)
Show source-provided references
1. Development of CZTS-based thin film solar cells10.1016/j.tsf.2008.11.002 ↗
2. Temperature dependence of Cu2ZnSnS4 photovoltaic cell properties10.1143/APEX.5.082302 ↗
3. Effects of sulfurization temperature on CZTS thin film solar cell performances10.1016/j.solener.2013.09.020 ↗
4. CZTS based thin film solar cells: a status review
5. Electrical and optical properties of stannite-type quaternary semiconductor thin films10.1143/JJAP.27.2094 ↗
6. Cu2ZnSnS4 thin films prepared by sulfurization of ion beam sputtered precursor and their electrical and optical properties10.1016/S1001-0521(07)60096-5 ↗
7. Device characteristics of CZTSSe thin-film solar cells with 12.6% efficiency10.1002/aenm.201301465 ↗
8. Optimized fabrication of sputter deposited Cu2ZnSnS4 (CZTS) thin films10.1016/j.solener.2013.02.003 ↗
9. Thermally evaporated Cu2ZnSnS4 solar cells10.1063/1.3499284 ↗
10. Influence of H2S concentration on the properties of Cu2ZnSnS4 thin films and solar cells prepared by sol-gel sulfurization10.1016/j.solmat.2011.05.050 ↗
11. Cu2ZnSnS4 thin films annealed in H2S atmosphere for solar cell absorber prepared by pulsed laser deposition10.1143/JJAP.47.602 ↗
12. Characterization of a CZTS thin film solar cell grown by sputtering method10.1016/j.solener.2013.11.035 ↗
13. Heteroepitaxial growth of Cu2ZnSnS4 thin film on sapphire substrate by radio frequency magnetron sputtering10.1063/1.4867093 ↗
14. Chemical insights into the instability of Cu2ZnSnS4 films during annealing10.1021/cm202379s ↗
15. Influence of sticking coefficients on the behavior of sputtered atoms in an argon glow discharge: modeling and comparison with experiment10.1116/1.581359 ↗
16. Analysis of sticking coefficient in BSCCO thin films fabricated by using the ion beam sputtering method
17. Sticking coefficient and growth rate during Al chemical vapor deposition10.1063/1.116982 ↗
18. Measurement of sticking coefficient of gold atoms on MgO(001) with a torsion microbalance10.1016/0040-6090(82)90292-9 ↗
19. Sticking probability of Ti atoms in magnetron sputtering deposition evaluated from the spatial distribution of Ti atom density10.1116/1.2539256 ↗
20. Initial sticking probabilities of Cu vacuum deposited on ordered Al2O3 and MgO10.1016/0039-6028(95)00243-X ↗
21. Sticking probability of sputtered particles and collisions on rotating Ni-P substrates10.1016/S0257-8972(03)00085-9 ↗
22. Particle-in-cell/Monte Carlo collisions treatment of an Ar/O2 magnetron discharge used for the reactive sputter deposition of TiOx films10.1088/1367-2630/11/10/103010 ↗
23. Determination of fluorine atom density in reactive plasmas by vacuum ultraviolet absorption spectroscopy at 95.85 nm10.1063/1.1149543 ↗
24. A simple formula for diffusion calculations involving wall reflection and low density10.1063/1.339662 ↗
25. Spatial distribution of the velocity distribution function of Fe atoms in a magnetron sputtering plasma source10.1063/1.2035311 ↗
26. Velocity distribution function of sputtered Cu atoms obtained by time resolved optical absorption spectroscopy10.1063/1.3284528 ↗
27. Fabry-Perot interferometry for measurements of the velocity of sputtered atoms in a magnetron discharge10.1088/0963-0252/17/4/045013 ↗
28. Measurement of diffusion coefficients for ground-state and metastable copper atoms in rare gases10.1088/0022-3727/26/9/011 ↗
29. Collisional-radiative model for the sputtered copper atoms and ions in a direct current argon glow discharge10.1016/S0584-8547(98)00201-8 ↗
30. Role of sputtered Cu atoms and ions in a direct current glow discharge: combined fluid and Monte Carlo model10.1063/1.361023 ↗
31. Binary gaseous diffusion coefficients of mercury and of zinc in hydrogen, helium, argon, nitrogen, and carbon dioxide10.1021/je00003a003 ↗
32. Proceedings of the 30th Symposium on Plasma Processing