Effect of substrate and selenization temperature on the properties of RF sputtered CZTSe layer
Source abstract
Abstract
Abstract Cu 2 ZnSnSe 4 (CZTSe) thin films were deposited by RF sputtering method at different substrate temperatures, followed by an annealing step in SnSe 2 . It was found that the substrate temperature significantly affected phase structure and surface morphology of the precursor films. The annealed films show better crystallinity than the precursors. Single kesterite CZTSe phase was observed when the annealing temperature was below 505 °C. No photoconductive response was observed for precursor film, whereas the annealed films showed obvious photo-response under illumination. The film annealed at 480 °C shows the best photoconductivity, as a result of low carrier concentration (8.2 × 10 14 cm −3 ) and high mobility (26.4 cm 2 ·v −1 ·s −1 ). The Mo/CZTSe (annealed at 480 °C)/CdS/Au diode shows obvious rectification character. By using optimized CZTSe film, CZTSe solar cell was fabricated, and it showed power conversion efficiency of 0.34% with relatively high open circuit voltage of 350 mV. This work provides a way to modulate the structure and property of CZTSe film deposited by sputtering technique for fabricating solar cells.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Copper-based nanomaterials and applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (26)
Show source-provided references
1. Determination of band gap energy (Eg) of Cu2ZnSnSe4 thin films: on the discrepancies of reported band gap values10.1063/1.3457172 ↗
2. Cu2ZnSnSe4 thin-film solar cells by thermal Co-evaporation with 11.6% efficiency and improved minority carrier diffusion length10.1002/aenm.201401372 ↗
3. Device characteristics of CZTSSe thin-film solar cells with 12.6% efficiency10.1002/aenm.201301465 ↗
4. Cu2ZnSnSe4 solar cells with 10.6% efficiency through innovative absorber engineering with Ge superficial nanolayer10.1002/pip.2797 ↗
5. Co-evaporated Cu2ZnSnSe4 films and devices10.1016/j.solmat.2012.01.008 ↗
6. Cu2ZnSnS4 thin film solar cells from electroplated precursors: novel low-cost perspective10.1016/j.tsf.2008.11.061 ↗
7. Cu2ZnSnS4 thin film solar cells prepared by non-vacuum processing10.1016/j.solmat.2008.12.009 ↗
8. Physical and electrical characterization of high-performance Cu2ZnSnSe4, based thin film solar cells10.1016/j.tsf.2014.10.052 ↗
9. Growth of Cu2ZnSnSe4 film under controllable Se vapor composition and impact of low Cu content on solar cell efficiency10.1021/acsami.6b00081 ↗
10. Single elementary target-sputtered Cu2ZnSnSe4 thin film solar cells10.1016/j.solmat.2014.08.043 ↗
11. Brammertz · 2015 · 1
12. Characterization of defects in 9.7% efficient Cu2ZnSnSe4-CdS-ZnO solar cells
13. Chemical insights into the instability of Cu2ZnSnS4 films during annealing10.1021/cm202379s ↗
14. The consequences of kesteriteequilibria for efficient solar cells10.1021/ja111713g ↗
15. Growth of Cu2ZnSnSe4 by cosputtering and reactive annealing atmosphere10.1016/j.solmat.2014.08.001 ↗
16. Morphological evolution and structural properties of Cu2ZnSn(S,Se)4 thin films deposited from single ceramic target by a one-step sputtering process and selenization without H2Se10.1016/j.jallcom.2015.04.103 ↗
17. Effect of Cu/(Zn+Sn) ratio on the ZnSe position and performance of CZTSe solar cells10.1016/j.jallcom.2016.01.080 ↗
18. Morphological and structural characterization of Cu2ZnSnSe4 thin films grown by selenization of elemental precursor layers10.1016/j.tsf.2008.11.034 ↗
19. Photoluminescence and Raman study of Cu2ZnSn(SexS1−x)4 monograins for photovoltaic applications10.1016/j.tsf.2010.12.099 ↗
20. Cu2ZnSnSe4 thin film solar cells produced via co-evaporation and including a SnSe2 capping layer10.1002/pip.2324 ↗
21. Tailoring the defects and carrier density for beyond 10% efficient CZTSe thin film solar cells10.1016/j.solmat.2016.09.034 ↗
22. Role of precursor solution in controlling the opto-electronic properties of spray pyrolysed Cu2ZnSnS4 thin films10.1016/j.solener.2010.12.005 ↗
23. Comparative study of Cu2ZnSnS4 film growth10.1016/j.solmat.2010.04.060 ↗
24. The current status and future prospects of kesterite solar cells: a brief review10.1002/pip.2741 ↗
25. Classification of lattice defects in the kesterite Cu2ZnSnS4 and Cu2ZnSnSe4 earth-abundant solar cell absorbers10.1002/adma.201203146 ↗
26. Optical and electrical properties of SnSe210.1088/0022-3727/2/11/304 ↗