journal article·2016-06

Influence of different vacuum conditions on the distribution of insoluble inclusions in a multi-crystalline silicon ingot

Shi Qiu, Shiqiang Ren, Liuqing Huang, Tianyu Tang, Ming Fang, Xuetao Luo

Vacuum· Volume 128
Publisher page

Abstract

Abstract The distribution of insoluble inclusions in multi-crystalline ( m -c) silicon was investigated by directional solidification under different vacuum conditions using recycled scraps. We found an abnormal peak (weight ratio of 1.19%) of SiC and Si 3 N 4 with an average size of 100 μm located at the bottom of the silicon ingot obtained under low-vacuum conditions. At the top of the ingot, the impurity phase featured a weight ratio exceeding 10.62% and a size of 20 μm. Results showed that large particles sank to the bottom of the ingots whereas small particles floated upward. Further investigation suggested that the dominant factor influencing inclusion distribution is related to the presence of metallic impurities (e.g., Ca, Al, and Na) and their corresponding microstructure. A mechanism of migration was proposed to reveal that bonding of metallic impurities and insoluble inclusions contribute to the abnormal distribution of impurities. The results provide guidance for controlling the distribution of insoluble inclusions in recycled m -c silicon.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Silicon and Solar Cell Technologies · Advancements in Semiconductor Devices and Circuit Design · Thin-Film Transistor Technologies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (29)

Show source-provided references
1. Quantitative study on long term global solar photovoltaic market10.1016/j.rser.2015.02.041 ↗
2. Acceptable contamination levels in solar grade silicon: From feedstock to solar cell10.1016/j.mseb.2008.05.021 ↗
3. Towards solar grade silicon: Challenges and benefits for low cost photovoltaics10.1016/j.solmat.2010.01.016 ↗
4. Engineering metal-impurity nanodefects for low-cost solar cells10.1038/nmat1457 ↗
5. Multiple Slag Operation on Boron Removal from Metallurgical-Grade Silicon Using Na2O-SiO2Slags10.1021/ie404427c ↗
6. Numerical Simulation of Phosphorus Removal from Silicon by Induction Vacuum Refining10.1007/s11661-011-0621-3 ↗
7. From electronic grade to solar grade silicon: chances and challenges in photovoltaics10.1002/pssa.200521104 ↗
8. Study of SiC and Si3N4 inclusions in industrial multicrystalline silicon ingots grown by directional solidification method10.1016/j.mssp.2010.10.019 ↗
9. Recycling of solar cell silicon scraps through filtration, Part I: Experimental investigation10.1016/j.solmat.2008.06.006 ↗
10. Electronic activity of SiC precipitates in multicrystalline solar silicon10.1002/pssa.200675436 ↗
11. Material-induced shunts in multicrystalline silicon solar cells10.1134/S106378260704015X ↗
12. Hard inclusions and their detrimental effects on the wire sawing process of multicrystalline silicon10.1016/j.solmat.2007.06.001 ↗
13. Mechanisms of transition-metal gettering in silicon10.1063/1.1289273 ↗
14. SiC and Si3N4 inclusions in multicrystalline silicon ingots10.1016/j.mssp.2004.05.001 ↗
15. A TEM study of SiC particles and filaments precipitated in multicrystalline Si for solar cells10.1016/j.solmat.2008.04.016 ↗
16. Influence of an insulation partition on a seeded directional solidification process for quasi-single crystalline silicon ingot for high-efficiency solar cells10.1016/j.solmat.2012.01.024 ↗
17. Origin of SiC impurities in silicon crystals grown from the melt in vacuum10.1149/1.2129197 ↗
18. Distribution and formation of silicon carbide and silicon nitride precipitates in block-cast multicrystalline silicon
19. The influence of buoyant forces and volume fraction of particles on the particle pushing entrapment transition during directional solidification of Al SiC and Al graphite compisites
20. The effect of the diffusion of solute between the particle and the interface on the particle pushing phenomena10.1016/S1359-6454(97)00331-5 ↗
21. The interaction between a particle and an advancing solidification front10.1016/S0022-0248(99)00290-0 ↗
22. A numerical model study of the effect of interface shape on particle pushing10.1016/j.jcrysgro.2012.05.032 ↗
23. Numerical and experimental study of vacuum directional solidification purification process for SoG-Si in metallurgical route10.1016/j.jcrysgro.2013.09.020 ↗
24. A modified vacuum directional solidification system of multicrystalline silicon based on optimizing for heat transfer10.1016/j.jcrysgro.2014.04.025 ↗
25. Removal of aluminum and calcium in multicrystalline silicon by vacuum induction melting and directional solidification10.1016/j.vacuum.2013.06.015 ↗
26. Removal of Cu, Mn and Na in multicrystalline silicon by directional solidification under low vacuum condition10.1016/j.vacuum.2015.02.006 ↗
27. Application of molecular interaction volume model on removing impurity aluminum from metallurgical grade silicon by vacuum volatilization10.1016/j.vacuum.2014.12.021 ↗
28. Vacuum refining of molten silicon
29. Effect of melt convection at various gravity levels and orientations on the forces acting on a large spherical particle in the vicinity of a solidification interface10.1016/S0022-0248(99)00785-X ↗