Properties of SiAlO2N protective coatings on surface acoustic wave devices
Source abstract
Abstract
Abstract The use of a protective wear-resistant amorphous SiAlO 2 N thin film overlayer (amorphous SiO 2 –AlN alloy) on top of surface acoustic wave (SAW) devices is demonstrated on both quartz and langatate substrates. SiAlO 2 N films were deposited by RF magnetron sputtering onto sapphire substrates, quartz SAW devices, and langatate SAW devices. The SiAlO 2 N layer had an amorphous structure, a density of 2.8 ± 0.1 g/cm 3 , a roughness less than 1 nm as measured by X-ray reflectivity, and a dielectric permittivity of 7.5 ± 0.05 as determined from microfabricated SiAlO 2 N capacitors. SiAlO 2 N elastic constants C 11 and C 44 were extracted using a numerical implementation of the matrix method for SAWs traveling in multilayer structures, and were found to be C 11 = 160 ± 30 GPa and C 44 = 55 ± 5 GPa. The operating frequencies of quartz SAW devices covered with SiAlO 2 N coatings were only slightly perturbed, but the temperature coefficient of delay (TCD) near 100 °C increased significantly by 250 ppm/°C. For langatate SAW devices, the SiAlO 2 N coating contributed an additional 8.5 dB to device transmission loss but the TCDs were minimally affected for SiAlO 2 N thicknesses up to 800 nm. This result suggests that langatate SAW devices for which temperature-frequency characteristics are important can be designed without consideration of the multi-layer structure, which greatly simplifies device design and modeling.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Acoustic Wave Resonator Technologies · Ferroelectric and Piezoelectric Materials · Advanced ceramic materials synthesis
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References
Reference metadata was not supplied for this record.