Development of new pressure regulator with flowrate-amplification using vacuum ejector
Source abstract
Abstract
Abstract The pressure regulator is a critically important element in a pneumatic system. It reduces the pressure of a high-pressure air source to the required level for a given pneumatic load and maintains it at a steady level. However, the pressure reduction between the inlet and outlet of a pressure regulator results in a significant power loss, especially when the pneumatic load requires only a low pressure but a large flowrate. In this paper, a design for a new pressure regulator that is capable of reducing this power loss is proposed. Compared to a traditional regulator, the new regulator design adds a component (a vacuum ejector) to draw in additional gas, resulting in an entrainment ratio. This entrainment ratio can reduce the flowrate through the inlet of a regulator. Thus, the power loss incurred by our new regulator is much smaller than that of a traditional design. This paper describes the design and operating principle of the new regulator in detail and evaluates its performance in terms of suction flow, energy-saving, and pressure-stabilization, etc.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Refrigeration and Air Conditioning Technologies · Hydraulic and Pneumatic Systems · Advanced Sensor Technologies Research
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (21)
Show source-provided references
1. Tao · 2014
2. SMC Co · 2003
3. The low-cost and precise piston gas pressure regulator10.1088/0957-0233/27/3/035901 ↗
4. Modelling of a pressure regulator10.1016/j.ijpvp.2006.10.002 ↗
5. Getting the most out of compressed gases: the role of the gas pressure regulator
6. Top tips for pneumatic efficiency
7. Study on energy system of compressed air poared car
8. Energy optimisation of pneumatic actuator systems in manufacturing10.1016/j.jclepro.2014.03.011 ↗
9. IMPROVING energy efficiency in compressed air systems practical experiences10.2298/TSCI151110022S ↗
10. Research on optimization for pneumatic System's air supply
11. Energy saving in pneumatic servo control utilizing interchamber cross-flow10.1115/1.2718244 ↗
12. A study on energy saving algorithm of electro-pneumatic regulator with modified PWM driven method10.1007/BF02915956 ↗
13. Power assessment of flowing compressed air10.1115/1.2170129 ↗
14. Experimental and numerical investigation of transient phenomena in vacuum ejectors10.1016/j.energy.2016.02.101 ↗
15. Three-dimensional CFD modeling and simulation on the performance of steam ejector heat pump for dryer section of the paper machine10.1016/j.vacuum.2015.09.016 ↗
16. Reducing energy consumption of a steam ejector through experimental optimization of the nozzle geometry10.1016/j.energy.2014.01.055 ↗
17. Study of a diffusion pump ejector10.1016/0042-207X(93)90140-6 ↗
18. A power recovery type pressure reducer in the high pressure pneumatic system
19. Numerical and experimental investigations on supersonic ejectors10.1016/j.ijheatfluidflow.2004.07.003 ↗
20. Comparison of ejector predicted performance by thermodynamic and CFD models10.1016/j.ijrefrig.2016.04.026 ↗
21. Prediction of condensation in steam ejector for a refrigeration system10.1016/j.ijrefrig.2010.09.018 ↗