Coatings made of tungsten carbide and tantalum carbide for machining tools
Source abstract
Abstract
Continuous evolution of cutting parameters has been a constant requirement for the manufacture of machining tools. This has promoted the development of new technologies to reduce the production time as well as cost without affecting the competitiveness. In the present work, high speed tools have been coated with WC and TaC by means of chemical vapour deposition and tested in a high speed milling machine. Damages on the tips of these cutting tools were analysed by scanning electron microscope. These observations show that the coating is heterogeneous and affected by the type and composition of various phases formed. Results indicate that the coating made from WC is more highly resistant to attrition than that made of TaC. Surfaces that have been machined by the coated tools are evaluated by means of the average roughness parameter
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Advanced materials and composites · Metal and Thin Film Mechanics · Material Properties and Applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (11)
Show source-provided references
1. Katz · 1987 · 145
2. A review of the present state of art in hard coatings grown from the vapor phase10.1116/1.574062 ↗
3. Quinto DT, Willd R. Balzers Limited. In: "25th international, conference on metallurgical coatings and thin films", invited talk: San Diego USA; 1998.
4. Compaction, distribution and chemical bonding of tungsten implanted glassy carbon10.1063/1.351919 ↗
5. Adhesion and failure mechanisms of tungsten–carbon containing multilayered and graded coatings subjected to scratch tests10.1016/S0040-6090(98)01499-0 ↗
6. Hardness and morphological characterizartion of tugnsten carbide thin films
7. Investigation of cosputtered W-C thin fihns as diffusion barriers
8. Coleman · Tooling and production · 1984 · 46
9. The influence of the microstructure of three Al–Si alloys on the cutting-force amplitude during fine turning10.1016/j.ijmachtools.2005.07.032 ↗
10. Johne P. Handbuch der aluminiumzerspannung, aluminium–verlag, duesseldorf; 1984.
11. 2004